1. |
- Abbas, Taimoor, et al.
(author)
-
A Measurement Based Shadow Fading Model for Vehicle-to-Vehicle Network Simulations
- 2015
-
In: International Journal of Antennas and Propagation. - : Hindawi Publishing Corporation. - 1687-5869 .- 1687-5877.
-
Journal article (peer-reviewed)abstract
- The vehicle-to-vehicle (V2V) propagation channel has significant implications on the design and performance of novel communication protocols for vehicular ad hoc networks (VANETs). Extensive research efforts have been made to develop V2V channel models to be implemented in advanced VANET system simulators for performance evaluation. The impact of shadowing caused by other vehicles has, however, largely been neglected in most of the models, as well as in the system simulations. In this paper we present a shadow fading model targeting system simulations based on real measurements performed in urban and highway scenarios. The measurement data is separated into three categories, line-of-sight (LOS), obstructed line-of-sight (OLOS) by vehicles, and non-line-of-sight due to buildings, with the help of video information recorded during the measurements. It is observed that vehicles obstructing the LOS induce an additional average attenuation of about 10 dB in the received signal power. An approach to incorporate the LOS/OLOS model into existing VANET simulators is also provided. Finally, system level VANET simulation results are presented, showing the difference between the LOS/OLOS model and a channel model based on Nakagami-m fading.
|
|
2. |
- Abbas, Taimoor, et al.
(author)
-
Directional Analysis of Vehicle-to-Vehicle Propagation Channels
- 2011
-
In: IEEE Vehicular Technology Conference.
-
Conference paper (peer-reviewed)abstract
- This paper presents a double directional analysis of vehicle-to-vehicle channel measurements conducted in three different traffic scenarios. Using a high-resolution algorithm, we derive channel parameters like Angle-of-Arrival (AOA), Angle-of-Departure (AOD), propagation delay and Doppler shift and identify underlying propagation mechanisms by combining these estimates with maps of the measurement sites. The results show that first-order reflections from a small number of interacting objects can account for a large part of the received signal in the absence of line-of-sight (LOS). This effect is especially pronounced in the two traffic scenarios where the road is not lined with buildings. We also found that the direction spread is low (and conversely that the antenna correlation is high) in such scenarios, which suggests that beam forming rather than diversity-based methods should be used if multiple antenna elements are used. The situation is reversed, however, in the third scenario, a narrow urban intersection, where a larger number of higher-order reflections is found to result in a higher direction spread.
|
|
3. |
- Abbas, Taimoor, et al.
(author)
-
Directional Analysis of Vehicle-to-Vehicle Propagation in Different Traffic Environments
- 2010
-
In: [Host publication title missing].
-
Conference paper (other academic/artistic)abstract
- This paper presents a double directional analysis of vehicle-to-vehicle channel measurements conducted in two different traffic environments. Using a high-resolution algorithm, we derive channel parameters like angle-of- arrival, angle-of-departure, propagation delay and Doppler’s spread and identify underlying propagation mechanisms by combining these estimates with maps of the measurement sites. The results show that single-bounce interaction with static objects is the dominating effect in the absence of line-of-sight, and that the contribution from other vehicles is small. We also find that in the absence of line-of-sight the direction spread at both sides of link is large which indicates possible diversity gain using multi-antenna arrangements.
|
|
4. |
- Abbas, Taimoor, et al.
(author)
-
Initial Investigation to study the Effect of Antenna Placement in Vehicle-to-Vehicle Communications
- 2011
-
In: [Host publication title missing].
-
Conference paper (other academic/artistic)abstract
- In this paper we present an analysis of the effects of antenna placement on the radio channel properties for Vehicle-to-Vehicle communications based on measurements performed in three different propagation scenarios; highway, urban and rural. Four omni-directional antennas were mounted at four different positions: roof, bumper, left-side mirror and inside windscreen of two standard station wagons (Volvo V70). The channel transfer functions were measured for all antenna combinations with a wideband MIMO channel sounder. The results from this initial analysis show that the antenna mounted on the left-side mirror outperforms other antennas when vehicles are moving in convoy and are aligned well to each other. Whereas, if the TX and RX are moving in opposite direction, i.e., towards each other, bumper antenna shows good performance as long as LOS is available in between the antenna elements. In total some kind of diversity arrangement with complementary antennas seems to be the preferred solution, to decrease the effect of shadowing.
|
|
5. |
- Abbas, Taimoor, et al.
(author)
-
Line-of-Sight Obstruction Analysis for Vehicle-to-Vehicle Network Simulations in a Two Lane Highway Scenario
- 2013
-
In: International Journal of Antennas and Propagation. - : Hindawi Limited. - 1687-5869 .- 1687-5877. ; 2013
-
Journal article (peer-reviewed)abstract
- In vehicular ad-hoc networks (VANETs) the impact of vehicles as obstacles has largely been neglected in the past. Recent studies have reported that the vehicles that obstruct the line-of-sight (LOS) path may introduce 10-20 dB additional loss, and as a result reduce the communication range. Most of the traffic mobility models (TMMs) today do not treat other vehicles as obstacles and thus can not model the impact of LOS obstruction in VANET simulations. In this paper the LOS obstruction caused by other vehicles is studied in a highway scenario. First a car-following model is used to characterize the motion of the vehicles driving in the same direction on a two-lane highway. Vehicles are allowed to change lanes when necessary. The position of each vehicle is updated by using the car-following rules together with the lane-changing rules for the forward motion. Based on the simulated traffic a simple TMM is proposed for VANET simulations, which is capable to identify the vehicles that are in the shadow region of other vehicles. The presented traffic mobility model together with the shadow fading path loss model can take in to account the impact of LOS obstruction on the total received power in the multiple-lane highway scenarios.
|
|
6. |
|
|
7. |
- Abbas, Taimoor, et al.
(author)
-
Measurement-Based Analysis: The Effect of Complementary Antennas and Diversity on Vehicle-to-Vehicle Communication
- 2013
-
In: IEEE Antennas and Wireless Propagation Letters. - 1548-5757. ; 12:1, s. 309-312
-
Journal article (peer-reviewed)abstract
- In vehicle-to-vehicle (V2V) communication systems the antennas are prone to shadowing and the antenna gain is dissimilar even for same antenna elements if mounted at different positions on the car. This paper investigates the impact of antenna placement based on channel measurements performed with four omni-directional antennas mounted on the roof, bumper, windscreen and left-side mirror of the transmitter and receiver cars. Results suggest to use antennas with complementary characteristics, e.g., antennas on each side, mounted on the roof and bumper, to exploit diversity and decrease the effect of shadowing.
|
|
8. |
- Abbas, Taimoor
(author)
-
Measurement Based Channel Characterization and Modeling for Vehicle-to-Vehicle Communications
- 2014
-
Doctoral thesis (other academic/artistic)abstract
- Vehicle-to-Vehicle (V2V) communication is a challenging but fast growing technology that has potential to enhance traffic safety and efficiency. It can also provide environmental benefits in terms of reduced fuel consumption. The effectiveness and reliability of these applications highly depends on the quality of the V2V communication link, which rely upon the properties of the propagation channel. Therefore, understanding the properties of the propagation channel becomes extremely important. This thesis aims to fill some gaps of knowledge in V2V channel research by addressing four different topics. The first topic is channel characterization of some important safety critical scenarios (papers I and II). Second, is the accuracy or validation study of existing channel models for these safety critical scenarios (papers III and IV). Third, is about channel modeling (paper V) and, the fourth topic is the impact of antenna placement on vehicles and the possible diversity gains. This thesis consists of an introduction and six papers: Paper I presents a double directional analysis of vehicular channels based on channel measurement data. Using SAGE, a high-resolution algorithm for parameter estimation, we estimate channel parameters to identify underlying propagation mechanisms. It is found that, single-bounce reflections from static objects are dominating propagation mechanisms in the absence of line-of-sight (LOS). Directional spread is observed to be high, which encourages the use of diversity-based methods. Paper II presents results for V2V channel characterization based on channel measurements conducted for merging lanes on highway, and four-way street intersection scenarios. It is found that the merging lane scenario has the worst propagation condition due to lack of scatterers. Signal reception is possible only with the present LOS component given that the antenna has a good gain in the direction of LOS. Thus designing an antenna that has an omni-directional gain, or using multiple antennas that radiate towards different directions become more important for such safety critical scenarios. Paper III presents the results of an accuracy study of a deterministic ray tracing channel model for vehicle-to-vehicle (V2V) communication, that is compared against channel measurement data. It is found that the results from measurement and simulation show a good agreement especially in LOS situations where as in NLOS situations the simulations are accurate as far as existing physical phenomena of wave propagation are captured by the implemented algorithm. Paper IV presents the results of a validation study of a stochastic NLOS pathloss and fading model named VirtualSource11p for V2V communication in urban street intersections. The reference model is validated with the help of independent channel measurement data. It is found that the model is flexible and fits well to most of the measurements with a few exceptions, and we propose minor modifications to the model for increased accuracy. Paper V presents a shadow fading model targeting system simulations based on channel measurements. The model parameters are extracted from measurement data, which is separated into three categories; line-of-sight (LOS), LOS obstructed by vehicles (OLOS), and LOS blocked by buildings (NLOS), with the help of video information recorded during the measurements. It is found that vehicles obstructing the LOS induce an additional attenuation in the received signal power. The results from system level vehicular ad hoc network (VANET) simulations are also presented, showing that the LOS obstruction affects the packet reception probability and this can not be ignored. Paper VI investigates the impact of antenna placement based on channel measurements performed with four omni-directional antennas mounted on the roof, bumper, windscreen and left-side mirror of the transmitter and receiver cars. We use diversity combining methods to evaluate the performance differences for all possible single-input single-output (SIMO), multiple-input single-output (MISO) and multiple-input multiple-output (MIMO) link combinations. This investigation suggests that a pair of antennas with complementary properties, e.g., a roof mounted antenna together with a bumper antenna is a good solution for obtaining the best reception performance, in most of the propagation environments. In summary, this thesis describes the channel behavior for safety-critical scenarios by statistical means and models it so that the system performance can be assessed in a realistic manner. In addition to that the influence of different antenna arrangements has also been studied to exploit the spatial diversity and to mitigate the shadowing effects. The presented work can thus enable more efficient design of future V2V communication systems.
|
|
9. |
- Abbas, Taimoor, et al.
(author)
-
Measurements Based Channel Characterization for Vehicle-to-Vehicle Communications at Merging Lanes on Highway
- 2013
-
In: 2013 IEEE 5th International Symposium on Wireless Vehicular Communications, WiVeC 2013 - Proceedings. - : IEEE. - 9781467363396
-
Conference paper (peer-reviewed)abstract
- This paper presents results for vehicle-to-vehicle channel characterization based on measurements conducted for the merging lane scenarios on a highway. We present power delay profiles as well as channel gains and analyze important propagation mechanisms to see the impact of line-of-sight (LOS) and the antenna radiation pattern on the total received power. It is found that the absence of LOS and strong scattering objects, close to the point where the ramp merges with a highway, may result in poor received signal strength. The probability of dropping packets also increases where there is LOS between TX and RX but the antenna pattern is not omni-directional. A dip in the antenna pattern affects the received signal strength severely which poses a challenge for vehicle-to-vehicle communication in safety critical situations.
|
|
10. |
|
|