| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
-
- 2018
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 58:9
-
Tidskriftsartikel (refereegranskat)
|
|
| 5. |
- Angioni, C., et al.
(författare)
-
Dependence of the turbulent particle flux on hydrogen isotopes induced by collisionality
- 2018
-
Ingår i: Physics of Plasmas. - : American Institute of Physics (AIP). - 1070-664X .- 1089-7674 .- 1070-6631 .- 1089-7666. ; 25:8
-
Tidskriftsartikel (refereegranskat)abstract
- The impact of the change of the mass of hydrogen isotopes on the turbulent particle flux is studied. The trapped electron component of the turbulent particle convection induced by collisionality, which is outward in ion temperature gradient turbulence, increases with decreasing thermal velocity of the isotope. Thereby, the lighter is the isotope, the stronger is the turbulent pinch, and the larger is the predicted density gradient at the null of the particle flux. The passing particle component of the flux increases with decreasing mass of the isotope and can also affect the predicted density gradient. This effect is however subdominant for usual core plasma parameters. The analytical results are confirmed by means of both quasi-linear and nonlinear gyrokinetic simulations, and an estimate of the difference in local density gradient produced by this effect as a function of collisionality has been obtained for typical plasma parameters at mid-radius. Analysis of currently available experimental data from the JET and the ASDEX Upgrade tokamaks does not show any clear and general evidence of inconsistency with this theoretically predicted effect outside the errorbars and also allows the identification of cases providing weak evidence of qualitative consistency.
|
|
| 6. |
- Appel, L. C., et al.
(författare)
-
Equilibrium reconstruction in an iron core tokamak using a deterministic magnetisation model
- 2018
-
Ingår i: Computer Physics Communications. - : ELSEVIER. - 0010-4655 .- 1879-2944. ; 223, s. 1-17
-
Tidskriftsartikel (refereegranskat)abstract
- In many tokamaks ferromagnetic material, usually referred to as an iron-core, is present in order to improve the magnetic coupling between the solenoid and the plasma. The presence of the iron core in proximity to the plasma changes the magnetic topology with consequent effects on the magnetic field structure and the plasma boundary. This paper considers the problem of obtaining the free-boundary plasma equilibrium solution in the presence of ferromagnetic material based on measured constraints. The current approach employs, a model described by O'Brien et al. (1992) in which the magnetisation currents at the iron-air boundary are represented by a set of free parameters and appropriate boundary conditions are enforced via a set of quasi-measurements on the material boundary. This can lead to the possibility of overfitting the data and hiding underlying issues with the measured signals. Although the model typically achieves good fits to measured magnetic signals there are significant discrepancies in the inferred magnetic topology compared with other plasma diagnostic measurements that are independent of the magnetic field. An alternative approach for equilibrium reconstruction in iron-core tokamaks, termed the deterministic magnetisation model is developed and implemented in EFIT++. The iron is represented by a boundary current with the gradients in the magnetisation dipole state generating macroscopic internal magnetisation currents. A model for the boundary magnetisation currents at the iron-air interface is developed using B-Splines enabling continuity to arbitrary order; internal magnetisation currents are allocated to triangulated regions within the iron, and a method to enable adaptive refinement is implemented. The deterministic model has been validated by comparing it with a synthetic 2-D electromagnetic model of JET. It is established that the maximum field discrepancy is less than 1.5 mT throughout the vacuum region enclosing the plasma. The discrepancies of simulated magnetic probe signals are accurate to within 1% for signals with absolute magnitude greater than 100 mT; in all other cases agreement is to within 1 mT. The effect of neglecting the internal magnetisation currents increases the maximum discrepancy in the vacuum region to >20 mT, resulting in errors of 5%-10% in the simulated probe signals. The fact that the previous model neglects the internal magnetisation currents (and also has additional free parameters when fitting the measured data) makes it unsuitable for analysing data in the absence of plasma current. The discrepancy of the poloidal magnetic flux within the vacuum vessel is to within 0.1 Wb. Finally the deterministic model is applied to an equilibrium force-balance solution of a JET discharge using experimental data. It is shown that the discrepancies of the outboard separatrix position, and the outer strike-point position inferred from Thomson Scattering and Infrared camera data are much improved beyond the routine equilibrium reconstruction, whereas the discrepancy of the inner strike-point position is similar.
|
|
| 7. |
|
|
| 8. |
- Budny, R. V., et al.
(författare)
-
Alpha heating, isotopic mass, and fast ion effects in deuterium-tritium experiments
- 2018
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 58:9
-
Tidskriftsartikel (refereegranskat)abstract
- Alpha heating experiments in the Tokamak Fusion Test Reactor (TFTR) and in the Joint European Torus (JET) 1997 DTE1 campaign arc reexamined. In TFTR supershots central electron heating of both deuterium only and deuterium-tritium supershots was dominated by thermal ion-electron heat transfer rate p(ie). The higher T-e in deuterium-tritium supershots was mainly due to higher T-i largely caused by isotopic mass effects of neutral beam-thermal ion heating. The thermal ion-electron heating dominated the electron heating in the center. The ratio of the predicted alpha to total electron heating rates f(alp) is less than 0.30. Thus alpha heating (and possible favorable isotopic mass scaling of the thermal plasma) were too small to be measured reliably. The JET alpha heating Hot-Ion H-mode discharges had lower T-i/T-e, and thus had lower p(ie) and the deuterium-tritium DT discharges had higher f(alp), than in TFTR. There were not enough comparable discharges to verify alpha heating. The high performance phases consisted of rampup to brief flattop durations. At equal times during the rampup phase central T-e and T-i were linearly correlated with the thermal hydrogcnic isotopic mass < A >(hyd) which co-varied with beam ion pressure, the tritium fraction of neutral beam power, and the time delay to the first significant sawteeth which interrupted the T-e increases. For both devices the expected alpha healing rate and the null hypothesis of no alpha heating arc consistent with the measurements within the measurement and modeling uncertainties.
|
|
| 9. |
- Coiling, Bethany, et al.
(författare)
-
Testing of tritium breeder blanket activation foil spectrometer during JET operations
- 2018
-
Ingår i: Fusion engineering and design. - : Elsevier BV. - 0920-3796 .- 1873-7196. ; 136, s. 258-264
-
Tidskriftsartikel (refereegranskat)abstract
- Accurate measurement of the nuclear environment within a test tritium breeding-blanket module of a fusion reactor is crucial to determine tritium production rates which are relevant to self-sufficiency of tritium fuel supply, tritium accountancy and also to the evaluation of localised power levels produced in blankets. This requires evaluation of the time-dependent spectral neutron flux within the test tritium breeding-blanket module under harsh radiation and temperature environments. The application of an activation foil-based spectrometer system to determine neutron flux density using a pneumatic transfer system in ITER has been studied, deployed and tested on the Joint European Torus (JET) machine in a recent deuterium - deuterium campaign for a selection of high purity activation foils. Deployment of the spectrometer system has provided important functional and practical testing of the detector measurement system, associated hardware and post processing techniques for the analysis of large data sets produced through the use of list mode data collection. The testing is invaluable for the optimisation of systems for future planned testing in tritium - tritium and deuterium - tritium conditions. Analysis of the time and energy spectra collected to date and the status of the development of methods for post processing are presented in this paper.
|
|
| 10. |
- Guillemaut, C., et al.
(författare)
-
Experimental validation of an analytical kinetic model for edge-localized modes in JET-ITER-like wall
- 2018
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 58:6
-
Tidskriftsartikel (refereegranskat)abstract
- The design and operation of future fusion devices relying on H-mode plasmas requires reliable modelling of edge-localized modes (ELMs) for precise prediction of divertor target conditions. An extensive experimental validation of simple analytical predictions of the time evolution of target plasma loads during ELMs has been carried out here in more than 70 JET-ITER-like wall H-mode experiments with a wide range of conditions. Comparisons of these analytical predictions with diagnostic measurements of target ion flux density, power density, impact energy and electron temperature during ELMs are presented in this paper and show excellent agreement. The analytical predictions tested here are made with the 'free-streaming' kinetic model (FSM) which describes ELMs as a quasi-neutral plasma bunch expanding along the magnetic field lines into the Scrape-Off Layer without collisions. Consequences of the FSM on energy reflection and deposition on divertor targets during ELMs are also discussed.
|
|
