| 1. |
-
- 2018
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 58:1
-
Forskningsöversikt (refereegranskat)
|
|
| 2. |
- Bombarda, F., et al.
(författare)
-
Runaway electron beam control
- 2019
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP Publishing. - 1361-6587 .- 0741-3335. ; 61:1
-
Tidskriftsartikel (refereegranskat)
|
|
| 3. |
-
- 2018
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 58:9
-
Tidskriftsartikel (refereegranskat)
|
|
| 4. |
- Meyer, H.F., et al.
(författare)
-
Overview of physics studies on ASDEX Upgrade
- 2019
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 59:11
-
Forskningsöversikt (refereegranskat)abstract
- The ASDEX Upgrade (AUG) programme, jointly run with the EUROfusion MST1 task force, continues to significantly enhance the physics base of ITER and DEMO. Here, the full tungsten wall is a key asset for extrapolating to future devices. The high overall heating power, flexible heating mix and comprehensive diagnostic set allows studies ranging from mimicking the scrape-off-layer and divertor conditions of ITER and DEMO at high density to fully non-inductive operation (q 95 = 5.5, ) at low density. Higher installed electron cyclotron resonance heating power 6 MW, new diagnostics and improved analysis techniques have further enhanced the capabilities of AUG. Stable high-density H-modes with MW m-1 with fully detached strike-points have been demonstrated. The ballooning instability close to the separatrix has been identified as a potential cause leading to the H-mode density limit and is also found to play an important role for the access to small edge-localized modes (ELMs). Density limit disruptions have been successfully avoided using a path-oriented approach to disruption handling and progress has been made in understanding the dissipation and avoidance of runaway electron beams. ELM suppression with resonant magnetic perturbations is now routinely achieved reaching transiently . This gives new insight into the field penetration physics, in particular with respect to plasma flows. Modelling agrees well with plasma response measurements and a helically localised ballooning structure observed prior to the ELM is evidence for the changed edge stability due to the magnetic perturbations. The impact of 3D perturbations on heat load patterns and fast-ion losses have been further elaborated. Progress has also been made in understanding the ELM cycle itself. Here, new fast measurements of and E r allow for inter ELM transport analysis confirming that E r is dominated by the diamagnetic term even for fast timescales. New analysis techniques allow detailed comparison of the ELM crash and are in good agreement with nonlinear MHD modelling. The observation of accelerated ions during the ELM crash can be seen as evidence for the reconnection during the ELM. As type-I ELMs (even mitigated) are likely not a viable operational regime in DEMO studies of 'natural' no ELM regimes have been extended. Stable I-modes up to have been characterised using -feedback. Core physics has been advanced by more detailed characterisation of the turbulence with new measurements such as the eddy tilt angle - measured for the first time - or the cross-phase angle of and fluctuations. These new data put strong constraints on gyro-kinetic turbulence modelling. In addition, carefully executed studies in different main species (H, D and He) and with different heating mixes highlight the importance of the collisional energy exchange for interpreting energy confinement. A new regime with a hollow profile now gives access to regimes mimicking aspects of burning plasma conditions and lead to nonlinear interactions of energetic particle modes despite the sub-Alfvénic beam energy. This will help to validate the fast-ion codes for predicting ITER and DEMO.
|
|
| 5. |
- Meyer, H., et al.
(författare)
-
Overview of progress in European medium sized tokamaks towards an integrated plasma-edge/wall solution
- 2017
-
Ingår i: Nuclear Fusion. - : Institute of Physics Publishing (IOPP). - 0029-5515 .- 1741-4326. ; 57:10
-
Tidskriftsartikel (refereegranskat)abstract
- Integrating the plasma core performance with an edge and scrape-off layer (SOL) that leads to tolerable heat and particle loads on the wall is a major challenge. The new European medium size tokamak task force (EU-MST) coordinates research on ASDEX Upgrade (AUG), MAST and TCV. This multi-machine approach within EU-MST, covering a wide parameter range, is instrumental to progress in the field, as ITER and DEMO core/pedestal and SOL parameters are not achievable simultaneously in present day devices. A two prong approach is adopted. On the one hand, scenarios with tolerable transient heat and particle loads, including active edge localised mode (ELM) control are developed. On the other hand, divertor solutions including advanced magnetic configurations are studied. Considerable progress has been made on both approaches, in particular in the fields of: ELM control with resonant magnetic perturbations (RMP), small ELM regimes, detachment onset and control, as well as filamentary scrape-off-layer transport. For example full ELM suppression has now been achieved on AUG at low collisionality with n = 2 RMP maintaining good confinement H-H(98,H-y2) approximate to 0.95. Advances have been made with respect to detachment onset and control. Studies in advanced divertor configurations (Snowflake, Super-X and X-point target divertor) shed new light on SOL physics. Cross field filamentary transport has been characterised in a wide parameter regime on AUG, MAST and TCV progressing the theoretical and experimental understanding crucial for predicting first wall loads in ITER and DEMO. Conditions in the SOL also play a crucial role for ELM stability and access to small ELM regimes.
|
|
| 6. |
- Meyer, H., et al.
(författare)
-
Overview of progress in European medium sized tokamaks towards an integrated plasma-edge/wall solution
- 2017
-
Ingår i: Nuclear Fusion. - : Institute of Physics Publishing (IOPP). - 0029-5515 .- 1741-4326. ; 57:10
-
Tidskriftsartikel (refereegranskat)abstract
- Integrating the plasma core performance with an edge and scrape-off layer (SOL) that leads to tolerable heat and particle loads on the wall is a major challenge. The new European medium size tokamak task force (EU-MST) coordinates research on ASDEX Upgrade (AUG), MAST and TCV. This multi-machine approach within EU-MST, covering a wide parameter range, is instrumental to progress in the field, as ITER and DEMO core/pedestal and SOL parameters are not achievable simultaneously in present day devices. A two prong approach is adopted. On the one hand, scenarios with tolerable transient heat and particle loads, including active edge localised mode (ELM) control are developed. On the other hand, divertor solutions including advanced magnetic configurations are studied. Considerable progress has been made on both approaches, in particular in the fields of: ELM control with resonant magnetic perturbations (RMP), small ELM regimes, detachment onset and control, as well as filamentary scrape-off-layer transport. For example full ELM suppression has now been achieved on AUG at low collisionality with n = 2 RMP maintaining good confinement H-H(98,H-y2) approximate to 0.95. Advances have been made with respect to detachment onset and control. Studies in advanced divertor configurations (Snowflake, Super-X and X-point target divertor) shed new light on SOL physics. Cross field filamentary transport has been characterised in a wide parameter regime on AUG, MAST and TCV progressing the theoretical and experimental understanding crucial for predicting first wall loads in ITER and DEMO. Conditions in the SOL also play a crucial role for ELM stability and access to small ELM regimes.
|
|
| 7. |
- Ackerman, I. N., et al.
(författare)
-
Lifetime Risk of Primary Total Hip Replacement Surgery for Osteoarthritis From 2003 to 2013: A Multinational Analysis Using National Registry Data
- 2017
-
Ingår i: Arthritis Care Res (Hoboken). - : Wiley. - 2151-464X. ; 69:11, s. 1659-1667
-
Tidskriftsartikel (refereegranskat)abstract
- OBJECTIVE: To compare the lifetime risk of total hip replacement (THR) surgery for osteoarthritis (OA) between countries, and over time. METHODS: Data on primary THR procedures performed for OA in 2003 and 2013 were extracted from national arthroplasty registries in Australia, Denmark, Finland, Norway, and Sweden. Life tables and population data were also obtained for each country. Lifetime risk of THR was calculated for 2003 and 2013 using registry, life table, and population data. RESULTS: In 2003, lifetime risk of THR ranged from 8.7% (Denmark) to 15.9% (Norway) for females, and from 6.3% (Denmark) to 8.6% (Finland) for males. With the exception of females in Norway (where lifetime risk started and remained high), lifetime risk of THR increased significantly for both sexes in all countries from 2003 to 2013. In 2013, lifetime risk of THR was as high as 1 in 7 women in Norway, and 1 in 10 men in Finland. Females consistently demonstrated the highest lifetime risk of THR at both time points. Notably, lifetime risk for females in Norway was approximately double the risk for males in 2003 (females 15.9% [95% confidence interval (95% CI) 15.6-16.1], males 6.9% [95% CI 6.7-7.1]), and 2013 (females 16.0% [95% CI 15.8-16.3], males 8.3% [95% CI 8.1-8.5]). CONCLUSION: Using representative, population-based data, this study found statistically significant increases in the lifetime risk of THR in 5 countries over a 10-year period, and substantial between-sex differences. These multinational risk estimates can inform resource planning for OA service delivery.
|
|
| 8. |
- Bülow, E., et al.
(författare)
-
Low predictive power of comorbidity indices identified for mortality after acute arthroplasty surgery undertaken for femoral neck fracture
- 2019
-
Ingår i: Bone and Joint Journal. - 2049-4394. ; 101B:1, s. 104-112
-
Tidskriftsartikel (refereegranskat)abstract
- Aims Our aim was to examine the Elixhauser and Charlson comorbidity indices, based on administrative data available before surgery, and to establish their predictive value for mortality for patients who underwent hip arthroplasty in the management of a femoral neck fracture. Patients and Methods We analyzed data from 42 354 patients from the Swedish Hip Arthroplasty Register between 2005 and 2012. Only the first operated hip was included for patients with bilateral arthroplasty. We obtained comorbidity data by linkage from the Swedish National Patient Register, as well as death dates from the national population register. We used univariable Cox regression models to predict mortality based on the comorbidity indices, as well as multivariable regression with age and gender. Predictive power was evaluated by a concordance index, ranging from 0.5 to 1 (with the higher value being the better predictive power). A concordance index less than 0.7 was considered poor. We used bootstrapping for internal validation of the results. Results The predictive power of mortality was poor for both the Elixhauser and Charlson comorbidity indices (concordance indices less than 0.7). The Charlson Comorbidity Index was superior to Elixhauser, and a model with age and gender was superior to both indices. Conclusion Preoperative comorbidity from administrative data did not predict mortality for patients with a hip fracture treated by arthroplasty. This was true even if association on group level existed.
|
|
| 9. |
- Fawsitt, C. G., et al.
(författare)
-
Choice of Prosthetic Implant Combinations in Total Hip Replacement: Cost-Effectiveness Analysis Using UK and Swedish Hip Joint Registries Data
- 2019
-
Ingår i: Value in Health. - : Elsevier BV. - 1098-3015. ; 22:3, s. 303-312
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Prosthetic implants used in total hip replacements (THR) have a range of bearing surface combinations (metal-onpolyethylene, ceramic-on-polyethylene, ceramic-on-ceramic, and metal-on-metal), head sizes (small [<36 mm in diameter] and large [>= 36 mm in diameter]), and fixation techniques (cemented, uncemented, hybrid, and reverse hybrid). These can influence prosthesis survival, patients' quality of life, and healthcare costs. Objectives: To compare the lifetime cost-effectiveness of implants for patients of different age and sex profiles. Methods: We developed a Markov model to compare the cost-effectiveness of various implants against small-head cemented metal-on-polyethylene implants. The probability that patients required 1 or more revision surgeries was estimated from analyses of more than 1 million patients in the UK and Swedish hip joint registries, for men and women younger than 55, 55 to 64, 65 to 74, 75 to 84, and 85 years and older. Implant and healthcare costs were estimated from local procurement prices, national tariffs, and the literature. Quality-adjusted life-years were calculated using published utility estimates for patients undergoing THR in the United Kingdom. Results: Small-head cemented metal-on-polyethylene implants were the most cost-effective for men and women older than 65 years. These findings were robust to sensitivity analyses. Small-head cemented ceramic-on-polyethylene implants were most cost-effective in men and women younger than 65 years, but these results were more uncertain. Conclusions: The older the patient group, the more likely that the cheapest implants, small-head cemented metal-on-polyethylene implants, were cost-effective. We found no evidence that uncemented, hybrid, or reverse hybrid implants were the most cost-effective option for any patient group. Our findings can influence clinical practice and procurement decisions for healthcare payers worldwide.
|
|
| 10. |
- Greene, Meridith E, et al.
(författare)
-
Improved statistical analysis of pre- and post-treatment patient-reported outcome measures (PROMs): the applicability of piecewise linear regression splines
- 2015
-
Ingår i: Quality of life research : an international journal of quality of life aspects of treatment, care and rehabilitation. - : Springer Science and Business Media LLC. - 1573-2649. ; 24:3, s. 567-573
-
Tidskriftsartikel (refereegranskat)abstract
- Patient-reported health-related quality-of-life (HRQoL) measures such as the EuroQol 5 dimension (EQ-5D) index are commonplace when assessing healthcare providers or efficiency of medical techniques. HRQoL measures are generally bounded, and the magnitude of possible improvement depends on the pre-treatment HRQoL value. This paper aimed to assess and illustrated the possibility of modelling the relationship between pre- and post-treatment HRQoL measures with piecewise linear splines.
|
|
