| 1. |
- Agostini, Marco, 1987, et al.
(författare)
-
Designing a Safe Electrolyte Enabling Long‐Life Li/S Batteries
- 2019
-
Ingår i: ChemSusChem. - : Wiley. - 1864-5631 .- 1864-564X. ; 12:18, s. 4176-4184
-
Tidskriftsartikel (refereegranskat)abstract
- Lithium–sulfur (Li/S) batteries suffer from “shuttle” reactions in which soluble polysulfide species continuously migrate to and from the Li metal anode. As a consequence, the loss of active material and reactions at the surface of Li limit the practical applications of Li/S batteries. LiNO3 has been proposed as an electrolyte additive to reduce the shuttle reactions by aiding the formation of a stable solid electrolyte interphase (SEI) at the Li metal, limiting polysulfide shuttling. However, LiNO3 is continuously consumed during cycling, especially at low current rates. Therefore, the Li/S battery cycle life is limited by the LiNO3 concentration in the electrolyte. In this work, an ionic liquid (IL) [N-methyl-(n-butyl)pyrrolidinium bis(trifluoromethylsulfonyl)imide] was used as an additive to enable longer cycle life of Li/S batteries. By tuning the IL concentration, an enhanced stability of the SEI and lower flammability of the solutions were demonstrated, that is, higher safety of the battery. The Li/S cell built with a high sulfur mass loading (4 mg cm−2) and containing the IL-based electrolyte demonstrated a stable capacity of 600 mAh g−1 for more than double the number of cycles of a cell containing LiNO3 additive.
|
|
| 2. |
- Agostini, M., et al.
(författare)
-
Polysulfide-containing Glyme-based Electrolytes for Lithium Sulfur Battery
- 2015
-
Ingår i: Chemistry of Materials. - : American Chemical Society (ACS). - 1520-5002 .- 0897-4756. ; 27:13, s. 4604-4611
-
Tidskriftsartikel (refereegranskat)abstract
- A new comparative investigation of lithium sulfur cells employing a tetraethylene glycol dimethyl ether-lithium trifluoromethanesulfonate (TEGDME-LiCF3SO3) electrolyte charged by various polysulfide species (Li2S2, Li2S4, Li2S6, and Li2S8) is here reported. We carefully detect the effects of lithium polysulfide addition by originally combining X-ray photoelectron spectroscopy (XPS) and electrochemical impedance spectroscopy (EIS). The measurements clearly reveal how the polysulfide addition affects the nature and composition of the solid electrolyte interphase (SEI) in terms of precipitated S-based species determined by XPS. The study demonstrates that the SEI layer formed on the Li anode decreases in impedance and stabilizes by the presence of polysulfide. This, together with a buffer effect strongly mitigating the sulfur-cathode dissolution and the shuttle reaction, significantly improves the stability of the lithium-sulfur cell. The data here reported clearly suggest the polysulfide as an effective additive to enhance the performance of the lithium-sulfur battery (Graph Presented).
|
|
| 3. |
- Aguilera Medina, Luis, 1983, et al.
(författare)
-
A structural study of LiTFSI-tetraglyme mixtures: From diluted solutions to solvated ionic liquids
- 2015
-
Ingår i: Journal of Molecular Liquids. - : Elsevier BV. - 0167-7322. ; 210:Part B, s. 238-242
-
Tidskriftsartikel (refereegranskat)abstract
- We report on the nano-structure of solvated ionic liquids (SILs) formed by dissolving a Li-salt (LiTFSI) in the solvent tetraglyme. Using small angle X-ray scattering (SAXS), supported by Raman spectroscopy and computational modeling we follow how the nano-structure develops as Li-salt is added to the solvent. We find that, as the Li-salt concentration is increased a peak at Q 0.95 Å- 1 grows in intensity, signaling the presence of structural correlations typical of those found in traditional ionic liquids. The intensity of the peak reaches its maximum at the equimolar concentration, where each Li-ion can be solvated by one solvent molecule forming an effective cation complex. Combining the SAXS data with computer modeling we show that this peak can be assigned to charge alternation, also found in traditional ionic liquids. However, we also show that even at the equimolar concentration not all Li-ions are solvated by the solvent molecules, but a small fraction interacts directly with the anion (TFSI).
|
|
| 4. |
- Liu, Qiao, et al.
(författare)
-
Enhanced ionic conductivity and interface stability of hybrid solid-state polymer electrolyte for rechargeable lithium metal batteries
- 2019
-
Ingår i: Energy Storage Materials. - : Elsevier BV. - 2405-8297. ; 23, s. 105-111
-
Tidskriftsartikel (refereegranskat)abstract
- Compared to conventional organic liquid electrolyte, solid-state polymer electrolytes are extensively considered as an alternative candidate for next generation high-energy batteries because of their high safety, non-leakage and electrochemical stability with the metallic lithium (Li) anode. However, solid-state polymer electrolytes generally show low ionic conductivity and high interfacial impedance to electrodes. Here we report a hybrid solid-state electrolyte, presenting an ultra-high ionic conductivity of 3.27 mS cm −1 at room temperature, a wide electrochemical stability window of 4.9 V, and non-flammability. This electrolyte consists of a polymer blend matrix (polyethylene oxide and poly (vinylidene fluoride-co-hexafluoropropylene)), Li + conductive ceramic filler (Li 1.5 Al 0.5 Ge 1.5 (PO 4 ) 3 ) and a solvate ionic liquid (LiFSI in tetra ethylene glycol dimethyl ether, 1:1 in molar ratio) as plasticizer. The introduction of the solvate ionic liquid to the solid-state electrolyte not only improves its ionic conductivity but also remarkably enhances the stability of the interface with Li anode. When applied in Li metal batteries, a Li|Li symmetric cell can operate stably over 800 h with a minimal polarization of 25 mV and a full Li|LiFePO 4 cell delivers a high specific capacity of 158 mAh g −1 after 100 cycles at room temperature.
|
|
| 5. |
- Nitze, Florian, 1981, et al.
(författare)
-
Sulfur-doped ordered mesoporous carbons: A stability-improving sulfur host for lithium-sulfur battery cathodes
- 2016
-
Ingår i: Journal of Power Sources. - : Elsevier BV. - 0378-7753. ; 317, s. 112-119
-
Tidskriftsartikel (refereegranskat)abstract
- We report on sulfur-functionalized ordered mesoporous carbons aimed for lithium-sulfur battery electrode applications with improved charge capacity retention. The carbons were obtained by a hard-template strategy using a mixture of furfuryl alcohol and furfuryl mercaptan. For the application as electrode material in lithium-sulfur batteries, the carbons were additionally loaded with sulfur following a traditional melt-diffusion approach. It was found that the sulfur interacts stronger with the sulfur-functionalized carbon matrix than with the non-functionalized material. Electrodes showed very high capacity in the second discharge-charge cycle amounting to approximately 1500, 1200 and 1400 mAh/g (sulfur) for carbon materials with no, medium and high degrees of sulfur functionalization, respectively. More importantly, the sulfur-functionalization of the carbon was found to increase the capacity retention after 50 discharge-charge cycles by 8 and 5% for the carbons with medium and high degrees of sulfur-functionalization, respectively, compared to carbon with no sulfur-functionalization. We attribute this significant improvement to the presence of covalently bound sulfur groups at the internal surface of the functionalized carbon providing efficient anchoring sites for catenation to the sulfur loaded into the pores of the carbons and provide experimental support for this in the form of results from cyclic voltammetry and X-ray photoelectron spectroscopy.
|
|
| 6. |
- Xiong, Shizhao, 1985, et al.
(författare)
-
Role of organic solvent addition to ionic liquid electrolytes for lithium–sulphur batteries
- 2015
-
Ingår i: RSC Advances. - : Royal Society of Chemistry (RSC). - 2046-2069.
-
Tidskriftsartikel (refereegranskat)abstract
- We investigate the role of the addition of an organic solvent to an ionic liquid electrolyte for the performance of lithium–sulphur (Li–S) batteries. We find that with a mixed electrolyte, formed by adding 10 wt% 1,3-dioxolane (DIOX) to an ionic liquid, the capacity of a Li–S cell is more than doubled, the rate capability and the cycling performance considerably improved, compared to a cell utilizing a neat ionic liquid electrolyte. The improved performance can be correlated with an enhanced ion transport, evidenced by an increased ionic conductivity and higher limiting current density, directly related to a decrease in viscosity and glass transition temperature of the mixed electrolytes. We show that this in turn is linked to a change in the local environment of the Li-ions where the organic solvent is incorporated in the coordination shell. In addition we show that the mixed electrolytes have a considerably higher thermal stability, in particular a dramatically increased flash point, and improved low temperature properties with respect to a conventional organic solvent based electrolyte currently used for Li–S batteries.
|
|
