Sökning: onr:"swepub:oai:DiVA.org:uu-298806" >
Manufacturing and c...
Manufacturing and characterization of a ceramic single-use microvalve
-
- Khaji, Zahra (författare)
- Uppsala universitet,Mikrosystemteknik
-
- Klintberg, Lena (författare)
- Uppsala universitet,Mikrosystemteknik
-
- Thornell, Greger, 1969- (författare)
- Uppsala universitet,Ångström Space Technology Centre (ÅSTC)
-
(creator_code:org_t)
- 2016-06-30
- 2016
- Engelska.
-
Ingår i: Journal of Micromechanics and Microengineering. - : IOP Publishing. - 0960-1317 .- 1361-6439. ; 26:9
- Relaterad länk:
-
https://uu.diva-port... (primary) (Raw object)
-
visa fler...
-
http://uu.diva-porta...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- We present the manufacturing and characterization of a ceramic single-use microvalve withthe potential to be integrated in lab-on-a-chip devices, and forsee its utilization in space andother demanding applications. A 3 mm diameter membrane was used as the flow barrier, andthe opening mechanism was based on cracking the membrane by inducing thermal stresses onit with fast and localized resistive heating.Four manufacturing schemes based on high-temperature co-fired ceramic technology werestudied. Three designs for the integrated heaters and two thicknesses of 40 and 120 μmfor the membranes were considered, and the heat distribution over their membranes, therequired heating energies, their opening mode, and the flows admitted through were compared.Furthermore, the effect of applying +1 and −1 bar pressure difference on the membraneduring cracking was investigated. Thick membranes demonstrated unpromising results forlow-pressure applications since the heating either resulted in microcracks or cracking of thewhole chip. Because of the higher pressure tolerance of the thick membranes, the designwith microcracks can be considered for high-pressure applications where flow is facilitatedanyway. Thin membranes, on the other hand, showed different opening sizes depending onheater design and, consequently, heat distribution over the membranes, from microcracks toholes with sizes of 3–100% of the membrane area. For all the designs, applying +1 bar overpressure contributed to bigger openings, whereas −1 bar pressure difference only did so forone of the designs, resulting in smaller openings for the other two. The energy required forbreaking these membranes was a few hundred mJ with no significant dependence on designand applied pressure. The maximum sustainable pressure of the valve for the current designand thin membranes was 7 bar.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
Nyckelord
- single-use valve
- HTCC
- alumina
- platinum
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas