Sökning: onr:"swepub:oai:DiVA.org:hj-36849" >
Characterization an...
Characterization and modeling of the mechanical behavior of high silicon ductile iron
-
- Kasvayee, Keivan Amiri, 1986- (författare)
- Jönköping University,JTH, Material och tillverkning,JTH. Forskningsmiljö Material och tillverkning – Gjutning
-
- Ghassemali, Ehsan, 1983- (författare)
- Jönköping University,JTH. Forskningsmiljö Material och tillverkning – Gjutning,JTH, Material och tillverkning
-
- Svensson, Ingvar L. (författare)
- Jönköping University,JTH, Material och tillverkning,JTH. Forskningsmiljö Material och tillverkning – Gjutning
-
visa fler...
-
- Olofsson, Jakob, 1980- (författare)
- Jönköping University,JTH, Material och tillverkning,JTH. Forskningsmiljö Material och tillverkning – Gjutning
-
- Jarfors, Anders E.W. 1963- (författare)
- Jönköping University,JTH. Forskningsmiljö Material och tillverkning – Gjutning,JTH, Material och tillverkning
-
visa färre...
-
(creator_code:org_t)
- Elsevier, 2017
- 2017
- Engelska.
-
Ingår i: Materials Science & Engineering. - : Elsevier. - 0921-5093 .- 1873-4936. ; 708, s. 159-170
- Relaterad länk:
-
https://hj.diva-port... (primary) (Raw object)
-
visa fler...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- This paper investigates the effect of the solidification conditions and silicon content on the mechanical properties of ductile iron and presents empirical models for predicting the tensile behavior based on the microstructural characterizations. Two ductile iron grades of GJS-500-7 and GJS-500-14 were cast with silicon content of 2.36% and 3.71%, respectively. The cast geometry consisted of six plates with different thicknesses that provided different cooling rates during the solidification. Microstructure analysis, tensile and hardness tests were performed on the as-cast material. Tensile behavior was characterized by the Ludwigson equation. The tensile fracture surfaces were analyzed to quantify the fraction of porosity. The results showed that graphite content, graphite nodule count, ferrite fraction and yield strength were increased by increasing the silicon content. A higher silicon content resulted in lower work hardening exponent and strength coefficient on the Ludwigson equation. The results for 0.2% offset yield and the Ludwigson equation parameters were modeled based on microstructural characteristics, with influence of silicon content as the main contributing factor. The models were implemented into a casting process simulation to enable prediction of microstructure-based tensile behavior. A good agreement was obtained between measured and simulated tensile behavior, validating the predictions of simulation in cast components with similar microstructural characteristics.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik -- Metallurgi och metalliska material (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering -- Metallurgy and Metallic Materials (hsv//eng)
Nyckelord
- Casting simulation Component casting Ludwigson equation parameters Silicon content Spherical graphite iron
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas