Sökning: onr:"swepub:oai:DiVA.org:uu-97829" >
A metallic micropum...
A metallic micropump for high-pressure microfluidics
-
- Bodén, Roger (författare)
- Uppsala universitet,Mikrosystemteknik
-
- Hjort, Klas (författare)
- Uppsala universitet,Mikrosystemteknik
-
- Schweitz, Jan-Åke (författare)
- Uppsala universitet,Mikrosystemteknik
-
visa fler...
-
- Simu, Urban (författare)
- Uppsala universitet,Mikrosystemteknik
-
visa färre...
-
(creator_code:org_t)
- 2008-09-26
- 2008
- Engelska.
-
Ingår i: Journal of Micromechanics and Microengineering. - : IOP Publishing. - 0960-1317 .- 1361-6439. ; 18:11, s. 115009-
- Relaterad länk:
-
https://urn.kb.se/re...
-
visa fler...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- This paper presents one of the strongest mechanical sub-cm(3) sized micropumps for microfluidics. It consists of two active valves and one pumping chamber, each operated by a paraffin actuator that is driven by a low-voltage square pulse waveform. The pump is fabricated in a simple process using parylene-coated stainless steel stencils, paraffin and copper clad polyimide. When driving the pump at 0.07 Hz and 2.0 V (0.8 W) per actuator, it pumped water without leakage at a flow rate of 0.75 mu L min(-1) up to above 50 bar (5 MPa) back-pressure. The frequency dependence was evaluated and a maximum flow rate of 1 mu L min(-1) at 0.21 Hz and 1.8 V was observed. A thermomechanical FEM analysis, which was in good agreement with experiments at low frequencies, predicts the behaviour at higher frequencies.
Nyckelord
- TECHNOLOGY
- TEKNIKVETENSKAP
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas