Sökning: onr:"swepub:oai:DiVA.org:hj-48749" >
Effect of Process P...
Effect of Process Parameters on Distortion and Residual Stress in High-Pressure Die Cast AZ91D Components After Clean Blasting and Painting
-
- Dini, Hoda, 1984- (författare)
- Jönköping University,JTH, Material och tillverkning,Husqvarna, AB Drottninggatan 2, Huskvarna, 561 82, Sweden
-
- Andersson, Nils-Eric (författare)
- Jönköping University,JTH, Material och tillverkning
-
- Jarfors, Anders E.W. 1963- (författare)
- Jönköping University,JTH, Material och tillverkning
-
(creator_code:org_t)
- Springer, 2021
- 2021
- Engelska.
-
Ingår i: International Journal of metalcasting. - : Springer. - 1939-5981 .- 2163-3193. ; 15:1, s. 241-258
- Relaterad länk:
-
https://doi.org/10.1...
-
visa fler...
-
https://link.springe...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- A high-pressure die-casting process was employed to produce AZ91D components. These cast components were exposed to three different post-treatments: (1) clean blasting, (2) clean blasting and painting, and (3) painting (without clean blasting). The influence of the process parameters first phase injection speed, temperature of fixed half of the die, cooling time, and intensification pressure on distortion and residual stress of the components after each post-treatment were investigated. The results showed that intensification pressure was the most significant factor among the four parameters.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
Nyckelord
- Component casting
- Distortion
- High pressure die casting
- Magnesium
- Residual stress
- Blasting
- Die casting
- Residual stresses
- Cast components
- Cooling time
- Exposed to
- High pressure die casts
- Injection speed
- Post treatment
- Process parameters
- High pressure effects
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas