1. |
-
- 2019
-
Journal article (peer-reviewed)
|
|
2. |
- Abelev, Betty, et al.
(author)
-
Long-range angular correlations on the near and away side in p-Pb collisions at root S-NN=5.02 TeV
- 2013
-
In: Physics Letters. Section B: Nuclear, Elementary Particle and High-Energy Physics. - : Elsevier BV. - 0370-2693. ; 719:1-3, s. 29-41
-
Journal article (peer-reviewed)abstract
- Angular correlations between charged trigger and associated particles are measured by the ALICE detector in p-Pb collisions at a nucleon-nucleon centre-of-mass energy of 5.02 TeV for transverse momentum ranges within 0.5 < P-T,P-assoc < P-T,P-trig < 4 GeV/c. The correlations are measured over two units of pseudorapidity and full azimuthal angle in different intervals of event multiplicity, and expressed as associated yield per trigger particle. Two long-range ridge-like structures, one on the near side and one on the away side, are observed when the per-trigger yield obtained in low-multiplicity events is subtracted from the one in high-multiplicity events. The excess on the near-side is qualitatively similar to that recently reported by the CMS Collaboration, while the excess on the away-side is reported for the first time. The two-ridge structure projected onto azimuthal angle is quantified with the second and third Fourier coefficients as well as by near-side and away-side yields and widths. The yields on the near side and on the away side are equal within the uncertainties for all studied event multiplicity and p(T) bins, and the widths show no significant evolution with event multiplicity or p(T). These findings suggest that the near-side ridge is accompanied by an essentially identical away-side ridge. (c) 2013 CERN. Published by Elsevier B.V. All rights reserved.
|
|
3. |
- Abelev, Betty, et al.
(author)
-
Measurement of prompt J/psi and beauty hadron production cross sections at mid-rapidity in pp collisions at root s=7 TeV
- 2012
-
In: Journal of High Energy Physics. - 1029-8479. ; :11
-
Journal article (peer-reviewed)abstract
- The ALICE experiment at the LHC has studied J/psi production at mid-rapidity in pp collisions at root s = 7 TeV through its electron pair decay on a data sample corresponding to an integrated luminosity L-int = 5.6 nb(-1). The fraction of J/psi from the decay of long-lived beauty hadrons was determined for J/psi candidates with transverse momentum p(t) > 1,3 GeV/c and rapidity vertical bar y vertical bar < 0.9. The cross section for prompt J/psi mesons, i.e. directly produced J/psi and prompt decays of heavier charmonium states such as the psi(2S) and chi(c) resonances, is sigma(prompt J/psi) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 8.3 +/- 0.8(stat.) +/- 1.1 (syst.)(-1.4)(+1.5) (syst. pol.) mu b. The cross section for the production of b-hadrons decaying to J/psi with p(t) > 1.3 GeV/c and vertical bar y vertical bar < 0.9 is a sigma(J/psi <- hB) (p(t) > 1.3 GeV/c, vertical bar y vertical bar < 0.9) = 1.46 +/- 0.38 (stat.)(-0.32)(+0.26) (syst.) mu b. The results are compared to QCD model predictions. The shape of the p(t) and y distributions of b-quarks predicted by perturbative QCD model calculations are used to extrapolate the measured cross section to derive the b (b) over bar pair total cross section and d sigma/dy at mid-rapidity.
|
|
4. |
- Abelev, Betty, et al.
(author)
-
Underlying Event measurements in pp collisions at root s=0.9 and 7 TeV with the ALICE experiment at the LHC
- 2012
-
In: Journal of High Energy Physics. - 1029-8479. ; :7
-
Journal article (peer-reviewed)abstract
- We present measurements of Underlying Event observables in pp collisions at root s = 0 : 9 and 7 TeV. The analysis is performed as a function of the highest charged-particle transverse momentum p(T),L-T in the event. Different regions are defined with respect to the azimuthal direction of the leading (highest transverse momentum) track: Toward, Transverse and Away. The Toward and Away regions collect the fragmentation products of the hardest partonic interaction. The Transverse region is expected to be most sensitive to the Underlying Event activity. The study is performed with charged particles above three different p(T) thresholds: 0.15, 0.5 and 1.0 GeV/c. In the Transverse region we observe an increase in the multiplicity of a factor 2-3 between the lower and higher collision energies, depending on the track p(T) threshold considered. Data are compared to PYTHIA 6.4, PYTHIA 8.1 and PHOJET. On average, all models considered underestimate the multiplicity and summed p(T) in the Transverse region by about 10-30%.
|
|
5. |
- Andersson, Henrik, et al.
(author)
-
Assembling surface mounted components on ink-jet printed double sided paper circuit board
- 2014
-
In: Nanotechnology. - : IOP Publishing. - 0957-4484 .- 1361-6528. ; 25:9
-
Journal article (peer-reviewed)abstract
- Printed electronics is a rapidly developing field where many components can already be manufactured on flexible substrates by printing or by other high speed manufacturing methods. However, the functionality of even the most inexpensive microcontroller or other integrated circuit is, at the present time and for the foreseeable future, out of reach by means of fully printed components. Therefore, it is of interest to investigate hybrid printed electronics, where regular electrical components are mounted on flexible substrates to achieve high functionality at a low cost. Moreover, the use of paper as a substrate for printed electronics is of growing interest because it is an environmentally friendly and renewable material and is, additionally, the main material used for many packages in which electronics functionalities could be integrated. One of the challenges for such hybrid printed electronics is the mounting of the components and the interconnection between layers on flexible substrates with printed conductive tracks that should provide as low a resistance as possible while still being able to be used in a high speed manufacturing process. In this article, several conductive adhesives are evaluated as well as soldering for mounting surface mounted components on a paper circuit board with ink-jet printed tracks and, in addition, a double sided Arduino compatible circuit board is manufactured and programmed.
|
|
6. |
- Andersson, Henrik, et al.
(author)
-
System of nano-silver inkjet printed memory cards and PC card reader and programmer
- 2011
-
In: Microelectronics Journal. - : Elsevier BV. - 0959-8324 .- 0026-2692. ; 42:1, s. 21-27
-
Journal article (peer-reviewed)abstract
- This work describes the development of inkjet printed, low-cost memory cards, and complementary pair of memory card reader and card reader/programmer for PCs. This constitutes a complete system that can be used for various applications. The memory cards are manufactured by inkjet printing nano-silver ink on photo paper substrate. The printed memory structures have an initial high resistance that can later be programmed to specific values representing data on the cards, the so called Write Once Read Many (WORM) memories. The memory card reader measures the resistance values of the memory cells and reads it back to the computer by USB connection. Using multiple resistance levels that represent different states it is possible to have a larger number of selectable combinations with fewer physical bits compared to binary coding. This somewhat counters one of the limitations of resistive memory technology that basically each cell needs one physical contact. The number of possible states is related to the resolution of the reader and the stability of the WORM memory.
|
|
7. |
- Bergkvist, Lisa, et al.
(author)
-
Carbon Sequestration Potential f Agroforestry Systems For Phytoremediation In Chinandega, Nicaragua
- 2018
-
In: Linnaeus Eco-Tech 2018. ; , s. 211-211
-
Conference paper (other academic/artistic)abstract
- Greenhouse gases in the atmosphere have increased to earlier unrecorded levels, causing global climate change that increases GMT and threaten ecosystems and livelihoods. IPCC report suggest that agroforestry offers considerable carbon sequestration (c seq.) potential, especially for developing countries. The purpose of this study is to estimate the c seq. potential in different agroforestry systems suitable in Chinandega, Nicaragua - a deforested region where the ground is polluted by toxaphene and other POP:s. Three scenarios where studied; Shading system using Tectona grandis and Pogostemon cablin; Alley cropping using Erythrina poeppigiana and Ricinus communis and Silvopasture using Cordia alliodora and Brachiaria ruziziensis, the last scenario being divided into two subscenarios; unmanaged (grazed) and managed (harvested) grass. Calculations were performed using the modelling program CO2FIX v. 3.2, with a runtime of 100 years and assuming deforested area with no previous land use. Results show a significantly higher c seq. potential in Shading system (168/217 MgC/ha). Alley cropping yields 71 MgC/ha and Silvopasture results in 80/84 MgC/ha unmanaged and 65/70 MgC/ha managed. The higher number includes products from harvest. All scenarios show fluctuations over time due to thinning and harvesting practices. Phytoremediation potential of POPs has been shown in Ricinus communis and grass species. Soil c seq. is especially important to consider in longterm scenarios as this c seq. can be sustained over longer time. The inclusion of crop residue, the effect of grazing animals or changes in density of trees and crops and environmental fate of the toxic compounds need further assessment before considering large scale applications. Agroforestry practices could contribute to several benefits, including climate change mitigation and phytoremediation.
|
|
8. |
- Chambers, Josephine M., et al.
(author)
-
Co-productive agility and four collaborative pathways to sustainability transformations
- 2022
-
In: Global Environmental Change. - : Elsevier BV. - 0959-3780 .- 1872-9495. ; 72
-
Journal article (peer-reviewed)abstract
- Co-production, the collaborative weaving of research and practice by diverse societal actors, is argued to play an important role in sustainability transformations. Yet, there is still poor understanding of how to navigate the tensions that emerge in these processes. Through analyzing 32 initiatives worldwide that co-produced knowledge and action to foster sustainable social-ecological relations, we conceptualize 'co-productive agility' as an emergent feature vital for turning tensions into transformations. Co-productive agility refers to the willingness and ability of diverse actors to iteratively engage in reflexive dialogues to grow shared ideas and actions that would not have been possible from the outset. It relies on embedding knowledge production within processes of change to constantly recognize, reposition, and navigate tensions and opportunities. Co-productive agility opens up multiple pathways to transformation through: (1) elevating marginalized agendas in ways that maintain their integrity and broaden struggles for justice; (2) questioning dominant agendas by engaging with power in ways that challenge assumptions, (3) navigating conflicting agendas to actively transform interlinked paradigms, practices, and structures; (4) exploring diverse agendas to foster learning and mutual respect for a plurality of perspectives. We explore six process considerations that vary by these four pathways and provide a framework to enable agility in sustainability transformations. We argue that research and practice spend too much time closing down debate over different agendas for change - thereby avoiding, suppressing, or polarizing tensions, and call for more efforts to facilitate better interactions among different agendas.
|
|
9. |
- Chambers, Josephine M., et al.
(author)
-
Six modes of co-production for sustainability
- 2021
-
In: Nature Sustainability. - : Springer Science and Business Media LLC. - 2398-9629. ; 4, s. 983-996
-
Journal article (peer-reviewed)abstract
- Co-production includes diverse aims, terminologies and practices. This study explores such diversity by mapping differences in how 32 initiatives from 6 continents co-produce diverse outcomes for the sustainable development of ecosystems at local to global scales. The promise of co-production to address complex sustainability challenges is compelling. Yet, co-production, the collaborative weaving of research and practice, encompasses diverse aims, terminologies and practices, with poor clarity over their implications. To explore this diversity, we systematically mapped differences in how 32 initiatives from 6 continents co-produce diverse outcomes for the sustainable development of ecosystems at local to global scales. We found variation in their purpose for utilizing co-production, understanding of power, approach to politics and pathways to impact. A cluster analysis identified six modes of co-production: (1) researching solutions; (2) empowering voices; (3) brokering power; (4) reframing power; (5) navigating differences and (6) reframing agency. No mode is ideal; each holds unique potential to achieve particular outcomes, but also poses unique challenges and risks. Our analysis provides a heuristic tool for researchers and societal actors to critically explore this diversity and effectively navigate trade-offs when co-producing sustainability.
|
|
10. |
- Cumplido-Mayoral, I., et al.
(author)
-
Biological brain age prediction using machine learning on structural neuroimaging data: Multi-cohort validation against biomarkers of Alzheimer's disease and neurodegeneration stratified by sex
- 2023
-
In: Elife. - 2050-084X. ; 12
-
Journal article (peer-reviewed)abstract
- Brain--age can be inferred from structural neuroimaging and compared to chronological age (brain--age delta) as a marker of biological brain aging. Accelerated aging has been found in neurodegenerative disorders like Alzheimer's disease (AD), but its validation against markers of neurodegeneration and AD is lacking. Here, imaging--derived measures from the UK Biobank dataset (N=22,661) were used to predict brain--age in 2,314 cognitively unimpaired (CU) individuals at higher risk of AD and mild cognitive impaired (MCI) patients from four independent cohorts with available biomarker data: ALFA+, ADNI, EPAD, and OASIS. Brain-age delta was associated with abnormal amyloid-ss, more advanced stages (AT) of AD pathology and APOE-e4 status. Brain--age delta was positively associated with plasma neurofilament light, a marker of neurodegeneration, and sex differences in the brain effects of this marker were found. These results validate brain--age delta as a non-invasive marker of biological brain aging in non--demented individuals with abnormal levels of biomarkers of AD and axonal injury.
|
|