| 1. |
|
|
| 2. |
- Treu, A., et al.
(författare)
-
Durability and protection of timber structures in marine environments in Europe : An overview
- 2019
-
Ingår i: BioResources. - : North Carolina State University. - 1930-2126 .- 1930-2126. ; 14:4, s. 10161-10184
-
Tidskriftsartikel (refereegranskat)abstract
- Timber structures in marine applications are often exposed to severe degradation conditions caused by mechanical loads and wood-degrading organisms. This paper presents the use of timber in marine environments in Europe from a wood protection perspective. It discusses the use of wood in coastline protection and archeological marine wood, reviews the marine borer taxa in European waters, and gives an overview of potential solutions for protection of timber in marine environments. Information was compiled from the most relevant literature sources with an emphasis on new wood protection methods; the need for research and potential solutions are discussed. Traditionally, timber has been extensively utilized in a variety of marine applications. Although there is a strong need for developing new protection systems for timber in marine applications, the research in this field has been scarce for many years. New attempts to protect timber used in marine environments in Europe have mainly focused on wood modification and the use of mechanical barriers to prevent colonization of marine wood borers. The importance of understanding the mechanisms of settlement, migration, boring, and digestion of the degrading organisms is key for developing effective systems for protecting timber in marine environments
|
|
| 3. |
- Janssen, Tjbm, et al.
(författare)
-
Operation of graphene quantum Hall resistance standard in a cryogen-free table-top system
- 2015
-
Ingår i: 2D Materials. - : IOP Publishing. - 2053-1583. ; 2:3, s. 035015-
-
Tidskriftsartikel (refereegranskat)abstract
- Wedemonstrate quantum Hall resistance measurements with metrological accuracy in a small cryogen-free system operating at a temperature of around 3.8Kand magnetic fields below 5 T. Operating this system requires little experimental knowledge or laboratory infrastructure, thereby greatly advancing the proliferation of primary quantum standards for precision electrical metrology. This significant advance in technology has come about as a result of the unique properties of epitaxial graphene on SiC.
|
|
| 4. |
- Janssen, Tjbm, et al.
(författare)
-
Towards a cryogen-free table-top primary resistance standard
- 2016
-
Ingår i: 2016 Conference on Precision Electromagnetic Measurements (Cpem 2016). - : Institute of Electrical and Electronics Engineers Inc.. - 9781467391344
-
Konferensbidrag (refereegranskat)abstract
- We demonstrate quantum Hall resistance measurements with metrological accuracy in a small cryogen-free system operating at a temperature of around 3.8 K and magnetic fields below 5 T. We use this system to investigate the optimisation of graphene/SiC devices for maximum breakdown current. In addition we report the first characterisation of a cryogen-free cryogenic current comparator which enables entirely cryogen-free primary resistance metrology.
|
|
| 5. |
- Kohlmann, Johannes, et al.
(författare)
-
A quantum standard for sampled electrical measurements-Main goals and first results of the EMRP project Q-WAVE
- 2014
-
Ingår i: 29th Conference on Precision Electromagnetic Measurements, CPEM 2014. ; , s. 522-523
-
Konferensbidrag (refereegranskat)abstract
- Josephson voltage standards are well established for use at dc and low-frequency ac voltages. The increasing demand i) to provide traceability for arbitrary waveforms, ii) to extend the range of use to higher frequencies, and iii) to improve the accuracy is being addressed in the project Q-WAVE, which is jointly funded by the European Union and the participating countries within the European Metrology Research Programme (EMRP). Here, sampling measurements and procedures using binary-divided 1 V and 10 V arrays are investigated. In addition, a quantum-based analogue-to-digital converter for direct measurements of arbitrary waveforms is under development. It will contain several Josephson arrays in series biased by a pulse drive based on opto-electronics, in order to increase the output voltage.
|
|
| 6. |
- Loren, Niklas, et al.
(författare)
-
Phase separation induced by conformational ordering of gelatin in gelatin/maltodextrin mixtures
- 2001
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 34:2, s. 289-297
-
Tidskriftsartikel (refereegranskat)abstract
- Mixtures of gelatin and maltodextrin in aqueous solution have been quenched to temperatures at which they are initially miscible but where gelatin ordering is initiated. In many cases phase separation was observed to occur after a significant time delay, and the dependence of these delays on quench temperature and biopolymer concentration has been studied in detail using turbidity measurements and confocal laser scanning microscopy (CLSM). Furthermore, by observing the optical rotation (OR) and turbidity of the system simultaneously, the gelatin helix content and the time delay before the onset of phase separation were monitored concurrently. The observed delay times were found to correspond to the time taken for the development of a certain degree of gelatin ordering, which drives the separation process. A further consequence of gelatin ordering is the viscosifying of the solution and, at sufficient concentrations, the formation of a gel. Therefore, rheological measurements have been used in addition to turbidity measurements and CLSM in order to monitor further the structural development of the systems. A comparison of the data obtained from these techniques shows that while the development of a certain elasticity will trap the system morphology, this elasticity is not directly related to that found at the gel point. At low maltodextrin concentrations, where phase separation was not detected by turbidity, transmission electron microscopy (TEM) has been used to examine the microstructure on a smaller length scale.
|
|
| 7. |
- Sun, Vivian Z., et al.
(författare)
-
Overview and Results From the Mars 2020 Perseverance Rover's First Science Campaign on the Jezero Crater Floor
- 2023
-
Ingår i: Journal of Geophysical Research: Planets. - : John Wiley and Sons Inc. - 2169-9097 .- 2169-9100. ; 128:6
-
Tidskriftsartikel (refereegranskat)abstract
- The Mars 2020 Perseverance rover landed in Jezero crater on 18 February 2021. After a 100-sol period of commissioning and the Ingenuity Helicopter technology demonstration, Perseverance began its first science campaign to explore the enigmatic Jezero crater floor, whose igneous or sedimentary origins have been much debated in the scientific community. This paper describes the campaign plan developed to explore the crater floor's Máaz and Séítah formations and summarizes the results of the campaign between sols 100–379. By the end of the campaign, Perseverance had traversed more than 5 km, created seven abrasion patches, and sealed nine samples and a witness tube. Analysis of remote and proximity science observations show that the Máaz and Séítah formations are igneous in origin and composed of five and two geologic members, respectively. The Séítah formation represents the olivine-rich cumulate formed from differentiation of a slowly cooling melt or magma body, and the Máaz formation likely represents a separate series of lava flows emplaced after Séítah. The Máaz and Séítah rocks also preserve evidence of multiple episodes of aqueous alteration in secondary minerals like carbonate, Fe/Mg phyllosilicates, sulfates, and perchlorate, and surficial coatings. Post-emplacement processes tilted the rocks near the Máaz-Séítah contact and substantial erosion modified the crater floor rocks to their present-day expressions. Results from this crater floor campaign, including those obtained upon return of the collected samples, will help to build the geologic history of events that occurred in Jezero crater and provide time constraints on the formation of the Jezero delta.
|
|
| 8. |
- Williams, M.A.K., et al.
(författare)
-
Kinetics of droplet growth in gelatin/maltodextrin mixtures following thermal quenching
- 2001
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 0743-7463 .- 1520-5827. ; 17:11, s. 3412-3418
-
Tidskriftsartikel (refereegranskat)abstract
- Rates of droplet growth, following the thermal quenching of gelatin/maltodextrin mixtures into the incompatible region of the phase diagram, have been obtained from turbidity measurements. The results from experiments carried out at temperatures that prohibit the involvement of biopolymer conformational ordering and gelation are in good agreement with those obtained by similar studies of binary synthetic polymer systems and with theoretical predictions. For mixtures that would phase separate at temperatures above the gelatin ordering temperature (T0) but which are quenched directly to temperatures below this, droplet growth shows modified kinetics owing primarily to restrictions imposed by the viscosifying continuous phase. However, for a mixture that was initially observed to be miscible following quenches to temperatures below T0, it is proposed that biopolymer ordering induces phase separation, which was found to occur after significant delay periods.
|
|
