| 1. |
- Abdollahi Sani, Negar, et al.
(författare)
-
All-printed diode operating at 1.6 GHz
- 2014
-
Ingår i: Proceedings of the National Academy of Sciences of the United States of America. - : National Academy of Sciences. - 0027-8424 .- 1091-6490. ; 111:33, s. 11943-11948
-
Tidskriftsartikel (refereegranskat)abstract
- Printed electronics are considered for wireless electronic tags and sensors within the future Internet-of-things (IoT) concept. As a consequence of the low charge carrier mobility of present printable organic and inorganic semiconductors, the operational frequency of printed rectifiers is not high enough to enable direct communication and powering between mobile phones and printed e-tags. Here, we report an all-printed diode operating up to 1.6 GHz. The device, based on two stacked layers of Si and NbSi2 particles, is manufactured on a flexible substrate at low temperature and in ambient atmosphere. The high charge carrier mobility of the Si microparticles allows device operation to occur in the charge injection-limited regime. The asymmetry of the oxide layers in the resulting device stack leads to rectification of tunneling current. Printed diodes were combined with antennas and electrochromic displays to form an all-printed e-tag. The harvested signal from a Global System for Mobile Communications mobile phone was used to update the display. Our findings demonstrate a new communication pathway for printed electronics within IoT applications.
|
|
| 2. |
- Gustafsson, Stefan, et al.
(författare)
-
Electromagnetic dispersion modeling and measurements for HVDC power cables
- 2014
-
Ingår i: IEEE Transactions on Power Delivery. - : IEEE Press. - 0885-8977 .- 1937-4208. ; 29:6, s. 2439-2447
-
Tidskriftsartikel (refereegranskat)abstract
- This paper provides a general framework for electromagnetic (EM) modeling, sensitivity analysis, computation, and measurements regarding the wave propagation characteristics of high-voltage direct-current (HVDC) power cables. The modeling is motivated by the potential use with transient analysis, partial-discharge measurements, fault localization and monitoring, and is focused on very long (10 km or more) HVDC power cables with transients propagating in the low-frequency regime of about 0-100 kHz. An exact dispersion relation is formulated together with a discussion on practical aspects regarding the computation of the propagation constant. Experimental time-domain measurement data from an 80-km-long HVDC power cable are used to validate the electromagnetic model, and a mismatch calibration procedure is devised to account for the connection between the measurement equipment and the cable. Quantitative sensitivity analysis is devised to study the impact of parameter uncertainty on wave propagation characteristics. The sensitivity analysis can be used to study how material choices affect the propagation characteristics, and to indicate which material parameters need to be identified accurately in order to achieve accurate fault localization. The analysis shows that the sensitivity of the propagation constant due to a change in the conductivity in the three metallic layers (the inner conductor, the intermediate lead shield, and the outer steel armor) is comparable to the sensitivity with respect to the permittivity of the insulating layer. Hence, proper modeling of the EM fields inside the metallic layers is crucial in the low-frequency regime of 0-100 kHz.
|
|
| 3. |
- Nilsson, Kent, et al.
(författare)
-
Ascribed functions of the balanced scorecard: a study of politicians, managers and accountants in Swedish local governments
- 2009
-
Ingår i: Performance Measurement Association Conference.
-
Konferensbidrag (refereegranskat)abstract
- This paper takes a novel approach to investigate functions ascribed to the Balanced Scorecard in local governments. First, we develop a measurement scale of balanced scorecard functions based on a literature review. Then, by combining qualitative interviews and quantitative data (based on 101 respondents) from four local governments in Sweden, we examine the measurement scale and put it to use. The results show that politicians, managers and accountants in local government recognize multiple functions, instrumental as well as symbolic. Based on the results, we generate propositions to be tested in future research.
|
|
| 4. |
- McGinn, Steven, et al.
(författare)
-
New Technologies for DNA analysis-A review of the READNA Project.
- 2016
-
Ingår i: New Biotechnology. - : Elsevier BV. - 1876-4347 .- 1871-6784.
-
Forskningsöversikt (refereegranskat)abstract
- The REvolutionary Approaches and Devices for Nucleic Acid analysis (READNA) project received funding from the European Commission for 4 1/2 years. The objectives of the project revolved around technological developments in nucleic acid analysis. The project partners have discovered, created and developed a huge body of insights into nucleic acid analysis, ranging from improvements and implementation of current technologies to the most promising sequencing technologies that constitute a 3(rd) and 4(th) generation of sequencing methods with nanopores and in situ sequencing, respectively.
|
|
| 5. |
- Nordebo, Sven, et al.
(författare)
-
Electromagnetic dispersion modeling and measurements for HVDC power cables
- 2011
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- This paper provides a general framework for electromagnetic modeling, computation and measurements regarding the wave propagation characteristics of High-Voltage Direct Current (HVDC) power cables. The modeling is focused on very long (10 km or more) HVDC power cables and the relevant frequency range is therefore in the low-frequency regime of about 0-100 kHz. An exact dispersion relation is formulated together with a discussion on practical aspects regarding the computation of the propagation constant and the related characteristic impedance. Experimental time-domain measurement data from an 80 km long HVDC power cable is used to validate the model. It is concluded that a single-mode transmission line model is not adequate to account for the mismatch between the power cable and the instrumentation. A mismatch calibration procedure is therefore devised to account for the connection between the measurement equipment and the cable. A dispersion model is thus obtained that is accurate for early times of pulse arrival. To highlight the potential of accurate electromagnetic modeling, an example of high-resolution length-estimation is discussed and analyzed using statistical methods based on the Cramer-Rao lower bound. The analysis reveals that the estimation accuracy based on the present model (and its related model error) is in the order of 100 m for an 80 km long power cable, and that the potential accuracy using a perfect model based on the given measurement data is in the order of centimeters.
|
|
| 6. |
- Nordebo, Sven, et al.
(författare)
-
Low-frequency dispersion characteristics of a multilayered coaxial cable
- 2013
-
Ingår i: Journal of Engineering Mathematics. - : Springer Netherlands. - 0022-0833 .- 1573-2703. ; 83:1, s. 169-184
-
Tidskriftsartikel (refereegranskat)abstract
- This paper provides an exact asymptotic analysis regarding the low-frequency dispersion characteristics of a multilayered coaxial cable. A layer-recursive description of the dispersion function is derived that is well suited for asymptotic analysis. The recursion is based on two well-behaved (meromorphic) subdeterminants defined by a perfectly electrically conducting (PEC) and a perfectly magnetically conducting termination, respectively. For an open waveguide structure, the dispersion function is a combination of two such functions, and there is only one branch point that is related to the exterior domain. It is shown that if there is one isolating layer and a PEC outer shield, then the classical Weierstrass preparation theorem can be used to prove that the low-frequency behavior of the propagation constant is governed by the square root of the complex frequency, and an exact analytical expression for the dominating term of the asymptotic expansion is derived. It is furthermore shown that the same asymptotic expansion is valid to its lowest order even if the outer shield has finite conductivity and there is an infinite exterior region with finite nonzero conductivity. As a practical application of the theory, a high-voltage direct current (HVDC) power cable is analyzed and a numerical solution to the dispersion relation is validated by comparisons with the asymptotic analysis. The comparison reveals that the low-frequency dispersion characteristics of the power cable is very complicated and a first-order asymptotic approximation is valid only at extremely low frequencies (below 1 Hz). It is noted that the only way to come to this conclusion is to actually perform the asymptotic analysis. Hence, for practical modeling purposes, such as with fault localization, an accurate numerical solution to the dispersion relation is necessary and the asymptotic analysis is useful as a validation tool.
|
|
| 7. |
|
|
| 8. |
- Nordebo, Sven, et al.
(författare)
-
Wave modeling and fault localization for underwater power cables
- 2011
-
Ingår i: 2011 IEEE-APS Topical Conference on Antennas and Propagation in Wireless Communications (APWC). - : IEEE Press. - 9781457700460 ; , s. 698-701
-
Konferensbidrag (refereegranskat)abstract
- This paper describes some preliminary results regarding Time-Domain pulse Reflection (TDR) measurements and modeling performed on the Baltic Cable submarine HVDC link between southern Sweden and northern Germany. The measurements were conducted in collaboration between the Linnaeus University, Lund University, Baltic Cable AB and ABB High Voltage Cables AB, and is part of the research project: “Fundamental wave modeling for signal estimation on lossy transmission lines”. Preliminary results on measurements and modeling are included here, as well as a first numerical study regarding the low-frequency dispersion characteristics of power cables. The numerical study shows that the finite conductivity of the cable lead shield has a great impact on the losses at low frequencies (0-1 kHz), and that the low-frequency asymptotics of the propagation constant is consistent with common propagation models based on the skin-effect.
|
|
| 9. |
- Andersson Ersman, Peter, et al.
(författare)
-
Screen printed digital circuits based on vertical organicelectrochemical transistors
- 2017
-
Ingår i: Flexible and Printed Electronics. - : IOP Publishing. - 2058-8585. ; 2
-
Tidskriftsartikel (refereegranskat)abstract
- Vertical organic electrochemical transistors (OECTs) have been manufactured solely using screenprinting. The OECTs are based on PEDOT:PSS (poly(3,4-ethylenedioxythiophene) doped with poly(styrene sulfonic acid)), which defines the active material for both the transistor channel and the gateelectrode. The resulting vertical OECT devices and circuits exhibit low-voltage operation, relativelyfast switching, small footprint and high manufacturing yield; the last three parameters are explainedby the reliance of the transistor configuration on a robust structure in which the electrolyte verticallybridges the bottom channel and the top gate electrode. Two different architectures of the verticalOECT have been manufactured, characterized and evaluated in parallel throughout this report. Inaddition to the experimental work, SPICE models enabling simulations of standalone OECTs andOECT-based circuits have been developed. Our findings may pave the way for fully integrated, lowvoltageoperating and printed signal processing systems integrated with e.g. printed batteries, solarcells, sensors and communication interfaces. Such technology can then serve a low-cost basetechnology for the internet of things, smart packaging and home diagnostics applications.
|
|
| 10. |
- Jonzen, Jonas, et al.
(författare)
-
Skogliga grunddata : digitala kartor för skogsbruket
- 2016
-
Ingår i: Fakta. Skog. - 1400-7789.
-
Annan publikation (populärvet., debatt m.m.)abstract
- Skogliga grunddata är digitala raster-kartor som beskriver tillståndet i skog och mark. De skogliga variablerna är i huvudsak framtagna genom en sambearbetning av laserdata från Lantmäteriets nationella laserskanning och provytor från Riksskogstaxeringen. De digitala kartorna som beskriver skogsmarken är till stor hjälp för privata skogsägare, skogstjänstemän, myndigheter, m fl. Data är dels tillgängligt för gratis nedladdning, men det finns även möjligheter att titta på kartorna med hjälp av interaktiva webverktyg. Lantmäteriets laserskanning påbörjades 2009 och fortgår än idag. Endast delar av fjällkedjan återstår. Grundtanken med laserskanningen var att få en bra höjdmodell över landet. En bra höjdmodell ger stor nytta vid all samhällsplanering, men är även till hjälp vid klimatanpassning. Riksskogstaxeringen samlar årligen in data om Sveriges skogstillstånd med permanenta och tillfälliga provytor. Dessa provytor är koordinatsatta och är väl spridda över hela landet. I detta projekt har provytor från Riksskogstaxeringen kombinerats med laserdata för att ta fram rasterkartor med uppgifter om virkesvolym, grundyta, medelhöjd, medeldiameter och trädbiomassa.
|
|
