Spectral analysis in laser powder bed fusion

• This thesis is about the investigation of the spectral interaction of electromagnetic radiation with metal powders. For this purpose, spectral data of powders for laser powder bed fusion processes are investigated in three papers using different techniques. In paper A the spectral radiation behavior of the laser interaction zone is considered, in paper B and C the absorbance behavior of different metal powders depending on their state and measurement method.  Paper A investigates the spectral signal of the process light generated by laser material interaction in laser powder bed fusion. The detection is performed by a coaxially guided measuring beam and a quasi-coaxial measuring beam simultaneously guided by another scanning optics. The signal characteristics depend on the angle of incidence of the measuring beam to the laser material interaction zone. Using high-speed recordings and optical simulations, a model for describing the signal behavior could be determined. The measured spectral intensity distribution representing the degree for energy coupling can be corrected with a correction factor over the whole field for solid materials. This correction includes a function describing the numerical aperture of the measuring channel and the laser intensity on the working field. For the investigated powder, the measurement signal fluctuated strongly and no transferable model could be formed. The reason for this was the different absorbance behavior of the powders investigated. Paper B therefore deals in detail with the spectral absorbance behavior of metal powders for additive manufacturing. Using a high-precision spectrometer, 39 powders were measured reflectively over a wide spectral range and the absorbance determined. By varying the degree of use, aging, grain size and impurities, various influence parameters are determined experimentally and discussed theoretically. Based on 20 derived laser wavelengths, technically usable wavelengths with better process efficiency and stability are proposed. From the obtained absorbance, the efficiency of energy coupling can be estimated and form a broad data base for the optimization of laser parameters. In order to perform the absorbance determinations also in situ in a laser powder bed fusion system paper C describes a possibility of an inline absorbance determination by high resolution coaxial imaging. A method is discussed for geometrically correct and gapless imaging of the processing plane, recorded through the laser optics. By imaging at six different wavelengths, metal powders can be distinguished by their absorbance spectrum and impurities can be detected. In an experimental implementation the functionality of the method is proven. The results are validated by optical simulations, ray tracing and comparative measurements with a high-precision spectrometer.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Materialteknik -- Bearbetnings-, yt- och fogningsteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Materials Engineering -- Manufacturing, Surface and Joining Technology (hsv//eng)

Nyckelord

Spectral monitoring

Laser powder bed fusion

Laser optics

Absorbance

Produktionsutveckling

Manufacturing Systems Engineering

Publikations- och innehållstyp

vet (ämneskategori)

lic (ämneskategori)