Sökning: onr:"swepub:oai:DiVA.org:kth-6042" >
Control of HCCI Dur...
Control of HCCI During Engine Transients by aid of Variable Valve Timings Through the use of Model Based Non-Linear Compensation
-
- Agrell, Fredrik (författare)
- KTH,Maskinkonstruktion (Avd.)
-
- Ångström, Hans-Erik (författare)
- KTH,Maskinkonstruktion (Avd.)
-
Eriksson, Bengt (författare)
-
visa fler...
-
- Wikander, Jan (författare)
- KTH,Maskinkonstruktion (Avd.)
-
- Linderyd, Johan (författare)
- KTH,Maskinkonstruktion (Avd.)
-
visa färre...
-
KTH Maskinkonstruktion (Avd) (creator_code:org_t)
- 2005-04-11
- 2005
- Engelska.
-
Ingår i: SAE transactions. - 400 Commonwealth Drive, Warrendale, PA, United States : SAE International. - 0096-736X. ; 114:3, s. 296-310
- Relaterad länk:
-
https://urn.kb.se/re...
-
visa fler...
-
https://doi.org/10.4...
-
visa färre...
Abstract
Ämnesord
Stäng
- One of the main challenges with the Homogeneous Charge Compression Ignition, HCCI, combustion system is to control the Start Of Combustion, SOC, for varying load and external conditions. A method to achieve this on a cycle-by-cycle basis is to vary the valve timing based on a feedback signal from the SOC of previous cycles. The control can be achieved with two basic valve-timing strategies named the Overlap- and the IVC-method. The Overlap-method works by trapping of residuals while the IVC-method affects the effective compression ratio. In an earlier paper it has been shown that if the two methods are incorporated into one controller, SOC can be controlled in a relatively large operating window although the transient performance was not sufficient. The reason is that the simple PI-controller cannot be made fast enough to cope with the transients without magnifying the cycle-to-cycle variations of the combustion into instability. In this work a model based control system that features a non-linear compensation, based on the inverse of the non-linear function from valve timings to ignition delay, is suggested and evaluated. The results show good transient performance. Control performance from engine tests is reported. A combined engine and control simulation system is used for the development of the control strategies. The simulations are accomplished with a commercial cycle simulation code linked with a commercial control simulation code. The simulations are iteratively verified against engine test data. Engine tests are conducted on a single cylinder engine equipped with a hydraulic valve system.
Nyckelord
- TECHNOLOGY
- TEKNIKVETENSKAP
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas