| 1. |
|
|
| 2. |
|
|
| 3. |
- Bannan, T. J., et al.
(författare)
-
A method for extracting calibrated volatility information from the FIGAERO-HR-ToF-CIMS and its experimental application
- 2019
-
Ingår i: Atmospheric Measurement Techniques. - : Copernicus GmbH. - 1867-1381 .- 1867-8548. ; 12:3, s. 1429-1439
-
Tidskriftsartikel (refereegranskat)abstract
- The Filter Inlet for Gases and AEROsols (FIGAERO) is an inlet specifically designed to be coupled with the Aerodyne High-Resolution Time-of-Flight Chemical Ionization Mass Spectrometer (HR-ToF-CIMS). The FIGAERO-HR-ToF-CIMS provides simultaneous molecular information relating to both the gas- and particle-phase samples and has been used to extract vapour pressures (VPs) of the compounds desorbing from the filter whilst giving quantitative concentrations in the particle phase. However, such extraction of vapour pressures of the measured particle-phase components requires use of appropriate, well-defined, reference compounds. Vapour pressures for the homologous series of polyethylene glycols (PEG) ((H-(O-CH 2 CH 2 ) n -OH) for n = 3 to n = 8), covering a range of vapour pressures (VP) (10 -1 to 10 -7 Pa) that are atmospherically relevant, have been shown to be reproduced well by a range of different techniques, including Knudsen Effusion Mass Spectrometry (KEMS). This is the first homologous series of compounds for which a number of vapour pressure measurement techniques have been found to be in agreement, indicating the utility as a calibration standard, providing an ideal set of benchmark compounds for accurate characterization of the FIGAERO for extracting vapour pressure of measured compounds in chambers and the real atmosphere. To demonstrate this, single-component and mixture vapour pressure measurements are made using two FIGAERO-HR-ToF-CIMS instruments based on a new calibration determined from the PEG series. VP values extracted from both instruments agree well with those measured by KEMS and reported values from literature, validating this approach for extracting VP data from the FIGAERO. This method is then applied to chamber measurements, and the vapour pressures of known products are estimated. © 2019 Author(s).
|
|
| 4. |
|
|
| 5. |
- Le Breton, Michael, 1986, et al.
(författare)
-
Application of a FIGAERO ToF CIMS for on-line characterization of real-world fresh and aged particle emissions from buses
- 2019
-
Ingår i: Aerosol Science and Technology. - : Informa UK Limited. - 0278-6826 .- 1521-7388. ; 53:3, s. 244-259
-
Tidskriftsartikel (refereegranskat)abstract
- © 2019, © 2019 The Author(s). Published with license by Taylor & Francis Group, LLC. On-line chemical characterization of real-world particle emissions from 13 transit buses was performed using a chemical ionization mass spectrometer (CIMS) equipped with a filter inlet for gases and aerosols (FIGAERO). In addition to the fresh emissions the emissions were artificially aged using a potential aerosol mass reactor (Go:PAM). The buses studied were running on different fuel types (diesel, compressed natural gas, and rapeseed methyl ester) and exhaust after-treatment systems (selective catalytic reduction (SCR), exhaust gas recirculation (EGR), and a three-way catalyst). When evaluating emissions from passing exhaust plumes using the FIGAERO ToF-CIMS, two technical features were highlighted from this work, the use of high mass calibrants and the factor enhancement method to be able to filter important compounds from mass spectra including hundreds of species. Here, acetate was used as the reagent ion to enable detection of highly oxygenated species in the exhaust particle emissions with potential high toxicity and/or secondary organic aerosol formation (SOA) potential. The acetate ionization scheme accounted for 4% to 46% of the total emitted particulate mass through identification of 61 species in the spectra. For aged emission the various fuel types provided overlapping species that could explain up to 19% of the aged emissions. This is hypothesized to come from the oxidation of engine lubrication oil, thus a common source for various fuels which was further supported by laboratory measurements. Specific markers from the SCR technology, such as urea oxidation products and further byproducts from hydrolysis were identified and attributed to reactions of isocyanic acid.
|
|
| 6. |
- Le Breton, Michael, 1986, et al.
(författare)
-
Chlorine oxidation of VOCs at a semi-rural site in Beijing: significant chlorine liberation from ClNO2 and subsequent gas- and particle-phase Cl-VOC production
- 2018
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7316 .- 1680-7324. ; 18:17, s. 13013-13030:18, s. 13013-13030
-
Tidskriftsartikel (refereegranskat)abstract
- Nitryl chloride (ClNO2) accumulation at night acts as a significant reservoir for active chlorine and impacts the following day's photochemistry when the chlorine atom is liberated at sunrise. Here, we report simultaneous measurements of N2O5 and a suite of inorganic halogens including ClNO2 and reactions of chloride with volatile organic compounds (Cl-VOCs) in the gas and particle phases utilising the Filter Inlet for Gas and AEROsols time-of-flight chemical ionisation mass spectrometer (FIGAERO-ToF-CIMS) during an intensive measurement campaign 40 km northwest of Beijing in May and June 2016. A maximum mixing ratio of 2900 ppt of ClNO2 was observed with a mean campaign nighttime mixing ratio of 487 ppt, appearing to have an anthropogenic source supported by correlation with SO2, CO and benzene, which often persisted at high levels after sunrise until midday. This was attributed to such high mixing ratios persisting after numerous e-folding times of the photolytic lifetime enabling the chlorine atom production to reach 2.3 x 10(5) molecules cm(-3) from ClNO2 alone, peaking at 09:30 LT and up to 8.4 x 10(5) molecules cm(-3) when including the supporting inorganic halogen measurements. Cl-VOCs were observed in the particle and gas phases for the first time at high time resolution and illustrate how the iodide ToF-CIMS can detect unique markers of chlorine atom chemistry in ambient air from both biogenic and anthropogenic sources. Their presence and abundance can be explained via time series of their measured and steady-state calculated precursors, enabling the assessment of competing OH and chlorine atom oxidation via measurements of products from both of these mechanisms and their relative contribution to secondary organic aerosol (SOA) formation.
|
|
| 7. |
- Li, J. J., et al.
(författare)
-
Characterization of Aerosol Aging Potentials at Suburban Sites in Northern and Southern China Utilizing a Potential Aerosol Mass (Go:PAM) Reactor and an Aerosol Mass Spectrometer
- 2019
-
Ingår i: Journal of Geophysical Research-Atmospheres. - : American Geophysical Union (AGU). - 2169-897X .- 2169-8996. ; 124:10, s. 5629-5649
-
Tidskriftsartikel (refereegranskat)abstract
- Aerosol mass spectrometry was used to characterize submicron aerosols before and after aging in a Gothenburg Potential Aerosol Mass (Go:PAM) reactor at two suburban sites in China, one in northern China at Changping (CP), Beijing, and a second in southern China at Hong Kong (HK). Organic aerosol (OA) dominated in the ambient nonrefractory particulate matter <1m (NR-PM1) for both CP (42-71%) and HK (43-61%), with a large contribution from secondary OA factors that were semivolatile oxygenated (SVOOA) and low-volatility oxygenated (LVOOA). Under constant OH exposure, OA enhancement (78-98%) dominated the NR-PM1 mass increment at both sites, while nitrate was enhanced the most among the inorganic species (7-9%). Overall, the CP site exhibited higher OA oxidation potential and more enhancement of SVOOA than LVOOA (7.5 vs. 2.7g/m(3)), but the reverse was observed in HK (0.8 vs. 2.6g/m(3)). In CP, more enhancement of the less oxygenated SVOOA suggests that aerosol aging was more sensitive to the abundant locally emitted primary OA and volatile organic compound precursors. On the contrary, the more formation of the highly oxidized LVOOA in HK indicates that aerosol aging mainly escalated the degree of oxygenation of OA as ambient aerosol was already quite aged and there was a lack of volatile organic compound precursors. The comparative measurements using the same oxidation system reveal distinct key factors and mechanisms that influence secondary aerosol formation in two suburban locations in China, providing scientific insights to assist formulation of location-specific mitigation measures of secondary pollution. Plain Language Summary Atmospheric submicron particles have significant impacts on the climate and human health. A large part of these particles are formed secondarily through successive aging of primary emissions. To study such aging processes, we used a reactor that can provide highly oxidizing conditions to simulate the oxidation of ambient aerosols at accelerated rates. An online mass spectrometer was connected after the reactor to measure changes in aerosol mass concentration and chemical composition between the ambient samples and the oxidized ones. We presented the first comparative measurements of the aging potentials of ambient aerosols in two suburban sites in northern and southern China (Changping District in Beijing, and Hong Kong). Results showed that generally aerosols at the Changping site had higher aging potentials after passing through the oxidation reactor, probably due to more local emissions of precursors, while air masses in Hong Kong were already in a higher oxidation state with lower aging potentials, mainly because of strong impacts from long-range transported pollution sources. Distinct aerosol aging pathways related to different ambient precursors were observed at the two sites. Understanding of the different characteristics of aerosol aging processes can lead to advances in air quality modeling and pollution management.
|
|
| 8. |
- Mohr, Claudia, et al.
(författare)
-
Molecular identification of organic vapors driving atmospheric nanoparticle growth
- 2019
-
Ingår i: Nature communications. - : Springer Science and Business Media LLC. - 2041-1723. ; 10
-
Tidskriftsartikel (refereegranskat)abstract
- Particles formed in the atmosphere via nucleation provide about half the number of atmospheric cloud condensation nuclei, but in many locations, this process is limited by the growth of the newly formed particles. That growth is often via condensation of organic vapors. Identification of these vapors and their sources is thus fundamental for simulating changes to aerosol-cloud interactions, which are one of the most uncertain aspects of anthropogenic climate forcing. Here we present direct molecular-level observations of a distribution of organic vapors in a forested environment that can explain simultaneously observed atmospheric nanoparticle growth from 3 to 50nm. Furthermore, the volatility distribution of these vapors is sufficient to explain nanoparticle growth without invoking particle-phase processes. The agreement between observed mass growth, and the growth predicted from the observed mass of condensing vapors in a forested environment thus represents an important step forward in the characterization of atmospheric particle growth.
|
|
| 9. |
- Halldin Stenlid, Joakim, 1987-
(författare)
-
Computational Studies of Chemical Interactions: Molecules, Surfaces and Copper Corrosion
- 2017
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The chemical bond – a corner stone in science and a prerequisite for life – is the focus of this thesis. Fundamental and applied aspects of chemical bonding are covered including the development of new computational methods for the characterization and rationalization of chemical interactions. The thesis also covers the study of corrosion of copper-based materials. The latter is motivated by the proposed use of copper as encapsulating material for spent nuclear fuel in Sweden.In close collaboration with experimental groups, state-of-the-art computational methods were employed for the study of chemistry at the atomic scale. First, oxidation of nanoparticulate copper was examined in anoxic aqueous media in order to better understand the copper-water thermodynamics in relation to the corrosion of copper material under oxygen free conditions. With a similar ambition, the water-cuprite interface was investigated with regards to its chemical composition and reactivity. This was compared to the behavior of methanol and hydrogen sulfide at the cuprite surface.An overall ambition during the development of computational methods for the analysis of chemical bonding was to bridge the gap between molecular and materials chemistry. Theory and results are thus presented and applied in both a molecular and a solid-state framework. A new property, the local electron attachment energy, for the characterization of a compound’s local electrophilicity was introduced. Together with the surface electrostatic potential, the new property predicts and rationalizes regioselectivity and trends of molecular reactions, and interactions on metal and oxide nanoparticles and extended surfaces.Detailed atomistic understanding of chemical processes is a prerequisite for the efficient development of chemistry. We therefore envisage that the results of this thesis will find widespread use in areas such as heterogeneous catalysis, drug discovery, and nanotechnology.
|
|
| 10. |
- Hedlund, Artur, et al.
(författare)
-
Microstructures of cellulose coagulated in water and alcohols from 1-ethyl-3-methylimidazolium acetate : contrasting coagulation mechanisms
- 2019
-
Ingår i: Cellulose. - : Springer Science and Business Media LLC. - 0969-0239 .- 1572-882X. ; 26:3, s. 1545-1563
-
Tidskriftsartikel (refereegranskat)abstract
- Abstract: Coagulation of cellulose solutions is a process whereby many useful materials with variable microstructures and properties can be produced. This study investigates the complexity of the phase separation that generates the structural heterogeneity of such materials. The ionic liquid, 1-ethyl-3-methylimidazolium acetate ([C2mim][OAc]), and a co-solvent, dimethylsulfoxide (DMSO), are used to dissolve microcrystalline cellulose in concentrations from 5 to 25 wt%. The solutions are coagulated in water or 2-propanol (2PrOH). The coagulated material is then washed and solvent exchanged (water → 2PrOH → butanone → cyclohexane) in order to preserve the generated microstructures upon subsequent drying before analysis. Sweep electron microscopy images of 50 k magnification reveal open-pore fibrillar structures. The crystalline constituents of those fibrils are estimated using wide-angle X-ray spectroscopy and specific surface area data. It is found that the crystalline order or crystallite size is reduced by an increase in cellulose concentration, by the use of the co-solvent DMSO, or by the use of 2PrOH instead of water as the coagulant. Because previous theories cannot explain these trends, an alternative explanation is presented here focused on solid–liquid versus liquid–liquid phase separations. Graphical abstract: [Figure not available: see fulltext.].
|
|
