SwePub
Sök i LIBRIS databas

  Utökad sökning

onr:"swepub:oai:gup.ub.gu.se/258963"
 

Sökning: onr:"swepub:oai:gup.ub.gu.se/258963" > Polyacrylonitrile g...

Polyacrylonitrile gel polymer electrolyte based dye sensitized solar cells for a prototype solar panel

Arof, A. K. (författare)
University of Malaya
Noor, I. M. (författare)
University of Malaya
Buraidah, M. H. (författare)
University of Malaya
visa fler...
Bandara, T M W J, 1968 (författare)
University of Colombo
Careem, M. A. (författare)
University of Malaya,University of Peradeniya
Albinsson, Ingvar, 1962 (författare)
Gothenburg University,Göteborgs universitet,Institutionen för fysik (GU),Department of Physics (GU),University of Gothenburg
Mellander, Bengt-Erik, 1949 (författare)
Chalmers tekniska högskola,Chalmers University of Technology
visa färre...
 (creator_code:org_t)
Elsevier BV, 2017
2017
Engelska.
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686. ; 251, s. 223-234
  • Tidskriftsartikel (refereegranskat)
Abstract Ämnesord
Stäng  
  • Polyacrylonitrile (PAN) based gel polymer electrolytes (GPE) were prepared using lithium iodide (LiI), 1-butyl-3-methylimidazolium iodide (BMII) and tetrapropyl ammonium iodide (TPAI). The LiI mass fraction in the electrolyte was varied while keeping the masses of other components constant in order to enhance the solar cell performance. The addition of 4.61 wt.% LiI in the GPE increased the electrolyte room temperature ionic conductivity from (2.32 ± 0.02) to (3.91 ± 0.04) mS cm−1. The increase in conductivity with the addition of LiI salts was attributed to the increase in diffusion coefficient, mobility and number density of charge carriers as determined from Nyquist plot fitting. The incorporation of LiI salts in PAN-based GPE has enhanced the efficiency of the DSSC as expected. The best cell performance was obtained with an electrolyte containing 4.61 wt.% LiI sandwiched between a single mesoporous layer of TiO2 soaked in N3 dye sensitizer and a platinum counter electrode, which showed a power conversion efficiency (PCE) of (5.4 ± 0.1) % with a short circuit current density (Jsc) of (21.0 ± 1.1) mA cm−2, an open circuit voltage (Voc) of (0.48 ± 0.02) V and a fill factor (FF) of (53.4 ± 0.9) %. The DSSCs with 4.61 wt.% of LiI have been used to fabricate prototype solar panels for operating small devices. The panels were assembled using a number of cells, each having an area of 2 cm × 2 cm, connected in series and parallel. The panel, consisting of a set of eight cells in series which was connected in parallel with another set of eight cells in series, produces an average power conversion efficiency of (3.7 ± 0.2)% with a maximum output power of (17.1 ± 0.9) mW. © 2017 Elsevier Ltd

Ämnesord

NATURVETENSKAP  -- Fysik (hsv//swe)
NATURAL SCIENCES  -- Physical Sciences (hsv//eng)
TEKNIK OCH TEKNOLOGIER  -- Kemiteknik -- Annan kemiteknik (hsv//swe)
ENGINEERING AND TECHNOLOGY  -- Chemical Engineering -- Other Chemical Engineering (hsv//eng)

Nyckelord

Density of charge carriers
Dye-sensitized solar cell
Ion mobility
Lithium iodide
Solar panel
Ammonium iodide
Charge carriers
Conversion efficiency
Efficiency
Electrolytes
Open circuit voltage
Polyelectrolytes
Polymer solar cells
Salts
Solar cell arrays
Solar cells
Solar concentrators
Density of charges
Gel polymer electrolytes
Platinum counter electrodes
Polyacrylonitrile (PAN)
Power conversion efficiencies
Solar panels
Dye-sensitized solar cells
Density of charge carriers

Publikations- och innehållstyp

ref (ämneskategori)
art (ämneskategori)

Hitta via bibliotek

Till lärosätets databas

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy