LC Refining Intensity In The Light Of Forces On Fibres

• The aim of this investigation was to find new approaches to evaluate the performance of a full sized two-zoned low-consistency refiner i.e. a refiner with two stators and one rotor in between. Data from a paper mill producing TMP from Norway spruce was used in order to find a possible way to calculate the power split between the two zones. An assumption of equal amount of fibres captured between overlapping bars was found successful in order to develop equations for the power split. The equations predicted equal power in both zones at equal disc gaps. The power was found to correlate approximately linearly with the disc gap. The power split was essential to know for calculating refining intensity expressed as specific edge load and forces on fibres in the two zones. The reduction in fibre length was about 5% at 0.17 mm disc gap corresponding to 0.03 N force on fibres and 0.7 J/m specific edge load. Disc gap, force on fibres and specific edge load was found to predict the fibre shortening with approximately equal sufficiency upon changes in power and flow rate through the refiner.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Kemiteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Chemical Engineering (hsv//eng)

Nyckelord

Low consistency

Two-zoned refiners

Fibre length

Refining intensity

Disc gap

Specific edge load

Forces on fibres

Thermomechanical pulping

Publikations- och innehållstyp

ref (ämneskategori)

kon (ämneskategori)