Sökning: onr:"swepub:oai:research.chalmers.se:59018e26-2fcb-4be5-8561-3d5f04acef2d" >
Model Describing Ma...
Model Describing Material-Dependent Deformation Behavior in High-Velocity Metal Forming Processes
-
- Hallberg, Håkan (författare)
- Lund University,Lunds universitet,Hållfasthetslära,Institutionen för byggvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Solid Mechanics,Department of Construction Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Ryttberg, Kristina, 1977 (författare)
- Chalmers tekniska högskola,Chalmers University of Technology
-
- Ristinmaa, Matti (författare)
- Lund University,Lunds universitet,Hållfasthetslära,Institutionen för byggvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Solid Mechanics,Department of Construction Sciences,Departments at LTH,Faculty of Engineering, LTH
-
(creator_code:org_t)
- 2009
- 2009
- Engelska.
-
Ingår i: Journal of Engineering Mechanics - ASCE. - 1943-7889 .- 0733-9399. ; 135:4, s. 345-357
- Relaterad länk:
-
https://portal.resea... (primary) (free)
-
visa fler...
-
http://dx.doi.org/10...
-
https://research.cha...
-
https://doi.org/10.1...
-
https://lup.lub.lu.s...
-
visa färre...
Abstract
Ämnesord
Stäng
- A constitutive model for rate-dependent and thermomechanically coupled plasticity at finite strains is presented. The plasticity model is based on a J(2) model and rate-dependent behavior is included by use of a Perzyna-type formulation. Adiabatic heating effects are handled in a consistent way and not, as is a common assumption, through a constant conversion of the internal work rate into rate of heating. The conversion factor is instead derived from thermodynamic considerations. The stored energy is assumed to be a function of a single internal variable which differs from the effective plastic strain. This allows a thermodynamically consistent formulation to be obtained which, as shown, can be calibrated by use of simple procedures. Choosing 100Cr6 steel in two differently heat treated conditions as prototype material, experimental tests are performed, enabling the model to be calibrated. Significant differences in deformation behavior are noted as the differently heat treated specimens are compared. In addition, the local stress-updating procedure is reduced to a single scalar equation, permitting a very efficient numerical implementation of the model. The constitutive formulation proposed was employed in an explicit finite element solver, illustrative simulations of a high-velocity metal forming process being performed to demonstrate the capabilities of the model and certain characteristic traits of the materials that were studied.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
- NATURVETENSKAP -- Fysik -- Astronomi, astrofysik och kosmologi (hsv//swe)
- NATURAL SCIENCES -- Physical Sciences -- Astronomy, Astrophysics and Cosmology (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering (hsv//eng)
Nyckelord
- high-strain rates
- temperature
- stored energy
- heat
- plastic work
- partition
- adiabatic shear bands
- viscoplasticity
- steel
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas