| 1. |
-
- 2019
-
Tidskriftsartikel (refereegranskat)
|
|
| 2. |
- Beal, Jacob, et al.
(författare)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
Ingår i: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Tidskriftsartikel (refereegranskat)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
| 3. |
- Wu, Jingnan, 1994, et al.
(författare)
-
Modulating the nanoscale morphology on carboxylate-pyrazine containing terpolymer toward 17.8% efficiency organic solar cells with enhanced thermal stability
- 2022
-
Ingår i: Chemical Engineering Journal. - : Elsevier BV. - 1385-8947. ; 446
-
Tidskriftsartikel (refereegranskat)abstract
- It had been commonly accepted in the organic photovoltaic (OPV) community that subtle variations in the molecular structure of active layer materials would cause profound impacts on their aggregating structure and blend morphology and therefore the performance of such polymer solar cells (PSCs). Herein, we employed an electron-deficient building block 3,6-dithiophenyl-2-carboxylate pyrazine (DTCPz) for constructing one series of promising donor terpolymers of PMZ1, PMZ2, and PMZ3, respectively, gaining their relatively lower-lying highest occupied molecular orbital (HOMO) energy levels, more closed π-π stacking and enhanced crystallinity in thin films, and lower miscibility with acceptor Y6, in comparison with their parent polymer counterpart (namely PM6). Reaching DTCPz moieties up to 20% (mol/mol%) in its terpolymer composition, the resulting polymer (PMZ2) achieved more favorable phase separation with improved exciton dissociation, and charge transport and extraction. As a result, an outstanding fill factor of 77.2% and a promising power conversion efficiency of 17.8 % was achieved. Moreover, the corresponding device shows better thermal stability over the PM6-based one. This work suggests a facile method for significantly improving the thin film morphology of the active-layer materials via fine-tuning the chemical structure of electron-deficient units on the backbone of the wide bandgap donor polymer, therefore achieving enhanced photovoltaic performance and thermal stability for practical applications.
|
|
| 4. |
- Qin, Guo Qing, et al.
(författare)
-
Experimental Realization of Sensitivity Enhancement and Suppression with Exceptional Surfaces
- 2021
-
Ingår i: Laser and Photonics Reviews. - : Wiley. - 1863-8899 .- 1863-8880. ; 15:5
-
Tidskriftsartikel (refereegranskat)abstract
- By preparing a sensor system around isolated exceptional points, one can obtain a great enhancement of the sensitivity benefiting from the non-Hermiticity. However, this comes at the cost of reduction of the flexibility of the system, which is critical for practical applications. By generalizing the exceptional points to exceptional surfaces, it has been theoretically proposed recently that enhanced sensitivity and flexibility can be combined. Here, an exceptional surface is experimentally demonstrated in a non-Hermitian photonic sensing system, which is composed of a whispering-gallery-mode microresonator and two nanofiber waveguides, resulting in a unidirectional coupling between two degenerate counter-propagating modes with an external optical isolator. The system is simple, robust, and can be easily operated around an exceptional surface. On the one hand, sensitivity enhancement is observed by monitoring the resonant frequency splitting caused by small perturbations. This demonstration of exceptional-surface-enhanced sensitivity paves the way for practical non-Hermitian sensing applications. On the other hand, the suppression of frequency splitting around the exceptional surface is also shown for the first time.
|
|
| 5. |
- Shi, Furong, et al.
(författare)
-
A Nitroxide Radical Conjugated Polymer as an Additive to Reduce Nonradiative Energy Loss in Organic Solar Cells
- 2023
-
Ingår i: Advanced Materials. - : Wiley. - 0935-9648 .- 1521-4095. ; 35:23
-
Tidskriftsartikel (refereegranskat)abstract
- Nonfullerene-acceptor-based organic solar cells (NFA-OSCs) are now set off to the 20% power conversion efficiency milestone. To achieve this, minimizing all loss channels, including nonradiative photovoltage losses, seems a necessity. Nonradiative recombination, to a great extent, is known to be an inherent material property due to vibrationally induced decay of charge-transfer (CT) states or their back electron transfer to the triplet excitons. Herein, it is shown that the use of a new conjugated nitroxide radical polymer with 2,2,6,6-tetramethyl piperidine-1-oxyl side groups (GDTA) as an additive results in an improvement of the photovoltaic performance of NFA-OSCs based on different active layer materials. Upon the addition of GDTA, the open-circuit voltage (VOC), fill factor (FF), and short-circuit current density (JSC) improve simultaneously. This approach is applied to several material systems including state-of-the-art donor/acceptor pairs showing improvement from 15.8% to 17.6% (in the case of PM6:Y6) and from 17.5% to 18.3% (for PM6:BTP-eC9). Then, the possible reasons behind the observed improvements are discussed. The results point toward the suppression of the CT state to triplet excitons loss channel. This work presents a facile, promising, and generic approach to further improve the performance of NFA-OSCs.
|
|
| 6. |
- Sui, Yu fei, et al.
(författare)
-
Engineering cofactor metabolism for improved protein and glucoamylase production in Aspergillus niger
- 2020
-
Ingår i: Microbial Cell Factories. - : Springer Science and Business Media LLC. - 1475-2859. ; 19:1
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Nicotinamide adenine dinucleotide phosphate (NADPH) is an important cofactor ensuring intracellular redox balance, anabolism and cell growth in all living systems. Our recent multi-omics analyses of glucoamylase (GlaA) biosynthesis in the filamentous fungal cell factory Aspergillus niger indicated that low availability of NADPH might be a limiting factor for GlaA overproduction. Results: We thus employed the Design-Build-Test-Learn cycle for metabolic engineering to identify and prioritize effective cofactor engineering strategies for GlaA overproduction. Based on available metabolomics and 13C metabolic flux analysis data, we individually overexpressed seven predicted genes encoding NADPH generation enzymes under the control of the Tet-on gene switch in two A. niger recipient strains, one carrying a single and one carrying seven glaA gene copies, respectively, to test their individual effects on GlaA and total protein overproduction. Both strains were selected to understand if a strong pull towards glaA biosynthesis (seven gene copies) mandates a higher NADPH supply compared to the native condition (one gene copy). Detailed analysis of all 14 strains cultivated in shake flask cultures uncovered that overexpression of the gsdA gene (glucose 6-phosphate dehydrogenase), gndA gene (6-phosphogluconate dehydrogenase) and maeA gene (NADP-dependent malic enzyme) supported GlaA production on a subtle (10%) but significant level in the background strain carrying seven glaA gene copies. We thus performed maltose-limited chemostat cultures combining metabolome analysis for these three isolates to characterize metabolic-level fluctuations caused by cofactor engineering. In these cultures, overexpression of either the gndA or maeA gene increased the intracellular NADPH pool by 45% and 66%, and the yield of GlaA by 65% and 30%, respectively. In contrast, overexpression of the gsdA gene had a negative effect on both total protein and glucoamylase production. Conclusions: This data suggests for the first time that increased NADPH availability can indeed underpin protein and especially GlaA production in strains where a strong pull towards GlaA biosynthesis exists. This data also indicates that the highest impact on GlaA production can be engineered on a genetic level by increasing the flux through the pentose phosphate pathway (gndA gene) followed by engineering the flux through the reverse TCA cycle (maeA gene). We thus propose that NADPH cofactor engineering is indeed a valid strategy for metabolic engineering of A. niger to improve GlaA production, a strategy which is certainly also applicable to the rational design of other microbial cell factories.[Figure not available: see fulltext.].
|
|
