| 1. |
- Carlberg, Patrick, et al.
(författare)
-
Nanoimprint - a tool for realizing nano-bio research
- 2004
-
Ingår i: 2004 4th IEEE Conference on Nanotechnology. - 0780385365 ; , s. 199-200
-
Konferensbidrag (refereegranskat)abstract
- In this paper, we present a status report on how implementation of nanoimprint lithography has advanced our research. Contact guidance nerve growth experiments have so far primarily been done on micrometer-structured surfaces. We have made a stamp with 17 areas of different, submicron, line width and spacing covering a total 2.6 mm
|
|
| 2. |
- Lewen, R., et al.
(författare)
-
High frequency characterization of a GaInAs/InP electronic waveguide T-branch switch
- 2002
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 91:4, s. 2398-2402
-
Tidskriftsartikel (refereegranskat)abstract
- We report comprehensive microwave measurements on a T-branch switch; a GaInAs/InP electron waveguide based structure. The study includes a small signal model of the device where limitations of high frequency operation are discussed. An example of large signal operation where the nonlinearity of the device is exploited by operating the T-branch switch as a frequency multiplier is demonstrated.
|
|
| 3. |
- Maximov, Ivan, et al.
(författare)
-
Nanoimprint lithography for fabrication of three-terminal ballistic junctions in InP/GaInAs
- 2002
-
Ingår i: Nanotechnology. - : IOP Publishing. - 0957-4484. ; 13:5, s. 666-668
-
Tidskriftsartikel (refereegranskat)abstract
- We present processing technology and characterization results for InP/GaInAs two-dimensional electron gas (2DEG) three-terminal ballistic junction (TBJ) devices manufactured using nanoimprint lithography (NIL). To transfer sub-100 nm features into a high-mobility InP-based 2DEG material, we used SiO2/Si stamps made using electron beam lithography and reactive ion etching. After NIL, the resist residues are removed in oxygen plasma; this is followed by wet etching of InP/GaInAs to define the TBJ structures. Fabricated TBJ devices are characterized using scanning electron microscopy and electron transport measurements. Highly non-linear electrical characteristics as predicted by the theory (Xu H Q 2001 APPI. Phys. Lett. 78 2064) are demonstrated.
|
|
| 4. |
- Maximov, Ivan, et al.
(författare)
-
Nanoimprint technology for fabrication of three-terminal ballistic junction devices in GaInAs/InP
- 2003
-
Ingår i: Microelectronic Engineering. - 1873-5568. ; 67-8, s. 196-202
-
Tidskriftsartikel (refereegranskat)abstract
- We present processing technology based on nanoimprint lithography (NIL) and wet etching for fabrication of GaInAs/InP three-terminal ballistic junction (TBJ) devices. To transfer sub-100 nm features into a high-mobility InP-based 2DEG material, we used SiO2/Si stamps made with electron beam lithography and reactive ion etching. After the NIL, the resist residues are removed in oxygen plasma followed by wet etching of GaInAs/InP to define the M-structures. Fabricated TBJ-devices are characterized using scanning electron microscopy and electron transport measurements. Highly non-linear electrical characteristics of the TBJ structures are demonstrated and compared with E-beam defined devices. (C) 2003 Elsevier Science B.V. All rights reserved.
|
|
| 5. |
- Balocco, C, et al.
(författare)
-
Microwave detection at 110 GHz by nanowires with broken symmetry
- 2005
-
Ingår i: Nano Letters. - : American Chemical Society (ACS). - 1530-6992 .- 1530-6984. ; 5:7, s. 1423-1427
-
Tidskriftsartikel (refereegranskat)abstract
- By using arrays of nanowires with intentionally broken symmetry, we were able to detect microwaves up to 110 GHz at room temperature. This is, to the best of our knowledge, the highest speed that has been demonstrated in different types of novel electronic nanostructures to date. Our experiments showed a rather stable detection sensitivity over a broad frequency range from 100 MHz to 110 GHz. The novel working principle enabled the nanowires to detect microwaves efficiently without a dc bias. In principle, the need for only one high-resolution lithography step and the planar architecture allow an arbitrary number of nanowires to be made by folding a linear array as many times as required over a large area, for example, a whole wafer. Our experiment on 18 parallel nanowires showed a sensitivity of approximately 75 mV dc output/mW of nominal input power of the 110 GHz signal, even though only about 0.4% of the rf power was effectively applied to the structure because of an impedance mismatch. Because this array of nanowires operates simultaneously, low detection noise was achieved, allowing us to detect -25 dBm 110 GHz microwaves at zero bias with a standard setup.
|
|
| 6. |
- Gustafsson, Anders, et al.
(författare)
-
Reevaluation of blueshifts introduced by lateral confinement in quantum-well wire structures
- 1993
-
Ingår i: Applied Physics Letters. - 0003-6951. ; 12:15, s. 1709-1711
-
Tidskriftsartikel (refereegranskat)abstract
- The luminescence from etched quantum-well wire structures often exhibits an unexpectedly large blueshift of the peak energy position. Further, the shift is usually quite independent of the width of the wires. In this letter we show that this blueshift can be explained as a decreased transfer of excitons between areas of different monolayer thicknesses within the single quantum wells, caused by a change in the exciton diffusion from being two-dimensional in the quantum wells to one-dimensional in the wires. This reduced transfer will result in a blueshift of the peak energy position if the monolayer splitting is unresolved.
|
|
| 7. |
- Jafari Jam, Reza, et al.
(författare)
-
III-V nanowire synthesis by use of electrodeposited gold particles
- 2015
-
Ingår i: Nano letters (Print). - Washington, DC : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 15:1, s. 134-138
-
Tidskriftsartikel (refereegranskat)abstract
- Semiconductor nanowires are great candidates for building novel electronic devices. Considering the cost of fabricating such devices, substrate reuse and gold consumption are the main concerns. Here we report on implementation of high throughput gold electrodeposition for selective deposition of metal seed particles in arrays defined by lithography for nanowire synthesis. By use of this method, a reduction in gold consumption by a factor of at least 300 was achieved, as compared to conventional thermal evaporation for the same pattern. Because this method also facilitates substrate reuse, a significantly reduced cost of the final device is expected. We investigate the morphology, crystallography, and optical properties of InP and GaAs nanowires grown from electrodeposited gold seed particles and compare them with the properties of nanowires grown from seed particles defined by thermal evaporation of gold. We find that nanowire synthesis, as well as the material properties of the grown nanowires are comparable and quite independent of the gold deposition technique. On the basis of these results, electrodeposition is proposed as a key technology for large-scale fabrication of nanowire-based devices.
|
|
| 8. |
|
|
| 9. |
- Martin, TP, et al.
(författare)
-
The influence of confining wall profile on quantum interference effects in etched Ga0.25In0.75As/InP billiards
- 2003
-
Ingår i: Superlattices and Microstructures. - : Elsevier BV. - 0749-6036. ; 34:3-6, s. 179-184
-
Tidskriftsartikel (refereegranskat)abstract
- We present measurements of the potential profile of etched GaInAs/InP billiards and show that their energy gradients are an order of magnitude steeper than those of surface-gated GaAs/AlGaAs billiards. Previously observed in GaAs/AlGaAs billiards, fractal conductance fluctuations are predicted to be critically sensitive to the billiard profile. Here we show that, despite the increase in energy gradient, the fractal conductance fluctuations persist in the harder GaInAs/InP billiards. (C) 2004 Elsevier Ltd. All rights reserved.
|
|
| 10. |
- Shorubalko, Ivan, et al.
(författare)
-
A novel frequency-doubling device based on three-terminal ballistic junction
- 2002
-
Ingår i: Device Research Conference (Cat. No.02TH8606). - 0780373170 ; , s. 159-160
-
Konferensbidrag (refereegranskat)abstract
- Summary form only given. Ballistic devices have received increasing attention for their nonlinear electrical properties, which are interesting from both physics and application points of view. Recently, novel nonlinear electrical properties of three-terminal ballistic junctions (TBJs) have been discovered theoretically and experimentally. In this work we propose and demonstrate functionality of a novel frequency-doubling device based on a three-terminal ballistic junction. The novel devices are fabricated by integrating a T-shaped TBJ and a one-dimensional (1D) lateral-field-effect transistor (lateral-FET) with trench gate-channel insulation on high-electron-mobility GaInAs/InP quantum well structures The results of the measurements show frequency doubling and gain in these novel devices at room temperature
|
|
