| 41. |
- White, Christopher J., et al.
(författare)
-
SLOW-SPEED SUPERNOVAE FROM THE PALOMAR TRANSIENT FACTORY : TWO CHANNELS
- 2015
-
Ingår i: Astrophysical Journal. - 0004-637X .- 1538-4357. ; 799:1
-
Tidskriftsartikel (refereegranskat)abstract
- Since the discovery of the unusual prototype SN 2002cx, the eponymous class of Type I (hydrogen-poor) supernovae with low ejecta speeds has grown to include approximately two dozen members identified from several heterogeneous surveys, in some cases ambiguously. Here we present the results of a systematic study of 1077 Type I supernovae discovered by the Palomar Transient Factory, leading to nine new members of this peculiar class. Moreover, we find there are two distinct subclasses based on their spectroscopic, photometric, and host galaxy properties: SN 2002cx-like supernovae tend to be in later-type or more irregular hosts, have more varied and generally dimmer luminosities, have longer rise times, and lack a Ti II trough when compared to SN 2002es-like supernovae. None of our objects show helium, and we counter a previous claim of two such events. We also find that the occurrence rate of these transients relative to Type Ia supernovae is 5.6(-3.8)(+22) % (90% confidence), lower compared to earlier estimates. Combining our objects with the literature sample, we propose that these subclasses have two distinct physical origins.
|
|
| 42. |
- Wu, Xiongyu, et al.
(författare)
-
Synthesis and identification of metabolite biomarkers of 25C-NBOMe and 25I-NBOMe
- 2017
-
Ingår i: Tetrahedron. - : PERGAMON-ELSEVIER SCIENCE LTD. - 0040-4020 .- 1464-5416. ; 73:45, s. 6393-6400
-
Tidskriftsartikel (refereegranskat)abstract
- Synthetic routes have been developed for synthesis of potential metabolites of 25C-NBOMe and 25I-NBOMe. Nine potential metabolites have been synthesized, among which compounds 8 and 20a could be used as metabolite biomarkers of 25C-NBOMe and 20b of 25I-NBOMe in urinary detection at forensic laboratories to prove intake. (C) 2017 Elsevier Ltd. All rights reserved.
|
|
| 43. |
- Ödén, Jakob, et al.
(författare)
-
Technical Note : On the calculation of stopping-power ratio for stoichiometric calibration in proton therapy
- 2015
-
Ingår i: Medical physics (Lancaster). - : Wiley. - 0094-2405 .- 2473-4209. ; 42:9, s. 5252-5257
-
Tidskriftsartikel (refereegranskat)abstract
- Purpose: The quantitative effects of assumptions made in the calculation of stopping-power ratios (SPRs) are investigated, for stoichiometric CT calibration in proton therapy. The assumptions investigated include the use of the Bethe formula without correction terms, Bragg additivity, the choice of I-value for water, and the data source for elemental I-values. Methods: The predictions of the Bethe formula for SPR (no correction terms) were validated against more sophisticated calculations using the SRIM software package for 72 human tissues. A stoichiometric calibration was then performed at our hospital. SPR was calculated for the human tissues using either the assumption of simple Bragg additivity or the Seltzer-Berger rule (as used in ICRU Reports 37 and 49). In each case, the calculation was performed twice: First, by assuming the I-value of water was an experimentally based value of 78 eV (value proposed in Errata and Addenda for ICRU Report 73) and second, by recalculating the I-value theoretically. The discrepancy between predictions using ICRU elemental I-values and the commonly used tables of Janni was also investigated. Results: Errors due to neglecting the correction terms to the Bethe formula were calculated at less than 0.1% for biological tissues. Discrepancies greater than 1%, however, were estimated due to departures from simple Bragg additivity when a fixed I-value for water was imposed. When the I-value for water was calculated in a consistent manner to that for tissue, this disagreement was substantially reduced. The difference between SPR predictions when using Janni's or ICRU tables for I-values was up to 1.6%. Experimental data used for materials of relevance to proton therapy suggest that the ICRU-derived values provide somewhat more accurate results (root-mean-square-error: 0.8% versus 1.6%). Conclusions: The conclusions from this study are that (1) the Bethe formula can be safely used for SPR calculations without correction terms; (2) simple Bragg additivity can be reasonably assumed for compound materials; (3) if simple Bragg additivity is assumed, then the I-value for water should be calculated in a consistent manner to that of the tissue of interest (rather than using an experimentally derived value); (4) the ICRU Report 37 I-values may provide a better agreement with experiment than Janni's tables.
|
|
