| 1. |
- Elmroth Nordlander, Jonas, et al.
(författare)
-
Mo3Ni2N Nanoparticle Generation by Spark Discharge
- 2023
-
Ingår i: Materials. - : MDPI AG. - 1996-1944. ; 16:3
-
Tidskriftsartikel (refereegranskat)abstract
- Spark ablation is an advantageous method for the generation of metallic nanoparticles with defined particle sizes and compositions. The reaction of the metal particles with the carrier gas during the synthesis and, therefore, the incorporation of those light elements into structural voids or even compound formation was confirmed for hydrides and oxides but has only been suspected to occur for nitrides. In this study, dispersed nanoparticles of Mo3Ni2N and Mo with Janus morphology, and defined particle sizes were obtained by spark discharge generation as a result of carrier gas ionization and characterized using transmission electron microscopy and powder X-ray diffraction. Metal nitrides possess beneficial catalytic and thermoelectric properties, as well as high hardness and wear resistance. Therefore, this method offers the possibility of controlled synthesis of materials which are interesting for numerous applications.
|
|
| 2. |
- Franzén, Sara, et al.
(författare)
-
Compositional tuning of gas-phase synthesized Pd–Cu nanoparticles
- 2023
-
Ingår i: Nanoscale Advances. - 2516-0230. ; 5:22, s. 6069-6077
-
Tidskriftsartikel (refereegranskat)abstract
- Bimetallic nanoparticles have gained significant attention in catalysis as potential alternatives to expensive catalysts based on noble metals. In this study, we investigate the compositional tuning of Pd–Cu bimetallic nanoparticles using a physical synthesis method called spark ablation. By utilizing pure and alloyed electrodes in different configurations, we demonstrate the ability to tailor the chemical composition of nanoparticles within the range of approximately 80 : 20 at% to 40 : 60 at% (Pd : Cu), measured using X-ray fluorescence (XRF) and transmission electron microscopy energy dispersive X-ray spectroscopy (TEM-EDXS). Time-resolved XRF measurements revealed a shift in composition throughout the ablation process, potentially influenced by material transfer between electrodes. Powder X-ray diffraction confirmed the predominantly fcc phase of the nanoparticles while high-resolution TEM and scanning TEM-EDXS confirmed the mixing of Pd and Cu within individual nanoparticles. X-ray photoelectron and absorption spectroscopy were used to analyze the outermost atomic layers of the nanoparticles, which is highly important for catalytic applications. Such comprehensive analyses offer insights into the formation and structure of bimetallic nanoparticles and pave the way for the development of efficient and affordable catalysts for various applications.
|
|
| 3. |
- Gericke, Sabrina Maria, et al.
(författare)
-
In Situ H2 Reduction of Al2O3-Supported Ni- and Mo-Based Catalysts
- 2022
-
Ingår i: Catalysts. - : MDPI. - 2073-4344. ; 12:7
-
Tidskriftsartikel (refereegranskat)abstract
- Nickel (Ni)-promoted Molybdenum (Mo)-based catalysts are used for hydrotreatment processes in the chemical industry where the catalysts are exposed to high-pressure H2 at elevated temperature. In this environment, the catalyst transforms into the active phase, which involves the reduction of the oxide. Here, we report on the first in situ study on the reduction of alumina supported Ni- and Mo-based catalysts in 1 mbar H2 using ambient-pressure X-ray photoelectron spectroscopy (APXPS). The study confirms that mixing Ni and Mo lowers the reduction temperature of both Ni- and Mo-oxide as compared to the monometallic catalysts and shows that the MoO3 reduction starts at a lower temperature than the reduction of NiO in NiMo/Al2O3 catalysts. Additionally, the reduction of Ni and Mo foil was directly compared to the reduction of the Al2O3-supported catalysts and it was observed that the reduction of the supported catalysts is more gradual than the reduction of the foils, indicating a strong interaction between the Ni/Mo and the alumina support. © 2022 by the authors.
|
|
| 4. |
- Balmes, Olivier, et al.
(författare)
-
Reversible formation of a PdCx phase in Pd nanoparticles upon CO and O-2 exposure
- 2012
-
Ingår i: Physical Chemistry Chemical Physics. - : Royal Society of Chemistry (RSC). - 1463-9084 .- 1463-9076. ; 14:14, s. 4796-4801
-
Tidskriftsartikel (refereegranskat)abstract
- The structure and chemical composition of Pd nanoparticles exposed to pure CO and mixtures of CO and O-2 at elevated temperatures have been studied in situ by a combination of X-ray Diffraction and X-ray Photoelectron Spectroscopy in pressures ranging from ultra high vacuum to 10 mbar and from room temperature to a few hundred degrees celsius. Our investigation shows that under CO exposure, above a certain temperature, carbon dissolves into the Pd particles forming a carbide phase. Upon exposure to CO and O-2 mixtures, the carbide phase forms and disappears reversibly, switching at the stoichiometric ratio for CO oxidation. This finding opens new scenarios for the understanding of catalytic oxidation of C-based molecules.
|
|
| 5. |
|
|
| 6. |
- Blomberg, Sara, et al.
(författare)
-
A high pressure X-ray photoelectron spectroscopy study of oxidation and reduction of Rh(100) and Rh nanoparticles
- 2014
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028. ; 628, s. 153-158
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied the oxidation and reduction of Rh(100) and SiO2 supported Rh particles using high pressure X-ray photoelectron spectroscopy. We show that the formation and reduction of Rh bulk oxide can be followed in situ in O-2 and CO pressures in the range of 0.1 Torr. In general, the oxidation/reduction processes are similar on Rh(100) and the nanoparticles, but there are significant differences in temperature dependence. Already at a sample temperature of 140 degrees C, the particles show clear signs of a thin bulk oxide, while an ultra-thin so-called surface oxide covers the single crystal at the same temperature. Both of these oxide films, however, hinder further oxidation, and a thick oxide is only found at a temperature of at least 300 degrees C, for both samples. The reduction, in contrast, starts at a higher temperature on the particles as compared to the single crystal, but once started the particles are completely reduced at lower temperatures. (C) 2014 Elsevier B.V. All rights reserved.
|
|
| 7. |
- Blomberg, Sara, et al.
(författare)
-
Bimetallic nanoparticles as a model system for an industrial NiMo catalyst
- 2019
-
Ingår i: Materials. - : MDPI AG. - 1996-1944. ; 12:22
-
Tidskriftsartikel (refereegranskat)abstract
- An in-depth understanding of the reactionmechanismis required for the further development of Mo-based catalysts for biobased feedstocks. However, fundamental studies of industrial catalysts are challenging, and simplified systems are often used without direct comparison to their industrial counterparts. Here, we report on size-selected bimetallic NiMo nanoparticles as a candidate for a model catalyst that is directly compared to the industrial system to evaluate their industrial relevance. Both the nanoparticles and industrial supported NiMo catalysts were characterized using surface- and bulk-sensitive techniques. We found that the active Ni and Mo metals in the industrial catalyst are well dispersed and well mixed on the support, and that the interaction between Ni and Mo promotes the reduction of the Mo oxide. We successfully produced 25 nm NiMo alloyed nanoparticles with a narrow size distribution. Characterization of the nanoparticles showed that they have a metallic core with a native oxide shell with a high potential for use as a model system for fundamental studies of hydrotreating catalysts for biobased feedstocks. © 2019 by the authors.
|
|
| 8. |
- Blomberg, Sara, et al.
(författare)
-
Generation and oxidation of aerosol deposited PdAg nanoparticles
- 2013
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028. ; 616, s. 186-191
-
Tidskriftsartikel (refereegranskat)abstract
- PdAg nanoparticles with a diameter of 10 nm have been generated by an aerosol particle method, and supported on a silica substrate. By using a combination of X-ray Energy Dispersive Spectroscopy and X-ray Photoelectron Spectroscopy it is shown that the size distribution of the particles is narrow and that the two metals form an alloy with a mixture of 75% Pd and 25% Ag. Under oxidizing conditions, Pd is found to segregate to the surface and a thin PdO like oxide is formed similar to the surface oxide previously reported on extended PdAg and pure Pd surfaces. (C) 2013 Elsevier B.V. All rights reserved.
|
|
| 9. |
|
|
| 10. |
- Jönsson, Linnéa, et al.
(författare)
-
The effect of electrode composition on bimetallic AgAu nanoparticles produced by spark ablation
- 2024
-
Ingår i: Journal of Aerosol Science. - 0021-8502. ; 177
-
Tidskriftsartikel (refereegranskat)abstract
- A flexible way to generate bimetallic nanoparticles with high control of their composition is to use spark ablation of alloyed electrodes. It has been generally accepted and stated that particles produced using spark ablation of alloyed electrodes obtain the same chemical composition as the electrodes. However, we identify a lack of studies fully supporting the connection between electrode and particle composition, presented in a small literature survey. The aim of the study is, hence, to explore the validity of the statement by analysing the relation between alloyed electrodes and their resulting particle composition using three sets of AgAu electrodes containing Au and 25, 50, and 75 atomic % Ag, respectively. The resulting composition is thoroughly investigated using both single particle (scanning- and transmission electron microscopy) and ensemble particle techniques (inductive coupled plasma-mass spectroscopy, x-ray photoelectron spectroscopy, x-ray fluorescence, and optical measurements of surface plasmon resonance. We also investigate how sample size (e.g., the number of particles analysed) affects the reliability of the resulting sample mean. For single-particle measurements of a sample with a compositional standard deviation of a few atomic percentage points, a sample size of 20 particles is a good benchmark for obtaining reliable results of the sample mean. Furthermore, this article aims to challenge the practice in which the composition of nanoparticles is measured, presented, and interpreted, to improve and facilitate future research related to this topic. From the results of this study, it could be concluded that for the investigated Ag–Au material system, the particles obtained a composition very similar to the alloyed AgAu electrodes.
|
|
