Sökning: onr:"swepub:oai:DiVA.org:oru-55655" >
Die materials, hard...
Die materials, hardening methods and surface coatings for forming of high, extra high and ultra high strength steel sheets (HSS/EHSS/UHSS)
-
- Liljengren, Magnus (författare)
- Olofström School of Automotive Stamping, Olofström, Sweden
-
- Kjellson, Kenneth (författare)
- Volvo Cars Body Components, Olofström, Sweden
-
- Johansson, Tuve (författare)
- Volvo Cars Body Components, Olofström, Sweden
-
visa fler...
-
- Asnafi, Nader, 1960- (författare)
- Volvo Cars Body Components, Olofström, Sweden
-
visa färre...
-
(creator_code:org_t)
- Inst. de Engenharia Mecânica e Gestão Industrial, 2006
- 2006
- Engelska.
-
Ingår i: Drawing the Things to Come: Trends and Advances in Sheet Metal Forming. - : Inst. de Engenharia Mecânica e Gestão Industrial. - 9789728953065 ; , s. 597-604
- Relaterad länk:
-
https://urn.kb.se/re...
Abstract
Ämnesord
Stäng
- During the past years, large efforts have been made at Volvo Cars to establish a scientific and systematic approach to selection of die materials, hardening methods and surface treatments/coatings. These efforts were initiated, since both new higher strength sheet materials and new die materials with better performance were introduced. Both these higher strength sheet materials and higher performance die materials needed to be industrialized. Volvo cars transferred to a so-called Dry Presshop several years ago. This means that only the rust protection oil applied by the material supplier to the sheet prior to delivery is allowed as the stamping lubricant. No additional lubricant can be accepted. This transfer is done with regard to environmental improvement and a lean production philosophy. "Trouble-shooting" (reduction of abrasive and adhesive die wear) by using additional lubrication is therefore not possible anymore.In this investigation 1.20 and 1.95 mm thick uncoated and hot-dip galvanized sheets of DP600, DP800 and DP1000 were tested. The wear behaviour of the die materials Sverker 21 (D2), Calmax, Sleipner, Weartec, Vanadis 6 and Vancron 40 were studied. Uncoated, plasma-nitrided, PVD-coated (CrN and TiAlN) versions of dies made in the above-mentioned materials were tested.The tests were carried out both in laboratory in a U-bend test equipment and in real stamping production. Based on the results obtained in laboratory and production tests, guidelines were established for selection of die materials and surface treatments in stamping of DP600, DP800 and DP1000. These guidelines are described in the present paper.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
Nyckelord
- Stamping
- Tool
- Die
- Wear
- DP600
- DP800
- DP1000
- D2
- Calmax
- Sleipner
- Weartec
- Vanadis 6
- Vancron 40
Publikations- och innehållstyp
- vet (ämneskategori)
- kon (ämneskategori)
Hitta via bibliotek
Till lärosätets databas