1. |
- Bramer, Tobias, et al.
(author)
-
Catanionic drug-surfactant mixtures : Phase behavior and sustained release from gels
- 2003
-
In: Pharmaceutical research. - 0724-8741 .- 1573-904X. ; 20:10, s. 1661-1667
-
Journal article (peer-reviewed)abstract
- PURPOSE: To study mixtures of SDS and the drugs diphenhydramine, tetracaine, and amitriptyline to compile phase diagrams and to investigate the use of interesting phases for sustained release from gels. METHODS: Phase diagrams were composed by studying large numbers of different compositions of negatively charged SDS and positively charged drug compounds visually, rheologically, and by cryotransmission electron microscopy. Drug release from Carbopol 940 and agar gels containing interesting phases, e.g., vesicle and branched micelle phases, was measured in vitro by the USP paddle method. RESULTS: Vesicles and elongated and branched micelles were formed on the SDS-rich side in all three systems examined. The tetracaine system differed from the other two in that it showed a vesicle area in the drug-rich side. Release of diphenhydramine from Carbopol 940 gels was slowed by at least a factor of 10 when in the form of vesicles or branched micelles. The same delay was found for both drug-rich and SDS-rich tetracaine vesicles. CONCLUSIONS: Mixtures of SDS and positively charged drugs form the same interesting phases as traditional catanionic mixtures. This may prove useful in obtaining functional controlled-release systems when using gels as drug carriers.
|
|
2. |
- Bramer, Tobias, et al.
(author)
-
Effects of pH and ionic strength on catanionic drug-surfactant mixtures used for prolonged release from gels.
- 2007
-
In: Journal of drug delivery science and technology. - 1773-2247. ; 17:4, s. 285-291
-
Journal article (peer-reviewed)abstract
- The purpose of this study was to investigate the influence of pH and ionic strength on the phase behavior of two different catanionic drug-surfactant mixtures, and to study drug release from gels facilitated by the catanionic aggregates. Simplified phase diagrams were constructed for diphenhydramine or tetracaine mixed with SDS, varying the pH approximately between 6 and 11, and the NaCI concentration from 0.45 to 1.8%. The phases formed were studied visually, rheologically and with cryo-TEM. Some mixtures containing catanionic vesicles and micelles were selected for drug release studies from gels, varying the pH and NaCI concentration here as well. Both catanionic systems investigated proved relatively resilient to changes in the ionic strength. Changes in pH, on the other hand, caused marked effects to the phase behavior in both systems. The influence of pH was particularly strong in the drug-rich part of the tetracaine/SDS system, where increasing the pH causes precipitation. As expected, the drug release in both systems was somewhat affected by changes in both pH and ionic strength, but remained in all cases significantly prolonged as compared to the release of free, non-complexed, drug. These studies show that catanionic mixtures may be used to obtain prolonged drug release from gels, and that the concept also works when the gels are exposed to a pH that is a couple of units above the pKa of the cationic component. Furthermore, the ionic strength has no pronounced effect on the drug release, as long as it is kept within reasonable pharmaceutical levels.
|
|
3. |
- Dew, Noel, et al.
(author)
-
Gel formation in systems composed of drug containing catanionic vesicles and oppositely charged hydrophobically modified polymer.
- 2009
-
In: Colloids and Surfaces B. - : Elsevier BV. - 0927-7765 .- 1873-4367. ; 70:2, s. 187-197
-
Journal article (peer-reviewed)abstract
- The aim of this study was to explore if mixtures of drug containing catanionic vesicles and polymers give rise to gel formation, and if so, if drug release from these gels could be prolonged. Catanionic vesicles formed from the drug substances alprenolol or tetracaine, and the oppositely charged surfactant sodium dodecyl sulphate were mixed with polymers. Three polymers with different properties were employed: one bearing hydrophobic modifications, one positively charged and one positively charged polymer bearing hydrophobic modifications. The structure of the vesicles before and after addition of polymer was investigated by using cryo-TEM. Gel formation was confirmed by using rheological measurements. Drug release was studied using a modified USP paddle method. Gels were observed to form only in the case when catanionic vesicles, most likely with a net negative charge, were mixed with positively charged polymer bearing lipophilic modifications. The release of drug substance from these systems, where the vesicles are not trapped within the gel but constitute a founding part of it, could be significantly prolonged. The drug release rate was found to depend on vesicle concentration to a higher extent than on polymer concentration.
|
|
4. |
- Dew, Noel, 1980-, et al.
(author)
-
Gel formulations containing catanionic vesicles composed of alprenolol and SDS : effects of drug release and skin penetration on aggregate structure
- 2012
-
In: Colloids and Surfaces B. - : Elsevier BV. - 0927-7765 .- 1873-4367. ; 89, s. 53-60
-
Journal article (peer-reviewed)abstract
- To fully utilize the extended contact time of gel formulations a novel formulation with drug containing catanionic aggregates offering prolonged drug release and skin penetration were investigated. This study aimed to further explore the drug release process from catanionic vesicles in gels. Catanionic vesicles were formed from alprenolol and sodium dodecyl sulphate. Physical gels composed of catanionic vesicles and a SoftCAT polymer were used as well as covalent Carbopol gels. Drug release was measured in vitro using a modified USP paddle method and the skin penetration was studied using dermatomized pig ear skin mounted in horizontal Ussing chambers. The aggregate structure was visualized with cryo-TEM during the drug release and skin penetration process. The study results show that catanionic vesicles are present in the formulations throughout the drug release process and during the clinically relevant skin application time. Hence, the decreased skin penetration rate stems from the prolonged release of drug substance from the gels. The rheological investigation shows that the gel structure of the physically cross-linked gels is maintained even as the drug substance is released and the gel volume is decreased.These findings indicate that the applicability of formulations like these is a future possibility.
|
|
5. |
- Gelin, Kristina, et al.
(author)
-
Characterization of water in bacterial cellulose using dielectric spectroscopy and electron microscopy
- 2007
-
In: Polymer. - : Elsevier BV. - 0032-3861 .- 1873-2291. ; 48:26, s. 7623-7631
-
Journal article (peer-reviewed)abstract
- It is shown that only 10% of the 99 wt% water present in bacterial cellulose (BC) gels, produced by Acetobacter xylinum, behave like free bulk water; the majority of the water molecules in the gels is more or less tightly bound to the cellulose. The magnitude of the diffusion coefficients of ions transported in the water phase of the BC gels as well as the information contained in freeze fracture transmission electron microscopic images of the gel structures indicates that the bulk-like water is confined in “lakes” rather than forming a continuous phase throughout the gel. Water desorption isotherms suggest that these “lakes” decrease in size with increasing oxygen concentration used during the biosynthesis process of the gels.
|
|
6. |
- Aad, G., et al.
(author)
-
- 2012
-
Journal article (peer-reviewed)
|
|
7. |
- Aad, G., et al.
(author)
-
- 2012
-
In: Nuclear Physics, Section B. - : Elsevier BV. - 0550-3213 .- 1873-1562. ; 864:3, s. 341-381
-
Journal article (peer-reviewed)
|
|
8. |
- Aad, G., et al.
(author)
-
- 2013
-
Journal article (peer-reviewed)
|
|
9. |
|
|
10. |
|
|