| 1. |
- Kehoe, Laura, et al.
(author)
-
Make EU trade with Brazil sustainable
- 2019
-
In: Science. - : American Association for the Advancement of Science (AAAS). - 0036-8075 .- 1095-9203. ; 364:6438, s. 341-
-
Journal article (other academic/artistic)
|
|
| 2. |
- Schael, S., et al.
(author)
-
Electroweak measurements in electron positron collisions at W-boson-pair energies at LEP
- 2013
-
In: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 532:4, s. 119-244
-
Research review (peer-reviewed)abstract
- Electroweak measurements performed with data taken at the electron positron collider LEP at CERN from 1995 to 2000 are reported. The combined data set considered in this report corresponds to a total luminosity of about 3 fb(-1) collected by the four LEP experiments ALEPH, DELPHI, 13 and OPAL, at centre-of-mass energies ranging from 130 GeV to 209 GeV. Combining the published results of the four LEP experiments, the measurements include total and differential cross-sections in photon-pair, fermion-pair and four-fermion production, the latter resulting from both double-resonant WW and ZZ production as well as singly resonant production. Total and differential cross-sections are measured precisely, providing a stringent test of the Standard Model at centre-of-mass energies never explored before in electron positron collisions. Final-state interaction effects in four-fermion production, such as those arising from colour reconnection and Bose Einstein correlations between the two W decay systems arising in WW production, are searched for and upper limits on the strength of possible effects are obtained. The data are used to determine fundamental properties of the W boson and the electroweak theory. Among others, the mass and width of the W boson, m(w) and Gamma(w), the branching fraction of W decays to hadrons, B(W -> had), and the trilinear gauge-boson self-couplings g(1)(Z), K-gamma and lambda(gamma), are determined to be: m(w) = 80.376 +/- 0.033 GeV Gamma(w) = 2.195 +/- 0.083 GeV B(W -> had) = 67.41 +/- 0.27% g(1)(Z) = 0.984(-0.020)(+0.018) K-gamma - 0.982 +/- 0.042 lambda(gamma) = 0.022 +/- 0.019. (C) 2013 Elsevier B.V. All rights reserved.
|
|
| 3. |
- Schael, S, et al.
(author)
-
Precision electroweak measurements on the Z resonance
- 2006
-
In: Physics Reports. - : Elsevier BV. - 0370-1573 .- 1873-6270. ; 427:5-6, s. 257-454
-
Research review (peer-reviewed)abstract
- We report on the final electroweak measurements performed with data taken at the Z resonance by the experiments operating at the electron-positron colliders SLC and LEP. The data consist of 17 million Z decays accumulated by the ALEPH, DELPHI, L3 and OPAL experiments at LEP, and 600 thousand Z decays by the SLID experiment using a polarised beam at SLC. The measurements include cross-sections, forward-backward asymmetries and polarised asymmetries. The mass and width of the Z boson, m(Z) and Gamma(Z), and its couplings to fermions, for example the p parameter and the effective electroweak mixing angle for leptons, are precisely measured: m(Z) = 91.1875 +/- 0.0021 GeV, Gamma(Z) = 2.4952 +/- 0.0023 GeV, rho(l) = 1.0050 +/- 0.0010, sin(2)theta(eff)(lept) = 0.23153 +/- 0.00016. The number of light neutrino species is determined to be 2.9840 +/- 0.0082, in agreement with the three observed generations of fundamental fermions. The results are compared to the predictions of the Standard Model (SM). At the Z-pole, electroweak radiative corrections beyond the running of the QED and QCD coupling constants are observed with a significance of five standard deviations, and in agreement with the Standard Model. Of the many Z-pole measurements, the forward-backward asymmetry in b-quark production shows the largest difference with respect to its SM expectation, at the level of 2.8 standard deviations. Through radiative corrections evaluated in the framework of the Standard Model, the Z-pole data are also used to predict the mass of the top quark, m(t) = 173(+10)(+13) GeV, and the mass of the W boson, m(W) = 80.363 +/- 0.032 GeV. These indirect constraints are compared to the direct measurements, providing a stringent test of the SM. Using in addition the direct measurements of m(t) and m(W), the mass of the as yet unobserved SM Higgs boson is predicted with a relative uncertainty of about 50% and found to be less than 285 GeV at 95% confidence level. (c) 2006 Elsevier B.V. All rights reserved.
|
|
| 4. |
|
|
| 5. |
- Antoniou, Antonis C., et al.
(author)
-
Common alleles at 6q25.1 and 1p11.2 are associated with breast cancer risk for BRCA1 and BRCA2 mutation carriers
- 2011
-
In: Human Molecular Genetics. - : Oxford University Press (OUP). - 0964-6906 .- 1460-2083. ; 20:16, s. 3304-3321
-
Journal article (peer-reviewed)abstract
- Two single nucleotide polymorphisms (SNPs) at 6q25.1, near the ESR1 gene, have been implicated in the susceptibility to breast cancer for Asian (rs2046210) and European women (rs9397435). A genome-wide association study in Europeans identified two further breast cancer susceptibility variants: rs11249433 at 1p11.2 and rs999737 in RAD51L1 at 14q24.1. Although previously identified breast cancer susceptibility variants have been shown to be associated with breast cancer risk for BRCA1 and BRCA2 mutation carriers, the involvement of these SNPs to breast cancer susceptibility in mutation carriers is currently unknown. To address this, we genotyped these SNPs in BRCA1 and BRCA2 mutation carriers from 42 studies from the Consortium of Investigators of Modifiers of BRCA1/2. In the analysis of 14 123 BRCA1 and 8053 BRCA2 mutation carriers of European ancestry, the 6q25.1 SNPs (r(2) = 0.14) were independently associated with the risk of breast cancer for BRCA1 mutation carriers [ hazard ratio (HR) = 1.17, 95% confidence interval (CI): 1.11-1.23, P-trend = 4.5 x 10(-9) for rs2046210; HR = 1.28, 95% CI: 1.18-1.40, P-trend = 1.3 x 10(-8) for rs9397435], but only rs9397435 was associated with the risk for BRCA2 carriers (HR = 1.14, 95% CI: 1.01-1.28, P-trend = 0.031). SNP rs11249433 (1p11.2) was associated with the risk of breast cancer for BRCA2 mutation carriers (HR = 1.09, 95% CI: 1.02-1.17, P-trend = 0.015), but was not associated with breast cancer risk for BRCA1 mutation carriers (HR = 0.97, 95% CI: 0.92-1.02, P-trend = 0.20). SNP rs999737 (RAD51L1) was not associated with breast cancer risk for either BRCA1 or BRCA2 mutation carriers (P-trend = 0.27 and 0.30, respectively). The identification of SNPs at 6q25.1 associated with breast cancer risk for BRCA1 mutation carriers will lead to a better understanding of the biology of tumour development in these women.
|
|
| 6. |
- Bartolini, Davide Basilio, et al.
(author)
-
The Autonomic Operating System Research Project - Achievements and Future Directions
- 2013
-
Conference paper (peer-reviewed)abstract
- Traditionally, hypervisors, operating systems, and runtime systems have been providing an abstraction layer over the bare-metal hardware. Traditional abstractions, however, do not consider for non-functional requirements such as system-level constraints or users' objectives. As these requirements are gaining increasing importance, researchers are looking into making user-specified and system-level objectives first-class citizens in the computer systems' realm. This paper describes the Autonomic Operating System (AcOS) project; AcOS enhances commodity operating systems with an autonomic layer that enables self-* properties through adaptive resource allocation. With AcOS, we investigate intelligent resource allocation to achieve user-specified service-level objectives on application performance and to respect system-level thresholds on CPU temperature. We give a broad overview of \system, elaborate on its achievements, and discuss research perspectives.
|
|
| 7. |
- Gruber, Aurel, et al.
(author)
-
Interactive Sculpting of Digital Faces Using an Anatomical Modeling Paradigm
- 2020
-
In: Computer Graphics Forum. - : Wiley. - 1467-8659 .- 0167-7055. ; 39:5, s. 93-102
-
Journal article (peer-reviewed)abstract
- Digitally sculpting 3D human faces is a very challenging task. It typically requires either 1) highly-skilled artists using complex software packages for high quality results, or 2) highly-constrained simple interfaces for consumer-level avatar creation, such as in game engines. We propose a novel interactive method for the creation of digital faces that is simple and intuitive to use, even for novice users, while consistently producing plausible 3D face geometry, and allowing editing freedom beyond traditional video game avatar creation. At the core of our system lies a specialized anatomical local face model (ALM), which is constructed from a dataset of several hundred 3D face scans. User edits are propagated to constraints for an optimization of our data-driven ALM model, ensuring the resulting face remains plausible even for simple edits like clicking and dragging surface points. We show how several natural interaction methods can be implemented in our framework, including direct control of the surface, indirect control of semantic features like age, ethnicity, gender, and BMI, as well as indirect control through manipulating the underlying bony structures. The result is a simple new method for creating digital human faces, for artists and novice users alike. Our method is attractive for low-budget VFX and animation productions, and our anatomical modeling paradigm can complement traditional game engine avatar design packages.
|
|
| 8. |
- Sironi, Filippo, et al.
(author)
-
ThermOS: System Support for Dynamic Thermal Management of Chip Multi-Processors
- 2013
-
In: 22nd International Conference on Parallel Architectures and Compilation Techniques (PACT), 2013. - 1089-795X. - 9781479910182 ; , s. 41-50
-
Conference paper (peer-reviewed)abstract
- Constraining the temperature of computing systems has become a dominant design aspect. The supply voltage decrease has lost its pace even though the feature size is shrinking constantly. This results in an increased number of transistors per unit of area and hence a growing power density. Researchers started investigating dynamic thermal management techniques to trade-off performance for energy consumption, thus reducing power density and temperature. Software dynamic thermal management displayed some advantages with respect to hardware solutions found in chip multi-processors. Hardware dynamic thermal management indiscriminately trades-off performance for energy consumption, possibly affecting established service-level agreements, while software solutions can avoid this issue. We propose ThermOS, a framework that harnesses formal, feedback control and idle cycle injection to reduce thermal emergencies while showing better efficiency than common dynamic thermal management techniques like dynamic voltage and frequency scaling.
|
|
