1. |
- Duoc, Vo Thanh, et al.
(author)
-
New Design of ZnO Nanorod- and Nanowire-Based NO2 Room-Temperature Sensors Prepared by Hydrothermal Method
- 2019
-
In: Journal of Nanomaterials. - : HINDAWI LTD. - 1687-4110 .- 1687-4129.
-
Journal article (peer-reviewed)abstract
- Room-temperature gas sensors are attracting attention because of their low power consumption, safe operation, and long-term stability. Herein, ZnO nanorods (NRs) and nanowires (NWs) were on-chip grown via a facile hydrothermal method and used for room-temperature NO2 gas sensor applications. The ZnO NRs were obtained by a one-step hydrothermal process, whereas the NWs were obtained by a two-step hydrothermal process. To obtain ZnO NW sensor, the length of NRs was controlled short enough so that none of the nanorod-nanorod junction was made. Thereafter, the NWs were grown from the tips of no-contact NRs to form nanowire-nanowire junctions. The gas-sensing characteristics of ZnO NRs and NWs were tested against NO2 gas at room temperature for comparison. The gas-sensing characteristics of the sensors were also tested at different applied voltages to evaluate the effect of the self-activated gas-sensing performance. Results show that the diameter of ZnO NRs and NWs is the dominant parameter of their NO2 gas-sensing performance at room temperature. In addition, self-activation by local heating occurred for both sensors, but because the NWs were smaller and sparser than the NRs, local heating thus required a lower applied voltage with maximal response compared with the NRs.
|
|
2. |
- Duoc, Vo Thanh, et al.
(author)
-
Hydrogen gas sensor based on self-heating effect of SnO2/Pt thin film with ultralow power consumption
- 2024
-
In: International journal of hydrogen energy. - : Elsevier. - 0360-3199 .- 1879-3487. ; 61, s. 774-782
-
Journal article (peer-reviewed)abstract
- Self-heating of sensing elements on gas sensors is an effective solution to avoid using external heaters. In this paper, a self-heated hydrogen gas sensor is presented. The sensor was created using the DC sputtering method, which involved fabricating it on a thermal-insulating Kapton flexible substrate. This process utilized a thin film of SnO2 with thick 50 nm that was modified with nanoclusters of Pt, serving as the sensing material. The SnO2/Pt material film was analyzed for microstructure and composition by SEM, XRD, and XPS analysis. Infrared images show that the self-heating effect is mainly concentrated in the strip of gas-sensitive material. It showed many good performances, such as high sensitivity (able to detect down to 50 ppm of H2), good selectivity (poor response to CO, NH3, H2S, and NO2), the sensor's performance is little changed by environmental humidity, and low power consumption (89 μW at 5V). The sensor is also stable and low-cost, suitable for portable H2 detection devices due to its low generated heat and small size.
|
|
3. |
- Duoc, Vo Thanh, et al.
(author)
-
Room temperature highly toxic NO2 gas sensors based on rootstock/scion nanowires of SnO2/ZnO, ZnO/SnO2, SnO2/SnO2 and, ZnO/ZnO
- 2021
-
In: Sensors and actuators. B, Chemical. - : Elsevier. - 0925-4005 .- 1873-3077. ; 348
-
Journal article (peer-reviewed)abstract
- Grafted structures between SnO2 and ZnO nanowires were realized in a two-step process of growth. First, the rootstocks of SnO2 or ZnO nanowires were synthesized by thermal evaporation technique. Second, a thin Au layer was sputter deposited on the sample and synthesis of nanowire scions of ZnO or SnO2, respectively, on the rootstocks was realized by thermal evaporation technique again. In both growth steps, SnO2 powder or a mixture of ZnO and carbon powders was use as source materials for the synthesis. Different rootstock/scion combinations of SnO2/ZnO, ZnO/SnO2 nanowires (called heterostructures) and ZnO/ZnO, SnO2/SnO2 nanowires (called homostructures) were synthesised. The fabricated grafted nanowires were examined by field-emission scanning electron microscope and their compositions were analyzed by energy dispersive spectroscopy and X-ray diffraction analysis. The test results indicate that this type of nanostructure material is very promising for NO2 gas sensing at ppt level at room temperature. Among the fabricated structures the SnO2/ZnO nanowires showed the best sensing performance with the high sensitivity and fast response and recovery time. We also discussed the gas sensing mechanism of the fabricated sensors based on the band diagram.
|
|