Sökning: onr:"swepub:oai:research.chalmers.se:3f95c005-8c7e-4e2d-972b-16c37011ebd4" >
Fracture Characteri...
Fracture Characteristics of Austempered Spheroidal Graphite Aluminum Cast Irons
-
- Zandira, Masoud, 1983 (författare)
- Chalmers tekniska högskola,Chalmers University of Technology
-
- Boutorabi, S. M. A. (författare)
- Iran University of Science and Technology
-
(creator_code:org_t)
- 2010
- 2010
- Engelska.
-
Ingår i: Journal of Iron and Steel Research International. - 1006-706X. ; 17:2, s. 31-35
- Relaterad länk:
-
https://doi.org/10.1...
-
visa fler...
-
https://research.cha...
-
visa färre...
Abstract
Ämnesord
Stäng
- The fracture characteristics of austempered spheroidal graphite aluminum cast iron had been investigated. The chemical content of the alloy was C3.2, Al2.2, Ni0.8 and Mg0.05 (in mass percent, %). Impact test samples were produced from keel blocks cast in CO2 molding process. The oversized impact samples were austenitized at 850 and 950 degrees C for 2 h followed by austempering at 300 and 400 degrees C for 30, 60, 120 and 180 min. The austempered samples were machined and tested at room temperature. The impact strength values for those samples austempered at 400 degrees C varied between 90 and 110J. Lower bainitic structures showed impact strength values of 22 to 50J. The fractures of the samples were examined using SEM. The results showed that the upper bainitic fracture revealed a honey Comb-like topography, which confirmed the ductile fracture behavior. The lower bainitic fractures of those samples austempered for short times revealed brittle fracture.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
Nyckelord
- DUCTILE IRON
- TOUGHNESS
- fracture characteristic
- MICROSTRUCTURE
- austempering
- aluminum cast iron
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas