| 1. |
|
|
| 2. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 3. |
|
|
| 4. |
- Askari, SJ, et al.
(författare)
-
Two-step growth of high-quality nano-diamond films using CH 4/H 2 gas mixture
- 2007
-
Ingår i: Vacuum. - : Elsevier BV. - 0042-207X .- 1879-2715. ; 81:5, s. 713-717
-
Tidskriftsartikel (refereegranskat)abstract
- Diamond films with fine grain size and good quality were successfully deposited on pure titanium substrate using a novel two-step growth technique in microwave plasma-assisted chemical vapor deposition (MWPCVD) system. The films were grown with varying the methane (CH4) concentration at the stage of bias-enhanced nucleation (BEN) and nano-diamond film deposition. It was found that nano-diamond nuclei were formed at a relatively high methane concentration, causing a secondary nucleation at the accompanying growth step. Nano-diamond film deposition on pure titanium was always very hard due to the high diffusion coefficient of carbon in Ti, the big difference between thermal expansion coefficients of diamond and Ti, the complex nature of the interlayer created during diamond deposition, and the difficulty in achieving very high nucleation density. A smooth and well-adhered nano-diamond film was successfully obtained on pure Ti substrate. Detailed experimental results on the synthesis, characterization and successful deposition of the nano-diamond film on pure Ti are discussed
|
|
| 5. |
- Liu, X. H., et al.
(författare)
-
Polyamide 6/clay nanocomposites using a cointercalation organophilic clay via melt compounding
- 2003
-
Ingår i: Journal of Applied Polymer Science. - : Wiley. - 0021-8995 .- 1097-4628. ; 88:4, s. 953-958
-
Tidskriftsartikel (refereegranskat)abstract
- Polyamide 6/clay nanocomposites (PA6CN) were prepared via the melt compounding method by using a new kind of organophilic clay, which was obtained through cointercalation of epoxy resin and quaternary ammonium into Na-montmorillonite. The dispersion effect of this kind of organophilic clay in the matrix was studied by means of X-ray diffraction (XRD) and transmission electron microscopy (TEM); the silicate layers were dispersed homogeneously and nearly exfoliated in the matrix. This was probably the result of the strong interaction between epoxy groups and amide end groups of PA6. The mechanical properties and heat distortion temperature (HDT) of PA6CN increased dramatically. The notched Izod impact strength of PA6CN was 80% higher than that of PA6 when the clay loading was 5 wt%. Even at 10 wt% clay content, the impact strength was still higher than that of PA6. The finely dispersed silicate layers and the strong interaction between silicate layers and matrix decreased the water absorption. At 10 wt% clay content, PA6CN only absorbs half the amount of water compared with PA6. The dynamic mechanical properties of PA6CN were also studied.
|
|
| 6. |
- Liu, X. H., et al.
(författare)
-
Investigation on unusual crystallization behavior in polyamide 6/montmorillonite nanocomposites
- 2002
-
Ingår i: Macromolecular materials and engineering. - 1438-7492 .- 1439-2054. ; 287:8, s. 515-522
-
Tidskriftsartikel (refereegranskat)abstract
- The crystallization behavior and crystal structure of polyamide 6/montmorillonite (PA6/MMT) nanocomposites were investigated by differential scanning calorimetry and X-ray diffraction, and an interesting behavior was observed. The material was prepared via melt compounding using an organophilic clay obtained by co-intercalation of epoxy resin and quaternary ammonium into Na-montmorillonite. A maximum in degree of crystallinity was obtained at 5 wt.-% MMT and the reasons for this, based on the MMT layer distribution, were discussed. The degree of crystallinity showed a strong dependence on the cooling rates. In contrast with typical behavior, a higher cooling rate resulted in a higher degree of crystallinity. In nanocomposites, the gamma-crystalline phase was dominant.
|
|
| 7. |
- Liu, X. H., et al.
(författare)
-
Polyamide 6-clay nanocompositles/polypropylene-grafted-maleic anhydride alloys
- 2001
-
Ingår i: Polymer. - 0032-3861 .- 1873-2291. ; 42:19, s. 8235-8239
-
Tidskriftsartikel (refereegranskat)abstract
- Polyamide 6-clay nanocomposites (PA6CN) based on montmorillonite typically show some brittleness with clay addition. In order to address this problem, PA6CN/PP-g-MAH alloys were prepared through blending PA6CN with polypropylene-grafted-maleic anhydride (PP-g-MAH). The mechanical properties, dynamic mechanical temperature spectra, morphology and water absorption of the alloys were studied. Compared with PA6CN, the notched impact strength of the alloys increased greatly while the alloys still maintained higher stiffness and strength than that of PA 6. The morphological studies via scanning electron microscopy (SEM) showed a PP-g-MAH toughen phase dispersed in PA6CN matrix. As the PP-g-MAH content was increased, reduced water absorption was observed.
|
|
