Sökning: onr:"swepub:oai:lup.lub.lu.se:05d45412-ff66-4c02-b54c-38eb7260ee8b" >
A Positive Feedback...
A Positive Feedback Passive Mixer-First Receiver Front-End
-
- Nejdel, Anders (författare)
- Lund University,Lunds universitet,Institutionen för elektro- och informationsteknik,Institutioner vid LTH,Lunds Tekniska Högskola,Department of Electrical and Information Technology,Departments at LTH,Faculty of Engineering, LTH
-
- Abdulaziz, Mohammed (författare)
- Lund University,Lunds universitet,Institutionen för elektro- och informationsteknik,Institutioner vid LTH,Lunds Tekniska Högskola,Department of Electrical and Information Technology,Departments at LTH,Faculty of Engineering, LTH
-
- Törmänen, Markus (författare)
- Lund University,Lunds universitet,Institutionen för elektro- och informationsteknik,Institutioner vid LTH,Lunds Tekniska Högskola,Department of Electrical and Information Technology,Departments at LTH,Faculty of Engineering, LTH
-
visa fler...
-
- Sjöland, Henrik (författare)
- Lund University,Lunds universitet,Institutionen för elektro- och informationsteknik,Institutioner vid LTH,Lunds Tekniska Högskola,Department of Electrical and Information Technology,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- 2015
- 2015
- Engelska.
-
Ingår i: 2015 IEEE Radio Frequency Integrated Circuits Symposium (RFIC). ; , s. 79-82
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://lup.lub.lu.s...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- This paper presents a technique to reduce the noise figure of a passive mixer-first receiver front-end. By using lower than 50Ω switch resistance in the current-mode passive mixer and introducing a positive feedback from baseband to the RF-input, it can be well matched close to fLO while achieving a noise figure below 3dB, which is otherwise a fundamental limit. A quadrature front-end prototype for a direct conversion receiver has been implemented in 65nm CMOS, occupying an active area of 0.23mm2 with a frequency operation ranging from 0.7 to 3.8GHz. The prototype achieves a minimum noise figure of 2.5dB, an out-of-band 1dB compression point of +3dBm, with IIP3 and IIP2 exceeding +26 and +65dBm, respectively. The current consumption from a 1.2V supply is between 22.8 and 62.8mA, depending on frequency operation.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Elektroteknik och elektronik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Electrical Engineering, Electronic Engineering, Information Engineering (hsv//eng)
Publikations- och innehållstyp
- kon (ämneskategori)
- ref (ämneskategori)