Sökning: onr:"swepub:oai:DiVA.org:hh-6202" >
On finishing of pre...
-
Berglund, Johan C,1978Sandvik Tooling, R & D Center Olofström, Sweden,Chalmers tekniska högskola,Chalmers University of Technology
(författare)
On finishing of pressing die surfaces using machine hammer peening
- Artikel/kapitelEngelska2011
Förlag, utgivningsår, omfång ...
-
2010-05-23
-
Berlin :Springer Berlin/Heidelberg,2011
-
printrdacarrier
Nummerbeteckningar
-
LIBRIS-ID:oai:DiVA.org:hh-6202
-
https://urn.kb.se/resolve?urn=urn:nbn:se:hh:diva-6202URI
-
https://doi.org/10.1007/s00170-010-2725-0DOI
-
https://research.chalmers.se/publication/128403URI
Kompletterande språkuppgifter
-
Språk:engelska
-
Sammanfattning på:engelska
Ingår i deldatabas
Klassifikation
-
Ämneskategori:ref swepub-contenttype
-
Ämneskategori:art swepub-publicationtype
Anmärkningar
-
Machine hammer peening (MHP) is a new method for finishing of surfaces. With this method, the workpiece surface is hammered with a spherical carbide tool. The main objective of the study was to evaluate whether the MHP method could become a plausible substitute for manual polishing in pressing die manufacturing where nodular cast iron is a common workpiece material. To do this, sample nodular cast iron surfaces were hammered and evaluated. Changes to the surfaces were evaluated using surface roughness measurements, hardness measurements and optical images. First of all, the workpiece surface was smoothened. Secondly, the surface hardness was increased significantly. Thirdly, the nodules on the workpiece surface were affected. They appeared to be smaller and not as visible. This effect would likely create a die surface less prone to galling since the cavities would not be filled with sheet metal to the same extent in a forming operation. In addition, with MHP, the amount of polishing needed to manufacture a die surface can be reduced because of the smoothening effect.
Ämnesord och genrebeteckningar
Biuppslag (personer, institutioner, konferenser, titlar ...)
-
Liljengren, MagnusOlofström School of Automotive Stamping, Olofström, Sweden,Chalmers tekniska högskola,Chalmers University of Technology
(författare)
-
Rosén, Bengt-GöranHögskolan i Halmstad,Maskinteknisk produktframtagning (MTEK),Chalmers tekniska högskola,Chalmers University of Technology(Swepub:cth)brosen
(författare)
-
Sandvik Tooling, R & D Center Olofström, SwedenChalmers tekniska högskola
(creator_code:org_t)
Sammanhörande titlar
-
Ingår i:The International Journal of Advanced Manufacturing TechnologyBerlin : Springer Berlin/Heidelberg52:1-4, s. 115-1210268-37681433-3015
Internetlänk
Hitta via bibliotek
Till lärosätets databas