| 1. |
- Jain, Vishal, 1989-, et al.
(författare)
-
A comparative study of nanowire based infrared p+-i-n+ photodetectors
- 2012
-
Konferensbidrag (refereegranskat)abstract
- We present a comparative study of electrical and optical properties of two types of p+-i-n+ photodetectors based on self-assembled ensembles of vertical InP nanowires (NWs) monolithically grown on InP. The detectors differ in the type of p+ contact, one detector geometry has p+-i-n+ segments integrated into the NWs (type A) while the other detector has i-n+ NW segments grown directly on a p+ substrate(type B). The samples were prepared by first depositing 80 nm Au nanoparticles on a p+ InP substrate using an aerosol technique and subsequently growing NWs using MOVPE. The NWs have a polytypecrystal structure of alternating wurtzite and zincblende segments. The processing of the detectors include deposition of SiO2, followed by an etching step to remove the oxide from the tip of the NWs, and finally sputtering of ITO on 1x1 mm2 device areas. The two most prominent differences between the detectors concern the current-voltage (I-V) characteristics and the spatial location of generated photocurrent. From spectrally resolved photocurrent measurements, we conclude that the photocurrent in detector type A is primarily generated in the NWs, whereas the photocurrent in type B detectors mainly stems from the substrate. Photogenerated carriers in the substrate diffuse to the NWs where they are effectively funnelled into the NWs. The I-V characteristics of the type A detector displays a non-trivial transport behaviour for forward biases, whereas type B shows excellent rectifying behavior with an ideality factor of about 2.5. We will discuss detailed analysis of the spectral fingerprints of the two detector types revealing the mixed crystal phase of the polytype NWs and bandstructure effects, temperature dependence of the I-V characteristics and typical photodetector parameters.
|
|
| 2. |
- Pettersson, Håkan, 1962-, et al.
(författare)
-
Electrical and optical properties of InP nanowire ensemble p(+)-i-n(+) photodetectors
- 2012
-
Ingår i: Nanotechnology. - Bristol, UK : Institute of Physics Publishing (IOPP). - 0957-4484 .- 1361-6528. ; 23:13
-
Tidskriftsartikel (refereegranskat)abstract
- We report on a comprehensive study of electrical and optical properties of efficient near-infrared p(+)-i-n(+) photodetectors based on large ensembles of self-assembled, vertically aligned i-n(+) InP nanowires monolithically grown on a common p(+) InP substrate without any buffer layer. The nanowires have a polytype modulated crystal structure of wurtzite and zinc blende. The electrical data display excellent rectifying behavior with an ideality factor of about 2.5 at 300 K. The ideality factor scales with 1/T, which possibly reflects deviations from classical transport models due to the mixed crystal phase of the nanowires. The observed dark leakage current is of the order of merely similar to 100 fA/nanowire at 1 V reverse bias. The detectors display a linear increase of the photocurrent with reverse bias up to about 10 pA/nanowire at 5 V. From spectrally resolved measurements, we conclude that the photocurrent is primarily generated by funneling photogenerated carriers from the substrate into the NWs. Contributions from direct excitation of the NWs become increasingly important at low temperatures. The photocurrent decreases with temperature with an activation energy of about 50 meV, which we discuss in terms of a temperature-dependent diffusion length in the substrate and perturbed transport through the mixed-phase nanowires. © 2012 IOP Publishing Ltd.
|
|
| 3. |
- Borschel, Christian, et al.
(författare)
-
A New Route toward Semiconductor Nanospintronics : Highly Mn-Doped GaAs Nanowires Realized by Ion-Implantation under Dynamic Annealing Conditions
- 2011
-
Ingår i: Nano letters (Print). - Washington : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 11:9, s. 3935-3940
-
Tidskriftsartikel (refereegranskat)abstract
- We report on highly Mn-doped GaAs nanowires (NWs) of high crystalline quality fabricated by ion beam implantation, a technique that allows doping concentrations beyond the equilibrium solubility limit. We studied two approaches for the preparation of Mn-doped GaAs NWs: First, ion implantation at room temperature with subsequent annealing resulted in polycrystalline NWs and phase segregation of MnAs and GaAs. The second approach was ion implantation at elevated temperatures. In this case, the single-crystallinity of the GaAs NWs was maintained, and crystalline, highly Mn-doped GaAs NWs were obtained. The electrical resistance of such NWs dropped with increasing temperature (activation energy about 70 meV). Corresponding magnetoresistance measurements showed a decrease at low temperatures, indicating paramagnetism. Our findings suggest possibilities for future applications where dense arrays of GaMnAs nanowires may be used as a new kind of magnetic material system.
|
|
| 4. |
|
|
| 5. |
- Jain, Vishal, 1989-, et al.
(författare)
-
Large area photodetectors based on InP NWs with InAs/InAsP QWs
- 2014
-
Konferensbidrag (refereegranskat)abstract
- Focal plane arrays have a widespread use in infrared imaging, which often rely on cryogenic cooling to curtail the dark current level necessary for a reasonable signal-to-noise ratio. Quantum well (QW) infrared photodetectors are uniform over large areas, but suffer from a severe drawback related to the selection rules for intersubband absorption. An interesting alternative is self-assembled III-V nanowires offering a key advantage owing to the enhanced absorption by optical resonance effects and strain relaxation.We present electrical and optical results from large ensembles of n+-i-n+ InP NWs, axially grown on InP substrates with InAs/InAsP QWs embedded within the i-segment, designed for both interband and intersubband detection. The NWs are contacted in a vertical geometry using 50 nm SiO2 as the insulating layer and ITO as the top contact. We first investigate the crystal quality of the InAsP QWs grown in 180 nm diameter NWs, using PL, CL and TEM. To achieve more abrupt InAs/InAsP QWs, we grow 130 nm diameter NWs and deplete the In present in the Au catalysts. The effect of n-doping on the device performance is studied by fabricating two different NW geometries, with and without an n+-segment grown before the nominal i-segment in the NW. In addition, the position of the QWs within the i-segment is varied to further scrutinize effects related to doping and crystal structure. Finally, we report spectrally resolved photocurrent results from the QWs in the near-infrared region and discuss about the further developments needed for intersubband detection.
|
|
| 6. |
- Jain, Vishal, et al.
(författare)
-
Study of photocurrent generation in InP nanowire-based p(+)-i-n(+) photodetectors
- 2014
-
Ingår i: Nano Reseach. - Beijing & Berlin/Heidelberg : Springer Science and Business Media LLC. - 1998-0124 .- 1998-0000. ; 7:4, s. 544-552
-
Tidskriftsartikel (refereegranskat)abstract
- We report on electrical and optical properties of p(+)-i-n(+)photodetectors/solar cells based on square millimeter arrays of InP nanowires (NWs) grown on InP substrates. The study includes a sample series where the p(+)-segment length was varied between 0 and 250 nm, as well as solar cells with 9.3% efficiency with similar design. The electrical data for all devices display clear rectifying behavior with an ideality factor between 1.8 and 2.5 at 300 K. From spectrally resolved photocurrent measurements, we conclude that the photocurrent generation process depends strongly on the p(+)-segment length. Without a p(+)-segment, photogenerated carriers funneled from the substrate into the NWs contribute strongly to the photocurrent. Adding a p(+)-segment decouples the substrate and shifts the depletion region, and collection of photogenerated carriers, to the NWs, in agreement with theoretical modeling. In optimized solar cells, clear spectral signatures of interband transitions in the zinc blende and wurtzite InP layers of the mixed-phase i-segments are observed. Complementary electroluminescence, transmission electron microscopy (TEM), as well as measurements of the dependence of the photocurrent on angle of incidence and polarization, support our interpretations.
|
|
