| 1. |
- Bordag, Michael, et al.
(författare)
-
Shear stress measurements on InAs nanowires by AFM manipulation
- 2007
-
Ingår i: Small. - Weinheim : Wiley-VCH Verlagsgesellschaft. - 1613-6810 .- 1613-6829. ; 3:8, s. 1398-1401
-
Tidskriftsartikel (refereegranskat)abstract
- On an upward curve? The curvature of an elastically deformed nanowire pinned to a flat surface contains information about the maximum static friction force, and hence the shear stress, between the nanowire and the surface. Here, InAs nanowires are bent in a controlled manner using the tip of an atomic force microscope (see image). The shear stress can be obtained from a simple analysis according to the standard theory of elasticity.
|
|
| 2. |
- Conache, Gabriela, et al.
(författare)
-
AFM-based manipulation of InAs nanowires
- 2008
-
Ingår i: Proceedings of the IVC-17 (17th International Vacuum Congress) [also] ICSS-13 (13th International Conference on Surface Science) [also] ICN+T-2007 (International Conference on Nanoscience and Technology). - Bristol : Institute of Physics (IOP). ; 100, s. 052051-052051
-
Konferensbidrag (refereegranskat)abstract
- A controlled method of manipulation of nanowires was found using the tip of an Atomic Force Microscope (AFM). Manipulation is done in the ‘Retrace Lift’ mode, where feedback is turned off for the reverse scan and the tip follows a nominal path. The effective manipulation force during the reverse scan can be changed by varying an offset in the height of the tip over the surface. Using this method, we have studied InAs nanowires on different substrates. We have also investigated interactions between wires and with gold features patterned onto the substrates.
|
|
| 3. |
- Conache, Gabriela, et al.
(författare)
-
Bias-controlled friction of InAs nanowires on a silicon nitride layer studied by atomic force microscopy
- 2010
-
Ingår i: Physical Review B Condensed Matter. - College Park, Md. : American Physical Society. - 0163-1829 .- 1095-3795. ; 82:3
-
Tidskriftsartikel (refereegranskat)abstract
- By studying how nanowires lying on a surface bend when pushed by an atomic force microscopy tip we are able to measure the friction between them and the substrate. Here, we show how the friction between InAs nanowires and an insulating silicon nitride layer varies when a dc voltage is applied to the tip during manipulation. The bias charges the capacitor formed by the wire and the grounded silicon back contact. Electrostatic forces increase the contact pressure and allow us to tune the friction between the wire and the silicon nitride surface. Using nanowires of about 40-70 nm diameter and a few microns in length we have applied biases in the range +12 to -12 V. A monotonic increase of the sliding friction with voltage was observed. This increase in friction with the normal force implies that the mesoscopic nanowire-surface system behaves like a macroscopic contact, despite the nanometer size of the contact in the direction of motion. The demonstrated bias-controlled friction has potential applications in MEMS/NEMS devices.
|
|
| 4. |
- Conache, Gabriela, et al.
(författare)
-
Comparative friction measurements of InAs nanowires on three substrates
- 2010
-
Ingår i: Journal of Applied Physics. - College Park, MD : American Institute of Physics (AIP). - 0021-8979 .- 1089-7550. ; 108:9
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated friction between InAs nanowires and three different substrates: SiO2, fluorosilanized SiO2, and Si3N4. The nanowires were pushed laterally with the tip of an atomic force microscope and the friction force per unit length for both static and sliding friction was deduced from the equilibrium shape of the bent wires. On all three substrates, thick wires showed a difference between sliding and static friction of up to three orders of magnitude. Furthermore, all substrates display a transition to stick-slip motion for nanowires with a diameter of less than about 40 nm. Hydrophobic and hydrophilic substrates display similar friction behavior suggesting that a condensed water layer does not strongly influence our results. The patterns and trends in the friction data are similar for all three substrates, which indicates that they are more fundamental in character and not specific to a single substrate. ©2010 American Institute of Physics.
|
|
| 5. |
- Conache, Gabriela, et al.
(författare)
-
Friction measurements of InAs nanowires on Silicon nitride by AFM manipulation
- 2009
-
Ingår i: Small. - Weinheim, Germany : Wiley-VCH Verlagsgesellschaft. - 1613-6810 .- 1613-6829. ; 5:2, s. 203-207
-
Tidskriftsartikel (refereegranskat)abstract
- A study was conducted to perform friction measurements of InAs nanowires (NW) on silicon nitride (Si 3N 4) through atomic force microscopy (AFM) manipulation. The investigations revealed the friction force per unit length for sliding and static friction over a range of nanowire diameters. It was found that there is a significant difference between the coefficients of the two sliding modes for large wires. It was also found that the difference between the two sliding modes disappears at smaller diameters and the sliding friction becomes equal with the static friction. The AFM investigations were performed on a Nanoscope IIIa Dimension 3100, using rectangular cantilevers, with a nominal spring constant of 30 N m -1. The nanowires were manipulated, using the 'Retrace Lift' mode of the AFM controller. The friction force per unit length was gathered from the local curvature of the NWs, using standard elasticity theory.
|
|
| 6. |
- Conache, Gabriela, 1977-, et al.
(författare)
-
Nanowire friction with an applied bias
- 2009
-
Konferensbidrag (refereegranskat)abstract
- Recently, we have shown how the friction acting on nanowires pushed across a surface by an AFM tip can be determined by measuring the radius of curvature of the bent wire aŸer manipulation. This technique allows us to study the friction properties of an extended mesoscale contact. Our main focus has been to determine whether such contacts behave like macroscopic objects, in which dišerences between the 'true' and 'apparent' contact areas play a key role and friction varies linearly with the applied normal force, or whether they are more like atomic-scale point contacts, wheremore fundamental processes dominate and friction oŸen is independent of the normal force. In this work we show how the friction between InAs nanowires and an insulating silicon nitride layer on a conductive silicon substrate varies when a DC voltage is applied to the AFM tip during manipulation. e tip charges the capacitor formed by the wire and the grounded silicon back contact, giving rise to attractive Coulomb forces and thus increasing the contact pressure between the wire and the silicon nitride. In this way we can vary the normal force on the sliding surfaces using a single wire, with a constant structure and contact geometry. Using nanowires of about 40-50 nm diameter and a few microns in length we have applied tip voltages in the range +12 to -12 V. Simplemodeling indicates that these voltages su›ce to give similar levels of band-lling and depletion to when the same wires are used in working wrap-gate or back-gate devices. A monotonic increase of the sliding friction with the voltage applied on the tip was observed. is implies that the friction increases with the normal force and that this mesoscopic system behaves more like a macroscopic contact, despite the nanometer size of the contact in the direction of motion.
|
|
| 7. |
- Pettersson, Håkan, et al.
(författare)
-
Friction measurements on InAs NWs by AFM manipulation
- 2008
-
Konferensbidrag (refereegranskat)abstract
- We discuss a new approach to measure the friction force between elastically deformed nanowires and a surface. The wires are bent, using an AFM, into an equilibrium shape determined by elastic restoring forces within the wire and friction between the wire and the surface. From measurements of the radius of curvature of the bent wires, elasticity theory allows the friction force per unit length to be calculated. We have studied friction properties of InAs nanowires deposited on SiO2, silanized SiO2 and Si3N4 substrates. The wires were typically from 0.5 to a few microns long, with diameters varying between 20 and 80 nm. Manipulation is done in a `Retrace Lift' mode, where feedback is turned off for the reverse scan and the tip follows a nominal path. The effective manipulation force during the reverse scan can be changed by varying an offset in the height of the tip over the surface. We will report on interesting static- and sliding friction experiments with nanowires on the different substrates, including how the friction force per unit length varies with the diameter of the wires.
|
|
| 8. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Nanowire friction with an applied bias
- 2010
-
Ingår i: Bulletin of the American Physical Society. - : American Physical Society.
-
Konferensbidrag (refereegranskat)abstract
- Recently, we have shown how the friction experienced by nanowires pushed by an AFM tip can be determined by measuring their radius of curvature after manipulation [1]. It is of fundamental interest to know whether the wires behave like macroscopic objects, or if they are more like true atomic-scale point contacts where friction becomes independent of the applied normal force. Here we study how the friction between InAs nanowires and a SiN layer on conductive silicon varies when a DC voltage is applied. The tip charges the capacitor formed by the wire and the silicon back contact, causing attractive Coulomb forces and so increasing the contact pressure. A monotonic increase of the sliding friction with voltage was observed. This implies that the friction increases with the normal force and that this mesoscopic system behaves more like a macroscopic contact, despite being only nanometers in size in the direction of motion.
|
|
| 9. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Shear stress measurements on InAs nanowires by AFM manipulation
- 2007
-
Ingår i: Bulletin of the American Physical Society. - New York : American Physical Society. - 0003-0503. ; 52:1
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we report on a novel approach to measure shear stress between elastic nanowires and a SiO2 surface. The method is based on the fact that the curvature of an elastically deformed nanowire pinned to a flat surface contains information about the maximal static friction force, i.e., the shear stress between the wire and the surface. At rest, the deformed wire is kept in equilibrium by counterbalancing static friction forces and restoring elastic forces. In the present work, InAs nanowires are bent in a controlled manner using the tip of an atomic force microscope (AFM). After the manipulation, the curvature of the most bent state can be determined from AFM micrographs. Assuming bulk values for the Young’s modulus, the shear stress can be obtained from straight- forward analyses according to standard theory of elasticity.
|
|
| 10. |
- Skjolding, Lars Henrik, et al.
(författare)
-
Characterisation of nano-interdigitated electrodes
- 2008
-
Ingår i: Journal of Physics: Conference Series. - : IOP Publishing. - 1742-6596 .- 1742-6588. ; 100, s. 052045-052045
-
Konferensbidrag (refereegranskat)abstract
- Interdigitated electrodes made up of two individually addressable interdigitated comb-like electrode structures have frequently been suggested as ultra sensitive electrochemical biosensors. Since the signal enhancement effects due to cycling of the reduced and oxidized species are strongly dependent on the inter electrode distances, since the nature of the enhancement is due to overlying diffusion layers, inter digitated electrodes with an electrode separation of less the non emicrometer a redesired for maximum signal amplification. Fabrication of submicron structures can only be made by advanced lithography techniques. By use of electron be amlithography we have fabricated arrays of interdigitated electrodes with an electrode separation distance of 200nm and an electrode finger width of likewise 200nm. The entire electrode structure is 100 micrometre times 100 micrometre, and the active electrode area is dictated by the opening in the passivation layer, that is defined by UV lithography. Here we report measurements of redox cycling of ferrocyanide by coupled cyclic voltammograms, where the potential atone of the working electrodes are varied and either an oxidising or reducing potential is applied to the complimentary interdigitated electrode. The measurements show fast conversion and high collection efficiency round 87% as expected for nano-interdigitated electrodes.
|
|
