| 1. |
- Jain, Vishal, 1989-, et al.
(författare)
-
A comparative study of nanowire based infrared p+-i-n+ photodetectors
- 2012
-
Konferensbidrag (refereegranskat)abstract
- We present a comparative study of electrical and optical properties of two types of p+-i-n+ photodetectors based on self-assembled ensembles of vertical InP nanowires (NWs) monolithically grown on InP. The detectors differ in the type of p+ contact, one detector geometry has p+-i-n+ segments integrated into the NWs (type A) while the other detector has i-n+ NW segments grown directly on a p+ substrate(type B). The samples were prepared by first depositing 80 nm Au nanoparticles on a p+ InP substrate using an aerosol technique and subsequently growing NWs using MOVPE. The NWs have a polytypecrystal structure of alternating wurtzite and zincblende segments. The processing of the detectors include deposition of SiO2, followed by an etching step to remove the oxide from the tip of the NWs, and finally sputtering of ITO on 1x1 mm2 device areas. The two most prominent differences between the detectors concern the current-voltage (I-V) characteristics and the spatial location of generated photocurrent. From spectrally resolved photocurrent measurements, we conclude that the photocurrent in detector type A is primarily generated in the NWs, whereas the photocurrent in type B detectors mainly stems from the substrate. Photogenerated carriers in the substrate diffuse to the NWs where they are effectively funnelled into the NWs. The I-V characteristics of the type A detector displays a non-trivial transport behaviour for forward biases, whereas type B shows excellent rectifying behavior with an ideality factor of about 2.5. We will discuss detailed analysis of the spectral fingerprints of the two detector types revealing the mixed crystal phase of the polytype NWs and bandstructure effects, temperature dependence of the I-V characteristics and typical photodetector parameters.
|
|
| 2. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Electrical and optical properties of InP nanowire ensemble p(+)-i-n(+) photodetectors
- 2012
-
Ingår i: Nanotechnology. - Bristol, UK : Institute of Physics Publishing (IOPP). - 0957-4484 .- 1361-6528. ; 23:13
-
Tidskriftsartikel (refereegranskat)abstract
- We report on a comprehensive study of electrical and optical properties of efficient near-infrared p(+)-i-n(+) photodetectors based on large ensembles of self-assembled, vertically aligned i-n(+) InP nanowires monolithically grown on a common p(+) InP substrate without any buffer layer. The nanowires have a polytype modulated crystal structure of wurtzite and zinc blende. The electrical data display excellent rectifying behavior with an ideality factor of about 2.5 at 300 K. The ideality factor scales with 1/T, which possibly reflects deviations from classical transport models due to the mixed crystal phase of the nanowires. The observed dark leakage current is of the order of merely similar to 100 fA/nanowire at 1 V reverse bias. The detectors display a linear increase of the photocurrent with reverse bias up to about 10 pA/nanowire at 5 V. From spectrally resolved measurements, we conclude that the photocurrent is primarily generated by funneling photogenerated carriers from the substrate into the NWs. Contributions from direct excitation of the NWs become increasingly important at low temperatures. The photocurrent decreases with temperature with an activation energy of about 50 meV, which we discuss in terms of a temperature-dependent diffusion length in the substrate and perturbed transport through the mixed-phase nanowires. © 2012 IOP Publishing Ltd.
|
|
| 3. |
- Dzhigaev, Dmitry, et al.
(författare)
-
Strain mapping inside an individual processed vertical nanowire transistor using scanning X-ray nanodiffraction
- 2020
-
Ingår i: Nanoscale. - : Royal Society of Chemistry (RSC). - 2040-3372 .- 2040-3364. ; 12:27, s. 14487-14493
-
Tidskriftsartikel (refereegranskat)abstract
- Semiconductor nanowires in wrapped, gate-all-around transistor geometry are highly favorable for future electronics. The advanced nanodevice processing results in strain due to the deposited dielectric and metal layers surrounding the nanowires, significantly affecting their performance. Therefore, non-destructive nanoscale characterization of complete devices is of utmost importance due to the small feature sizes and three-dimensional buried structure. Direct strain mapping inside heterostructured GaSb-InAs nanowire tunnel field-effect transistor embedded in dielectric HfO2, W metal gate layers, and an organic spacer is performed using fast scanning X-ray nanodiffraction. The effect of 10 nm W gate on a single embedded nanowire with segment diameters down to 40 nm is retrieved. The tensile strain values reach 0.26% in the p-type GaSb segment of the transistor. Supported by the finite element method simulation, we establish a connection between the Ar pressure used during the W layer deposition and the nanowire strain state. Thus, we can benchmark our models for further improvements in device engineering. Our study indicates, how the significant increase in X-ray brightness at 4th generation synchrotron, makes high-throughput measurements on realistic nanoelectronic devices viable.
|
|
| 4. |
- Jain, Vishal, 1989-, et al.
(författare)
-
Large area photodetectors based on InP NWs with InAs/InAsP QWs
- 2014
-
Konferensbidrag (refereegranskat)abstract
- Focal plane arrays have a widespread use in infrared imaging, which often rely on cryogenic cooling to curtail the dark current level necessary for a reasonable signal-to-noise ratio. Quantum well (QW) infrared photodetectors are uniform over large areas, but suffer from a severe drawback related to the selection rules for intersubband absorption. An interesting alternative is self-assembled III-V nanowires offering a key advantage owing to the enhanced absorption by optical resonance effects and strain relaxation.We present electrical and optical results from large ensembles of n+-i-n+ InP NWs, axially grown on InP substrates with InAs/InAsP QWs embedded within the i-segment, designed for both interband and intersubband detection. The NWs are contacted in a vertical geometry using 50 nm SiO2 as the insulating layer and ITO as the top contact. We first investigate the crystal quality of the InAsP QWs grown in 180 nm diameter NWs, using PL, CL and TEM. To achieve more abrupt InAs/InAsP QWs, we grow 130 nm diameter NWs and deplete the In present in the Au catalysts. The effect of n-doping on the device performance is studied by fabricating two different NW geometries, with and without an n+-segment grown before the nominal i-segment in the NW. In addition, the position of the QWs within the i-segment is varied to further scrutinize effects related to doping and crystal structure. Finally, we report spectrally resolved photocurrent results from the QWs in the near-infrared region and discuss about the further developments needed for intersubband detection.
|
|
| 5. |
- Adolfsson, Karl, et al.
(författare)
-
Fluorescent Nanowire Heterostructures as a Versatile Tool for Biology Applications
- 2013
-
Ingår i: Nano Letters. - : American Chemical Society (ACS). - 1530-6992 .- 1530-6984. ; 13:10, s. 4728-4732
-
Tidskriftsartikel (refereegranskat)abstract
- Nanowires are increasingly used in biology, as sensors, as injection devices, and us model systems for toxicity studies. Currently, in situ visualization of nanowires in biological media is done using organic dyes, which a;:e prone to photobleaching, or using microscopy methods which either yield poor resolution or require a sophisticated setup. Here we show that inherently fluorescent nanowire axial heterostructnies c:an be used to localize and identify nanowires in cells and tissue; By synthesizing GaP GaInP nanowire heterostructures, with nonfluorescent GaP segments and fluorescent GaInP segments, we created a barcode labeling system enabling the distinction of the nanowire morphological and chemical properties using fluorescence microscopy. The GaInP photoluminescence stability, combined with the fact that the nanowires can be coated with different materials while retaining their fluorescence, make these nanowires promising tools for biological and nanotoxicological studies.
|
|
| 6. |
- Borgström, Magnus, et al.
(författare)
-
Nanowires With Promise for Photovoltaics
- 2011
-
Ingår i: IEEE Journal of Selected Topics in Quantum Electronics. - 1077-260X. ; 17:4, s. 1050-1061
-
Tidskriftsartikel (refereegranskat)abstract
- Solar energy harvesting for electricity production is regarded as a fully credible future energy source: plentiful and without serious environmental concerns. The breakthrough for solar energy technology implementation has, however, been hampered by two issues: the conversion efficiency of light into electricity and the solar panel production cost. The use of III-V nanowires (NWs) in photovoltaics allows to respond to both these demands. They offer efficient light absorption and significant cost reduction. These low-dimensional structures can be grown epitaxially in dense NW arrays directly on silicon wafers, which are abundant and cheaper than the germanium substrates used for triple-junction solar cells today. For planar structures, lattice matching poses a strong restriction on growth. III-V NWs offer to create highly efficient multijunction devices, since multiple materials can be combined to match the solar spectrum without the need of tightly controlled lattice matching. At the same time, less material is required for NW-based solar cells than for planar-based architecture. This approach has potential to reach more than 50% in efficiency. Here, we describe our work on NW tandem solar cells, aiming toward two junctions absorbing different parts of the solar spectrum, connected in series via a tunnel diode.
|
|
| 7. |
- Borschel, Christian, et al.
(författare)
-
A New Route toward Semiconductor Nanospintronics : Highly Mn-Doped GaAs Nanowires Realized by Ion-Implantation under Dynamic Annealing Conditions
- 2011
-
Ingår i: Nano letters (Print). - Washington : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 11:9, s. 3935-3940
-
Tidskriftsartikel (refereegranskat)abstract
- We report on highly Mn-doped GaAs nanowires (NWs) of high crystalline quality fabricated by ion beam implantation, a technique that allows doping concentrations beyond the equilibrium solubility limit. We studied two approaches for the preparation of Mn-doped GaAs NWs: First, ion implantation at room temperature with subsequent annealing resulted in polycrystalline NWs and phase segregation of MnAs and GaAs. The second approach was ion implantation at elevated temperatures. In this case, the single-crystallinity of the GaAs NWs was maintained, and crystalline, highly Mn-doped GaAs NWs were obtained. The electrical resistance of such NWs dropped with increasing temperature (activation energy about 70 meV). Corresponding magnetoresistance measurements showed a decrease at low temperatures, indicating paramagnetism. Our findings suggest possibilities for future applications where dense arrays of GaMnAs nanowires may be used as a new kind of magnetic material system.
|
|
| 8. |
- Ganjipour, Bahram, et al.
(författare)
-
Tunnel Field-Effect Transistors Based on InP-GaAs Heterostructure Nanowires.
- 2012
-
Ingår i: ACS Nano. - : American Chemical Society (ACS). - 1936-086X .- 1936-0851. ; 6:4, s. 3109-3113
-
Tidskriftsartikel (refereegranskat)abstract
- We present tunneling field-effect transistors fabricated from InP-GaAs heterostructure nanowires with an n-i-p doping profile, where the intrinsic InP region is modulated by a top gate. The devices show an inverse subthreshold slope down to 50 mV/dec averaged over two decades with an on/off current ratio of approximately 10(7) for a gate voltage swing (V(GS)) of 1 V and an on-current of 2.2 μA/μm. Low-temperature measurements suggest a mechanism of trap-assisted tunneling, possibly explained by a narrow band gap segment of InGaAsP.
|
|
| 9. |
- Hjort, Martin, et al.
(författare)
-
Surface Chemistry, Structure, and Electronic Properties from Microns to the Atomic Scale of Axially Doped Semiconductor Nanowires.
- 2012
-
Ingår i: ACS Nano. - : American Chemical Society (ACS). - 1936-086X .- 1936-0851.
-
Tidskriftsartikel (refereegranskat)abstract
- Using both synchrotron-based photoemission electron microscopy/spectroscopy and scanning tunneling microscopy/spectroscopy, we obtain a complete picture of the surface composition, morphology, and electronic structure of InP nanowires. Characterization is done at all relevant length scales from micrometer to nanometer. We investigate nanowire surfaces with native oxide and molecular adsorbates resulting from exposure to ambient air. Atomic hydrogen exposure at elevated temperatures which leads to the removal of surface oxides while leaving the crystalline part of the wire intact was also studied. We show how surface chemical composition will seriously influence nanowire electronic properties. However, opposite to, for example, Ge nanowires, water or sulfur molecules adsorbed on the exterior oxidized surfaces are of less relevance. Instead, it is the final few atomic layers of the oxide which plays the most significant role by strongly negatively doping the surface. The InP nanowires in air are rather insensitive to their chemical surroundings in contrast to what is often assumed for nanowires. Our measurements allow us to draw a complete energy diagram depicting both band gap and differences in electron affinity across an axial nanowire p-n junction. Our findings thus give a robust set of quantitative values relating surface chemical composition to specific electronic properties highly relevant for simulating the performance of nanoscale devices.
|
|
| 10. |
- Jacobsson, Daniel, et al.
(författare)
-
Particle-assisted GaxIn1-xP nanowire growth for designed bandgap structures
- 2012
-
Ingår i: Nanotechnology. - : IOP Publishing. - 0957-4484 .- 1361-6528. ; 23:24
-
Tidskriftsartikel (refereegranskat)abstract
- Non-tapered vertically straight GaxIn1-xP nanowires were grown in a compositional range from Ga0.2In0.8P to pure GaP in particle-assisted mode by controlling the trimethylindium, trimethylgallium and hydrogen chloride flows in metal-organic vapor phase epitaxy. X-ray energy dispersive spectroscopy in transmission electron microscopy revealed homogeneous radial material composition in single nanowires, whereas variations in the material composition were found along the nanowires. High-resolution x-ray diffraction indicates a variation of the material composition on the order of about 19% measuring an entire sample area, i.e., including edge effects during growth. The non-capped nanowires emit room temperature photoluminescence strongly in the energy range of 1.43-2.16 eV, correlated with the bandgap expected from the material composition.
|
|
