1. |
- Beal, Jacob, et al.
(author)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
In: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Journal article (peer-reviewed)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
2. |
|
|
3. |
- Klionsky, Daniel J., et al.
(author)
-
Guidelines for the use and interpretation of assays for monitoring autophagy
- 2012
-
In: Autophagy. - : Informa UK Limited. - 1554-8635 .- 1554-8627. ; 8:4, s. 445-544
-
Research review (peer-reviewed)abstract
- In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
|
|
4. |
-
- 2019
-
Journal article (peer-reviewed)
|
|
5. |
- Sampson, Joshua N., et al.
(author)
-
Analysis of Heritability and Shared Heritability Based on Genome-Wide Association Studies for 13 Cancer Types
- 2015
-
In: Journal of the National Cancer Institute. - : Oxford University Press (OUP). - 0027-8874 .- 1460-2105. ; 107:12
-
Journal article (peer-reviewed)abstract
- Background: Studies of related individuals have consistently demonstrated notable familial aggregation of cancer. We aim to estimate the heritability and genetic correlation attributable to the additive effects of common single-nucleotide polymorphisms (SNPs) for cancer at 13 anatomical sites. Methods: Between 2007 and 2014, the US National Cancer Institute has generated data from genome-wide association studies (GWAS) for 49 492 cancer case patients and 34 131 control patients. We apply novel mixed model methodology (GCTA) to this GWAS data to estimate the heritability of individual cancers, as well as the proportion of heritability attributable to cigarette smoking in smoking-related cancers, and the genetic correlation between pairs of cancers. Results: GWAS heritability was statistically significant at nearly all sites, with the estimates of array-based heritability, h(l)(2), on the liability threshold (LT) scale ranging from 0.05 to 0.38. Estimating the combined heritability of multiple smoking characteristics, we calculate that at least 24% (95% confidence interval [CI] = 14% to 37%) and 7% (95% CI = 4% to 11%) of the heritability for lung and bladder cancer, respectively, can be attributed to genetic determinants of smoking. Most pairs of cancers studied did not show evidence of strong genetic correlation. We found only four pairs of cancers with marginally statistically significant correlations, specifically kidney and testes (rho = 0.73, SE = 0.28), diffuse large B-cell lymphoma (DLBCL) and pediatric osteosarcoma (rho = 0.53, SE = 0.21), DLBCL and chronic lymphocytic leukemia (CLL) (rho = 0.51, SE = 0.18), and bladder and lung (rho = 0.35, SE = 0.14). Correlation analysis also indicates that the genetic architecture of lung cancer differs between a smoking population of European ancestry and a nonsmoking Asian population, allowing for the possibility that the genetic etiology for the same disease can vary by population and environmental exposures. Conclusion: Our results provide important insights into the genetic architecture of cancers and suggest new avenues for investigation.
|
|
6. |
- Ding, Bao Jian, et al.
(author)
-
Biosynthesis of the sex pheromone component (E,Z)-7,9-Dodecadienyl acetate in the European Grapevine Moth, Lobesia botrana, involving ∆11 desaturation and an elusive ∆7 desaturase
- 2021
-
In: Journal of Chemical Ecology. - : Springer Science and Business Media LLC. - 0098-0331 .- 1573-1561. ; 47:3, s. 248-264
-
Journal article (peer-reviewed)abstract
- The European grapevine moth, Lobesia botrana, uses (E,Z)-7,9-dodecadienyl acetate as its major sex pheromone component. Through in vivo labeling experiments we demonstrated that the doubly unsaturated pheromone component is produced by ∆11 desaturation of tetradecanoic acid, followed by chain shortening of (Z)-11-tetradecenoic acid to (Z)-9-dodecenoic acid, and subsequently introduction of the second double bond by an unknown ∆7 desaturase, before final reduction and acetylation. By sequencing and analyzing the transcriptome of female pheromone glands of L. botrana, we obtained 41 candidate genes that may be involved in sex pheromone production, including the genes encoding 17 fatty acyl desaturases, 13 fatty acyl reductases, 1 fatty acid synthase, 3 acyl-CoA oxidases, 1 acetyl-CoA carboxylase, 4 fatty acid transport proteins and 2 acyl-CoA binding proteins. A functional assay of desaturase and acyl-CoA oxidase gene candidates in yeast and insect cell (Sf9) heterologous expression systems revealed that Lbo_PPTQ encodes a ∆11 desaturase producing (Z)-11-tetradecenoic acid from tetradecanoic acid. Further, Lbo_31670 and Lbo_49602 encode two acyl-CoA oxidases that may produce (Z)-9-dodecenoic acid by chain shortening (Z)-11-tetradecenoic acid. The gene encoding the enzyme introducing the E7 double bond into (Z)-9-dodecenoic acid remains elusive even though we assayed 17 candidate desaturases in the two heterologous systems.
|
|
7. |
- Han, Yi, et al.
(author)
-
Na-mediated carbon nitride realizing CO 2 photoreduction with selectivity modulation
- 2024
-
In: Journal of Colloid and Interface Science. - : ACADEMIC PRESS INC ELSEVIER SCIENCE. - 0021-9797 .- 1095-7103. ; 670, s. 348-356
-
Journal article (peer-reviewed)abstract
- The depressed directional separation of photogenerated carriers and weak CO2 adsorption/activation activity are the main factors hampering the development of artificial photosynthesis. Herein, Na ions are embedded in graphitic carbon nitride (g-C3N4) to achieve directional migration of the photogenerated electrons to Na sites, while the electron-rich Na sites enhance CO2 adsorption and activation. Na/g-C3N4 (NaCN) shows improved photocatalytic reduction activity of CO2 to CO and CH4, and under simulated sunlight irradiation, the CO yield of NaCN synthesized by embedding Na at 550 degrees C (NaCN-550) is 371.2 mu mol g-1 h-1, which is 58.9 times more than that of the monomer g-C3N4. By means of theoretical calculations and experiments including in situ fourier transform infrared spectroscopy, the mechanism is investigated. This strategy which improves carrier separation and reduces the energy barrier at the same time is important to the development of artificial photosynthesis.
|
|
8. |
|
|
9. |
- Liu, Qing, et al.
(author)
-
Unraveling the unique role of brown graphitic carbon nitride in robust CO2 photoreduction
- 2023
-
In: Applied Surface Science. - : ELSEVIER. - 0169-4332 .- 1873-5584. ; 615
-
Journal article (peer-reviewed)abstract
- Photocatalytic CO2 reduction is one of the important means to alleviate the energy crisis. In this work, an oxygen linked and brown graphitic carbon nitride (GACN) was successfully prepared by thermal polymerization after oil bath method. GACN introduced oxygen atoms on surface of BulkCN. Various characterizations of the material show that the prepared GACN has a different structure and higher photoelectronic activity compared to BulkCN. GACN possessed strong photocatalytic CO2 reduction capacity, and the photocatalytic activity was significantly improved compared with BulkCN. In view of density functional theory calculations, it is proved that the oxygen atoms introduced by GACN increase CO2 photoreaction reactivity, enhance electronic activity and reduce the reaction energy barrier. This work can have a positive effect on the photocatalytic application of g-C3N4 with the existence of oxygen atoms.
|
|
10. |
- Meng, Yi, et al.
(author)
-
2D and 3D Porphyrinic Covalent Organic Frameworks : The Influence of Dimensionality on Functionality
- 2020
-
In: Angewandte Chemie International Edition. - : Wiley. - 1433-7851 .- 1521-3773. ; 59:9, s. 3624-3629
-
Journal article (peer-reviewed)abstract
- The construction of 2D and 3D covalent organic frameworks (COFs) from functional moieties for desired properties has gained much attention. However, the influence of COFs dimensionality on their functionalities, which can further assist in COF design, has never been explored. Now, by selecting designed precursors and topology diagrams, 2D and 3D porphyrinic COFs (2D-PdPor-COF and 3D-PdPor-COF) are synthesized. By model building and Rietveld refinement of powder X-ray diffraction, 2D-PdPor-COF crystallizes as 2D sheets while 3D-PdPor-COF adopts a five-fold interpenetrated pts topology. Interestingly, compared with 2D-PdPor-COF, 3D-PdPor-COF showed interesting properties, including 1) higher CO2 adsorption capacity; 2) better photocatalytic performance; and 3) size-selective photocatalysis. Based on this study, we believe that with the incorporation of functional moieties, the dimensionality of COFs can definitely influence their functionalities.
|
|