SwePub
Tyck till om SwePub Sök här!
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Yamanaka Koji) "

Sökning: WFRF:(Yamanaka Koji)

  • Resultat 1-6 av 6
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  •  
2.
  • Andersson, Christer, 1982, et al. (författare)
  • A packaged 86 W GaN transmitter with SiC varactor-based dynamic load modulation
  • 2013
  • Ingår i: 43rd European Microwave Conference, EuMC 2013 - Held as Part of the 16th European Microwave Week, EuMW 2013, Nuremberg, Germany, 7-10 October 2013. - 9782874870316 ; , s. 283-286
  • Konferensbidrag (refereegranskat)abstract
    • Output power scaling based on class-J dynamic load modulation (DLM) theory is used to design an unprecedentedly high power microwave transmitter with varactor-based DLM functionality. Matching networks are realized on high dielectric constant substrates in order to reduce the form factor. The fully matched DLM PA incorporates a 24-mm GaN HEMT powerbar and a stack of four SiC varactors, all fit into a CuW package (40 mm × 20 mm). Peak output power is reconfigurable by changing the drain voltage, while retaining the DLMeffect. Under pulsed conditions at 40 V the PA delivers a peak power of 86 W at 2.14 GHz. Efficiency enhancement by DLM is 10-15 percentage-units at 6 dB output power back-off (OPBO). Employing digital predistortion (DPD) with a vector switched generalized memory polynomial (VS-GMP) the ACLR is -46 dBc at an average output power of 17 W and a drain efficiency of 34%. These results prove the potential for high output power levels in varactor-based DLM transmitters.
  •  
3.
  • Andersson, Christer, 1982, et al. (författare)
  • Theory and Design of Class-J Power Amplifiers With Dynamic Load Modulation
  • 2012
  • Ingår i: IEEE Transactions on Microwave Theory and Techniques. - 0018-9480 .- 1557-9670. ; 60:12, s. 3778-3786
  • Tidskriftsartikel (refereegranskat)abstract
    • A theory for class-J microwave amplifier operation as a function of drive level and fundamental load impedance is derived. Calculations show that, under appropriate operating conditions, it is sufficient to modulate the transistor load reactance to enable high-efficiency operation (>70%) over a large output power dynamic range (>10 dB) with high transistor power utilization. Such dynamic load modulation (DLM) networks are an ideal application of continuously tunable varactor technologies. Multiharmonic load–pull measurements are performed on a GaN HEMT and experimentally verify the theory of operation. A demonstrator amplifier using an SiC varactor technology is then designed and characterized by static measurements. The amplifier has a peak power of 38 dBm at 2.08 GHz and maintains efficiencies above 45% over 8 dB of power dynamic range. An analysis of the load network losses is performed to show the potential of the class-J DLM transmitter concept.
  •  
4.
  • Angelov, Iltcho, 1943, et al. (författare)
  • On the large-signal modeling of High Power AlGaN/GaN HEMTs
  • 2012
  • Ingår i: IEEE MTT-S International Microwave Symposium Digest. - 0149-645X. - 9781467310871
  • Konferensbidrag (refereegranskat)abstract
    • In this paper are given some recent results on modeling of High Power GaN HEMT devices. The GaN HEMT is very promising for high power application, but we push device to the limits, so many issues are becoming critical. For example, access resistances Rs, Rd in high power GAN HEMT are bias and temperature dependent-their extraction from cold FET measurements can lead to over optimistic prediction for output power. Thermal management, self-heating modeling are another very important issue-they influence reliability, power and PAE. Models without dynamic self-heating are not practical for GaN. The models without breakdown can easily predict world records for PAE, output power/mm etc. Some examples are given using vectorial Large Signal Measurements (LSNA/NVNA) to provide useful, global info about device behavior, influence of traps, knee voltage walkout etc.
  •  
5.
  • Oishi, Toshiyuki, et al. (författare)
  • Semi-physical nonlinear model for HEMTs with simple equations
  • 2010
  • Ingår i: 2010 International Workshop on Integrated Nonlinear Microwave and Millimetre-Wave Circuits, INMMiC 2010; Goteborg; 26 April 2010 through 27 April 2010. - 9781424474127 ; , s. 20-23
  • Konferensbidrag (refereegranskat)abstract
    • A Nonlinear Circuit Model (NCM) combined with device/physical parameters was developed by using hyperbolic tangent (tanh) function and applied to GaN high electron mobility transistors (HEMTs). The equations for the NCM were constructed to reproduce the results of a device physical simulation. Model parameters are similar with the parameters used in the device design. The simulated DC and capacitance characteristics agree well with the measurement data over wide voltage range. Furthermore, numbers of the parameters were reduced to only 17 by using common physical parameters to both drain current and capacitance models. © 2010 IEEE.
  •  
6.
  • Otsuka, Hiroshi, et al. (författare)
  • Semi-physical nonlinear circuit model with device/physical parameters for HEMTs
  • 2011
  • Ingår i: International Journal of Microwave and Wireless Technologies. - 1759-0787 .- 1759-0795. ; 3:1, s. 25-33
  • Tidskriftsartikel (refereegranskat)abstract
    • A nonlinear circuit model (NCM) with physical parameters is proposed for direct simulation of the RF characteristics of GaN high-electron-mobility transistors (GaN HEMTs) on the basis of device structure. The physical equations are used for the construction of the model in order to connect strongly the model parameters with the device/physical parameters. Hyperbolic tangent functions are used as the model equations to ensure good model convergence and rapid simulation (short simulation time). The usefulness of these equations is confirmed by technology computer aided design (TCAD) simulation. The number of model parameters for the nonlinear components (Ids, Cgs, Cgd) is reduced to 17 by using common physical parameters for modeling the drain current and capacitance. The accuracy of this model is verified by applying to GaN HEMTs. The modeled I–V and capacitance characteristics agree well with the measurement data over a wide voltage range. Furthermore, this model can be used for the accurate evaluation of S-parameters and large-signal RF characteristics.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-6 av 6

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy