| 1. |
- Grob, Stefan, et al.
(författare)
-
Solvent vapor annealing on perylene-based organic solar cells
- 2015
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry. - 2050-7488 .- 2050-7496. ; 3:30, s. 15700-15709
-
Tidskriftsartikel (refereegranskat)abstract
- Diindenoperylene (DIP) and tetraphenyldibenzoperiflanthene (DBP) are two commonly used donor materials in organic solar cell devices. Despite their structural similarities, DIP films are crystalline, exhibiting good charge and exciton transport, whereas DBP films are amorphous and have lower carrier mobility and a short exciton diffusion length. However, DBP reveals a distinctly higher absorption due to the lying orientation of its transition dipole moments. In this paper, we investigate the influence of solvent vapor annealing (SVA) on the solar cell performance of both materials. In general, SVA induces a partial re-solubilization of the material leading to enhanced crystallinity of the treated layer. For DBP, extended annealing times result in a strong aggregation of the molecules, creating inhomogeneous layers unfavorable for solar cells. However, in DIP cells, SVA leads to an increase in fill factor (FF) and also a slight increase in short-circuit current density (JSC) due to interface roughening. The best results are obtained by combining solvent vapor annealed DIP layers with strongly absorbing DBP and C-70 on top. Through this device architecture, we obtain the same increase in FF in addition to a higher gain in J(SC), elevating the power conversion efficiency by a factor of 1.2 to more than 4%.
|
|
| 2. |
- Hörmann, Ulrich, et al.
(författare)
-
Voc from a Morphology Point of View : the Influence of Molecular Orientation on the Open Circuit Voltage of Organic Planar Heterojunction Solar Cells
- 2014
-
Ingår i: Journal of physical chemistry C. - : American Chemical Society (ACS). - 1932-7455 .- 1932-7447. ; 118:46, s. 26462-26470
-
Tidskriftsartikel (refereegranskat)abstract
- The film morphology and device performance of planar heterojunctionsolar cells based on the molecular donor material α-sexithiophene (6T) are investigated.Planar heterojunctions of 6T with two different acceptor molecules, the C60 fullerene anddiindenoperylene (DIP), have been prepared. The growth temperature of the 6T bottomlayer has been varied between room temperature and 100 °C for each acceptor. By meansof X-ray diffraction and X-ray absorption, we show that the crystallinity and the molecularorientation of 6T is influenced by the preparation conditions and that the 6T filmtemplates the growth of the subsequent acceptor layer. These structural changes areaccompanied by changes in the characteristic parameters of the correspondingphotovoltaic cells. This is most prominently observed as a shift of the open circuitvoltage (Voc): In the case of 6T/C60 heterojunctions, Voc decreases from 0.4 to 0.3 V,approximately, if the growth temperature of 6T is increased from room temperature to 100°C. By contrast, Voc increases from about 1.2 V to almost 1.4 V in the case of 6T/DIP solarcells under the same conditions. We attribute these changes upon substrate heating toincreased recombination in the C60 case while an orientation dependent intermolecular coupling seems to change the origin of the photovoltaic gap in the DIP case.
|
|
