| 1. |
- Zhang, Kai, et al.
(författare)
-
Quantifying the photovoltaic potential of highways in China
- 2022
-
Ingår i: Applied Energy. - : Elsevier BV. - 0306-2619 .- 1872-9118. ; 324, s. 119600-
-
Tidskriftsartikel (refereegranskat)abstract
- Installing photovoltaic (PV) modules on highways is considered a promising way to support carbon neutrality in China. However, collecting the area of the highway, and precisely assessing the shadow area of the highway under complex terrain remain challenges. That severely hinders the assessment of highway PV potential. To address these challenges, a spatiotemporal model is developed in this study to estimate the annual solar PV potential on highways over the whole Chinese territory. First, the areas of different highway segments are calculated based on highway network and highway toll stations. Second, hourly shadow area on highways created by nearby terrain is estimated based on a digital elevation model (DEM). When calculating the highway PV potential, the solar irradiation received in these shadow areas is regarded as zero. Finally, the PV potential of all lanes and emergency lanes was estimated at the prefecture-level city scale using surface radiation data and radiation assessment models. Based on the highway data with a total mileage of 143,684 km at the end of 2020, the results show that the annual PV potential is 3,932 TW and that the corresponding installed capacity is 700.85 GW, which can generate clean electricity at a rate of up to 629.06 TWh. The annual PV potential of highways in the southeast is greater than that in the northwest owing to the higher highway density in the southeast. This study provides a reference basis for highway PV construction planning and suitably assessment in each region of China for PV highway development.
|
|
| 2. |
- Yuan, Ying Kuo, et al.
(författare)
-
Applications of graphene transistor optimized fabrication process in monolithic integrated driving gallium nitride micro-light-emitting diode
- 2021
-
Ingår i: Wuli Xuebao/Acta Physica Sinica. - : Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences. - 1000-3290. ; 70:19
-
Tidskriftsartikel (refereegranskat)abstract
- In the information display field, micro-light-emitting diodes (micro-LEDs) possess high potentials and they are expected to lead the direction of developing the next-generation new display technologies. Their display performances are superior to those produced by the currently prevailing liquid crystal and organic light-emitting diode based technologies. However, the micro-LED pixels and their driving circuits are often fabricated on different wafers, which implies that the so-called mass transfer seems to be inevitable, thus facing an obvious bottleneck. In this paper, the emerging graphene field effect transistors are used as the driving elements and integrated onto the GaN micro-LEDs, which is because the pixels and drivers are prepared directly on the same wafer, the technical problem of mass transfer is fundamentally bypassed. Furthermore, in traditional lithographic process, the ultraviolet photoresist directly contacts the graphene, which introduces severe carrier doping, thereby leading to deteriorated graphene transistor properties. This, not surprisingly, further translates into lower performances of the integrated devices. In the present work, proposed is a technique in which the polymethyl methacrylate (PMMA) thin films act as both the protection layers and the interlayers when optimizing the graphene field effect transistor processing. The PMMA layers are sandwiched between the graphene and the ultraviolet photoresist, which is a brand new device fabrication process. First, the new process is tested in discrete graphene field effect transistors. Compared with those devices that are processed without the PMMA protection thin films, the graphene devices fabricated with the new technology typically show their Dirac point at a gate voltage (Vg) deviation from Vg = 0, that is, 22 V lower than their counterparts. In addition, an increase in the carrier mobility of 32% is also observed. Finally, after applying the newly developed fabrication process to the pixel-and-driver integrated devices, it is found that their performances are improved significantly. With this new technique, the ultraviolet photoresist no longer directly contacts the sensitive graphene channel because of the PMMA protection. The doping effect and the performance dropping are dramatically reduced. The technique is facile and cheap, and it is also applicable to two-dimensional materials besides graphene, such as MoS2 and h-BN. It is hoped that it is of some value for device engineers working in this field.
|
|
| 3. |
- Zhang, Zhixin, et al.
(författare)
-
Vectorized rooftop area data for 90 cities in China
- 2022
-
Ingår i: Scientific Data. - : Springer Nature. - 2052-4463. ; 9:1
-
Tidskriftsartikel (refereegranskat)abstract
- Reliable information on building rooftops is crucial for utilizing limited urban space effectively. In recent decades, the demand for accurate and up-to-date data on the areas of rooftops on a large-scale is increasing. However, obtaining these data is challenging due to the limited capability of conventional computer vision methods and the high cost of 3D modeling involving aerial photogrammetry. In this study, a geospatial artificial intelligence framework is presented to obtain data for rooftops using high-resolution open-access remote sensing imagery. This framework is used to generate vectorized data for rooftops in 90 cities in China. The data was validated on test samples of 180 km(2) across different regions with spatial resolution, overall accuracy, and F1 score of 1 m, 97.95%, and 83.11%, respectively. In addition, the generated rooftop area conforms to the urban morphological characteristics and reflects urbanization level. These results demonstrate that the generated dataset can be used for data support and decision-making that can facilitate sustainable urban development effectively.
|
|
| 4. |
- Li, Kai, et al.
(författare)
-
Metal thermopile infrared detector with vertical graphene
- 2023
-
Ingår i: Wuli Xuebao/Acta Physica Sinica. - : Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences. - 1000-3290. ; 72:3
-
Tidskriftsartikel (refereegranskat)abstract
- Thermopile infrared detector is a kind of detector device mainly composed of thermocouple as the basic unit. Because of its simple principle, no need of cooling equipment, and other advantages, it has been widely used in various fields of production and life. However, the absorption rates of the materials in conventional thermopile devices are poor, and the majority of them are incompatible with microfabrication methods. In this work, a metal thermopile infrared detector with vertical graphene (VG) is designed and fabricated. The VG is grown via plasma enhanced chemical vapor deposition, and retained at the device’s thermal ends to provide the thermopile IR detector’s wideband and high response characteristics. The detector achieves a room temperature responsivity reaching a value as high as 1.53 V/W at 792 nm, which can increase the response results about 28 times and reduce the response time to 0.8 ms compared with the thermopile detector without VG. After systematically measuring the response results, it is finally found that there are three main mechanisms responsible for the response on the composite device. The first one is the response generated by the metal thermopile itself alone. The second one is the response increased eventually by the contribution of VG covered at the metal thermal junction that expands the temperature difference. The last one is the response generated by the temperature gradient existing inside the VG on the surface of the device after the absorption of heat. The portion of each partial response mechanism in the total response is also analyzed, providing a new reference direction for analyzing the response generation mechanism of thermopile detectors with other absorbing materials. The process is compatible with the microfabrication, while the device performance is enhanced and suitable for mass production. Furthermore, by utilizing the surface plasmon resonance to combine VG with metal nanoparticles, the material’ s light absorption is found to be enhanced significantly under the same conditions, and the resulting thermal voltage can be increased to 6 times. The results indicate that VG promises to possess practical applications, in many fields such as photoelectric sensing and power production devices. This technology provides a new method to manufacture high-performance thermopile infrared detectors and other sensor devices.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
- Fenstermacher, M.E., et al.
(författare)
-
DIII-D research advancing the physics basis for optimizing the tokamak approach to fusion energy
- 2022
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 62:4
-
Tidskriftsartikel (refereegranskat)abstract
- DIII-D physics research addresses critical challenges for the operation of ITER and the next generation of fusion energy devices. This is done through a focus on innovations to provide solutions for high performance long pulse operation, coupled with fundamental plasma physics understanding and model validation, to drive scenario development by integrating high performance core and boundary plasmas. Substantial increases in off-axis current drive efficiency from an innovative top launch system for EC power, and in pressure broadening for Alfven eigenmode control from a co-/counter-I p steerable off-axis neutral beam, all improve the prospects for optimization of future long pulse/steady state high performance tokamak operation. Fundamental studies into the modes that drive the evolution of the pedestal pressure profile and electron vs ion heat flux validate predictive models of pedestal recovery after ELMs. Understanding the physics mechanisms of ELM control and density pumpout by 3D magnetic perturbation fields leads to confident predictions for ITER and future devices. Validated modeling of high-Z shattered pellet injection for disruption mitigation, runaway electron dissipation, and techniques for disruption prediction and avoidance including machine learning, give confidence in handling disruptivity for future devices. For the non-nuclear phase of ITER, two actuators are identified to lower the L-H threshold power in hydrogen plasmas. With this physics understanding and suite of capabilities, a high poloidal beta optimized-core scenario with an internal transport barrier that projects nearly to Q = 10 in ITER at ∼8 MA was coupled to a detached divertor, and a near super H-mode optimized-pedestal scenario with co-I p beam injection was coupled to a radiative divertor. The hybrid core scenario was achieved directly, without the need for anomalous current diffusion, using off-axis current drive actuators. Also, a controller to assess proximity to stability limits and regulate β N in the ITER baseline scenario, based on plasma response to probing 3D fields, was demonstrated. Finally, innovative tokamak operation using a negative triangularity shape showed many attractive features for future pilot plant operation.
|
|
| 9. |
- Jiang, Mingkun, et al.
(författare)
-
Using Existing Infrastructure to Realize Low-Cost and Flexible Photovoltaic Power Generation in Areas with High-Power Demand in China
- 2020
-
Ingår i: iScience. - : Elsevier Inc.. - 2589-0042. ; 23:12
-
Tidskriftsartikel (refereegranskat)abstract
- Energy Policy; Energy Resources; Energy Systems; Energy Management © 2020 This study develops a new concept involving using the existing infrastructure for photovoltaic (PV) generation to reduce the costs associated with increased land use and to avoid curtailment due to the mismatch between power supply and demand. We establish a method to estimate the technological potential and economic performance of the PV systems deployed in coal-fired power plants in China. The potential capacity of the examined 1,082 units in China reaches 4 GWe, which is equivalent to 32% of China's newly installed distributed PV capacity in 2019. A total of 87% of PV systems achieve plant-side grid parity compared with desulfurized coal benchmark electricity prices. To the best of our knowledge, this is the first study that investigates the use of rooftops and coal storage sheds in power plants to facilitate low-cost, flexible PV power generation, thus opening a new channel for future PV generation development.
|
|
| 10. |
- Liu, Junwei, et al.
(författare)
-
Polymer synergy for efficient hole transport in solar cells and photodetectors
- 2023
-
Ingår i: Energy & Environmental Science. - : ROYAL SOC CHEMISTRY. - 1754-5692 .- 1754-5706.
-
Tidskriftsartikel (refereegranskat)abstract
- Hole transport materials (HTMs) have greatly advanced the progress of solution-based electronic devices in the past few years. Nevertheless, most devices employing dopant-free organic HTMs can only deliver inferior performance. In this work, we introduced a novel "polymer synergy" strategy to develop versatile dopant-free polymer HTMs for quantum dot/perovskite solar cells and photodetectors. With this synergy strategy, the optical, electrical and aggregation properties of polymer HTMs can be modulated, resulting in complementary absorption, high hole mobility, favorable energy landscape and moderate aggregation. Moreover, a clear orientational transition was observed for the developed HTMs with a 9-fold increase in the face-on/edge-on ratio, providing a highway-like carrier transport for electronic devices, as revealed by in situ characterization and ultrafast transient absorption. With these benefits, the photovoltaic and photodetection performance of quantum dot devices were boosted from 11.8% to 13.5% and from 2.95 x 10(12) to 3.41 x 10(13) Jones (over a 10-fold increase), respectively. Furthermore, the developed polymer HTMs can also significantly enhance the photovoltaic and photodetection performance of perovskite devices from 15.1% to 22.7% and from 2.7 x 10(12) to 2.17 x 10(13)Jones with the same device structure, indicating their great application potential in the emerging optoelectronics.
|
|
