| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
|
|
| 4. |
- Falchetto, G. L., et al.
(författare)
-
The European Integrated Tokamak Modelling (ITM) effort: achievements and first physics results
- 2014
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 54:4
-
Tidskriftsartikel (refereegranskat)abstract
- A selection of achievements and first physics results are presented of the European Integrated Tokamak Modelling Task Force (EFDA ITM-TF) simulation framework, which aims to provide a standardized platform and an integrated modelling suite of validated numerical codes for the simulation and prediction of a complete plasma discharge of an arbitrary tokamak. The framework developed by the ITM-TF, based on a generic data structure including both simulated and experimental data, allows for the development of sophisticated integrated simulations (workflows) for physics application.The equilibrium reconstruction and linear magnetohydrodynamic (MHD) stability simulation chain was applied, in particular, to the analysis of the edgeMHDstability of ASDEX Upgrade type-I ELMy H-mode discharges and ITER hybrid scenario, demonstrating the stabilizing effect of an increased Shafranov shift on edge modes. Interpretive simulations of a JET hybrid discharge were performed with two electromagnetic turbulence codes within ITM infrastructure showing the signature of trapped-electron assisted ITG turbulence. A successful benchmark among five EC beam/ray-tracing codes was performed in the ITM framework for an ITER inductive scenario for different launching conditions from the equatorial and upper launcher, showing good agreement of the computed absorbed power and driven current. Selected achievements and scientific workflow applications targeting key modelling topics and physics problems are also presented, showing the current status of the ITM-TF modelling suite.
|
|
| 5. |
- Kochur, A.G., et al.
(författare)
-
Mn3s X-ray photoelectron spectra of polynuclear trimethylacetate complexes of manganese
- 2010
-
Ingår i: Bulletin of the Russian Academy of Sciences: Physics. - : Allerton Press. - 1062-8738. ; 74:5, s. 625-630
-
Tidskriftsartikel (refereegranskat)abstract
- The Mn3s X-ray photoelectron spectra of manganese atoms in mono-, bi-, tri-, and hexanuclear trimethylacetate Mn complexes and MnIICl 2, MnIIIOOH, MnIVO2. ionic compounds were measured. The 3s spectra of the manganese atoms in MnII, MnIII, and MnIV valent states were calculated within the isolatedion approximation. The relationship between the characteristics of the Mn3s spectra and the magnetic moments of the manganese ions in the complexes is discussed.
|
|
| 6. |
- Kochur, A. G., et al.
(författare)
-
X-ray photoelectron Fe3s and Fe3p spectra of polynuclear trimethylacetate iron complexes
- 2010
-
Ingår i: Journal of Electron Spectroscopy and Related Phenomena. - : Elsevier BV. - 0368-2048 .- 1873-2526. ; 180:1-3, s. 21-26
-
Tidskriftsartikel (refereegranskat)abstract
- X-ray photoelectron Fe3s and Fe3p spectra are employed to study the electron structure and the spin magnetic state of bi-, tri-, and hexa-nuclear trimethylacetate iron complexes. Assignment of the spectra is performed based on an isolated-ion Pauli-Fock calculation of Fe3s and Fe3p spectra of the Fe atoms in bi- and tri-valent states. Nonequivalent Fe(III) and Fe(II) atoms are detected in tri- and hexa-nuclear complexes. Paramagnetic-limit molecular magnetic moments are calculated using effective atomic magnetic moments obtained from spin-sensitive spectral characteristics. Comparison of those values with the magnetic measurements data demonstrates antiferromagnetic interaction within the complexes.
|
|
| 7. |
- Widdowson, A., et al.
(författare)
-
Removal of beryllium-containing films deposited in JET from mirror surfaces by laser cleaning
- 2011
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 415:1, s. S1199-S1202
-
Tidskriftsartikel (refereegranskat)abstract
- A set of stainless steel (SS) and molybdenum mirror samples located in the divertor and at the outer mid-plane of the vessel were exposed in JET from 2005 to 2007. A selection of these mirror samples with well adhered deposits (i.e. not flaking) of up to a few hundred nanometers in thickness and with Be/C ratios ranging from 0 to similar to 1 have been cleaned using a laser system developed at CEA, Saclay. Following laser cleaning the recovered reflectivity was generally better in the infrared than the visible spectrum, with recovery of up to 90% of the initial reflectivity being obtained at 1600 nm for both Mo and SS mirrors falling as low as 20-30% of initial reflectivity at a wavelength of 400 nm for some SS mirrors, rising to similar to 80% for Mo mirrors. Some deposit remained on the mirrors after the cleaning trials.
|
|
| 8. |
- Ivanova, T M, et al.
(författare)
-
X-ray photoelectron spectra of heterometallic 3d-metal carboxylate complexes
- 2011
-
Ingår i: Russian Journal of Inorganic Chemistry. - : Maik Nauka/Interperiodica. - 0036-0236 .- 1531-8613. ; 56:1, s. 104-109
-
Tidskriftsartikel (refereegranskat)abstract
- The electronic structure and magnetic states in the heterometallic hexanuclear complex Mn4II Fe2III (μ4-O)2(Piv)10 · MeCN4 have been studied by X-ray photoelectron spectroscopy (XPS). The substitution of two Mn atoms for two Fe atoms in the hexanuclear complex was found to have an effect on the patterns of iron and manganese X-ray photoelectron spectra. XPS data are evidence of the high-spin paramagnetic state of MnII and FeIII atoms, as well as of the ligand-metal charge transfer upon complex formation. In the heteroatomic complex, the degree of bond covalence increased for both the manganese and iron atoms. The results obtained are in good agreement with X-ray diffraction data.
|
|
| 9. |
- Kalupin, D., et al.
(författare)
-
Numerical analysis of JET discharges with the European Transport Simulator
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:12, s. article nr. 123007-
-
Tidskriftsartikel (refereegranskat)abstract
- The 'European Transport Simulator' (ETS) (Coster et al 2010 IEEE Trans. Plasma Sci. 38 2085-92, Kalupin et al 2011 Proc. 38th EPS Conf. on Plasma Physics (Strasbourg, France, 2011) vol 35G (ECA) P. 4.111) is the new modular package for 1D discharge evolution developed within the EFDA Integrated Tokamak Modelling (ITM) Task Force. It consists of precompiled physics modules combined into a workflow through standardized input/output data structures. Ultimately, the ETS will allow for an entire discharge simulation from the start up until the current termination phase, including controllers and sub-systems. The paper presents the current status of the ETS towards this ultimate goal. It discusses the design of the workflow, the validation and verification of its components on the example of impurity solver and demonstrates a proof-of-principles coupling of a local gyrofluid model for turbulent transport to the ETS. It also presents the first results on the application of the ETS to JET tokamak discharges with the ITER like wall. It studies the correlations of the radiation from impurity to the choice of the sources and transport coefficients.
|
|
| 10. |
- Kashubin, A., et al.
(författare)
-
A footprint of rainfall on land seismic data repeatability at the CO2 storage pilot site, Ketzin, Germany
- 2011
-
Annan publikation (övrigt vetenskapligt/konstnärligt)abstract
- Two vintages of land time-lapse seismic data were acquired in 2005 and in 2009 at the Ketzin CO2 storage site in Germany. The datasets showed some differences in frequency content, signal-to-noise ratio and refraction statics despite that they were acquired with the same equipment and during the same seasons. The spatial variations in the data appeared to show good correlation with the difference in precipitation during the campaigns. These observations provide a ground for estimation of spatially varying operators that may be used in pre-stack or post-stack cross-equalization corrections of the time-lapse datasets. © 2011 Society of Exploration Geophysicists.
|
|
