| 1. |
- Kuzmenko, Volodymyr, 1987, et al.
(författare)
-
Cellulose-derived carbon nanofibers/graphene composite electrodes for powerful compact supercapacitors
- 2017
-
Ingår i: RSC Advances. - : Royal Society of Chemistry (RSC). - 2046-2069. ; 7:73, s. 45968-45977
-
Tidskriftsartikel (refereegranskat)abstract
- Herein, we demonstrate a unique supercapacitor composite electrode material that is originated from a sustainable cellulosic precursor via simultaneous one-step carbonization/reduction of cellulose/graphene oxide mats at 800 degrees C. The resulting freestanding material consists of mechanically stable carbon nanofibrous (CNF, fiber diameter 50-500 nm) scaffolds tightly intertwined with highly conductive reduced graphene oxide (rGO) sheets with a thickness of 1-3 nm. The material is mesoporous and has electrical conductivity of 49 S cm(-1), attributed to the well-interconnected graphene layers. The electrochemical evaluation of the CNF/graphene composite electrodes in a supercapacitor device shows very promising volumetric values of capacitance, energy and power density (up to 46 F cm(-3), 1.46 W h L-1 and 1.09 kW L-1, respectively). Moreover, the composite electrodes retain an impressive 97% of the initial capacitance over 4000 cycles. With these superior properties, the produced composite electrodes should be the "looked-for" components in compact supercapacitors used for increasingly popular portable electronics and hybrid vehicles.
|
|
| 2. |
- Haque, Mohammad Mazharul, 1984
(författare)
-
Electrolyte evaluation and engineering for the performance enhancement of electrochemical capacitors
- 2021
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- As a consequence of a fast-paced technological evolution along with the acknowledgment of utilizing clean and renewable energy resources over fossil fuels, the importance of energy storage devices is widely recognized. The electrochemical capacitor (EC), commonly known as a supercapacitor or ultracapacitor, is an energy storage device that is already being used in portable consumer electronics, electrification of transportation, and grid-level applications. High power density and long cycle life are the two most prominent properties of ECs, thanks to the electrostatic nature of their charge storage mechanism. These properties are well utilized in a system where ECs are used as a backup power-boosting device to rechargeable batteries. By providing the peak power required, they eventually prolong the battery lifetime. However, the relatively low energy density of ECs compared to rechargeable batteries limits their application as a standalone device. In addition, low operating voltage, adverse self-discharge rate, severe leakage current, elevated temperature incompatibility are some of the crucial issues that are preventing the widespread application of ECs. Besides a general discussion about ECs, the main objective of this thesis is to identify and address the above-mentioned critical challenges, and to propose and demonstrate corresponding solutions. Firstly, it is revealed that utilizing a redox-active KBr electrolyte can enhance both operating voltage and capacitance, and hence increases energy density without sacrificing power density or cycle life. Secondly, an evaluation of elevated temperature influence on the capacitive performance of ECs containing ionic liquid (IL) electrolyte demonstrates a high working temperature beyond 120 °C. Thirdly, a systematic investigation of ECs containing IL at elevated temperatures shows a significant increase of the self-discharge rate with temperature and pinpoints the underlying mechanisms; at lower initial voltages the self-discharge rate is dominated by diffusion of electrolyte ions rather than charge redistribution. Fourthly, the addition of a small amount of liquid crystals (LC) in neutral electrolyte shows a reduction of self-discharge and leakage current due to slower diffusion of ions in the device, which is proposed to originate from the anisotropic properties of LC. Finally, by utilizing the thermocapacitive effect, a thermal charging of ECs containing IL is demonstrated, where a high voltage of more than 900 mV could be recovered when two devices in series are exposed to a 60 °C temperature environment.
|
|
| 3. |
- Haque, Mohammad Mazharul, 1984, et al.
(författare)
-
Exploiting low-grade waste heat to produce electricity through supercapacitor containing carbon electrodes and ionic liquid electrolytes
- 2022
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686. ; 403
-
Tidskriftsartikel (refereegranskat)abstract
- Low-grade thermal energy harvesting presents great challenges to traditional thermoelectric systems based on the Seebeck effect, the thermogalvanic effect, and the Soret effect due to fixed temperature gradient and low voltage output. In this study, we report an ionic thermoelectric system, essentially a supercapacitor (SC) containing an ionic liquid (IL) electrolyte and activated carbon electrodes, which works on the thermocapacitive effect and does not require any fixed temperature gradient, rather it works in a homogeneously changing temperature. A systematic investigation is carried out on SCs containing two different ILs, 1-Ethyl-3-methylimidazolium bis (trifluoromethylsulfonyl), EMIm TFSI, and 1-Ethyl-3-methylimidazolium acetate, EMIm OAc. A high voltage output of 176 mV is achieved for EMIm TFSI containing SC by exposing just to 60 °C environment. Moreover, a large voltage of 502 mV is recovered from the SC upon subjecting to heat after one electrical charge/discharge cycle. A system containing two SCs in series demonstrates a significant voltage of 947 mV. The observed performance difference between the two ILs is rationalized in terms of the extent of asymmetry in the interfaces of the electrical double layer that essentially originates from different diffusivity of individual ions. The mechanism can be applied to a plethora of ILs to exploit low-grade heat to store electricity without a fixed temperature gradient, opening up the possibility to merge different scientific communities and enrich this rising research field.
|
|
| 4. |
- Haque, Mohammad Mazharul, 1984, et al.
(författare)
-
Identification of self-discharge mechanisms of ionic liquid electrolyte based supercapacitor under high-temperature operation
- 2021
-
Ingår i: Journal of Power Sources. - : Elsevier BV. - 0378-7753. ; 485
-
Tidskriftsartikel (refereegranskat)abstract
- Ionic liquids (ILs) are promising electrolytes for supercapacitors (SCs) aimed for high-temperature applications, where increased ionic conductivity results in superior capacitive performance compared to room temperature (RT) performance. However, an increased temperature also accelerates the self-discharge rate that adversely affects energy retention and restricts the usage of SCs in standalone applications. In this study, a detailed electrochemical investigation on the self-discharge behaviour of carbon-based SCs containing an IL, 1-Ethyl-3-methylimidazolium acetate (EMIM Ac), has been carried out in the temperature range RT - 60 °C, and the underlying self-discharge mechanisms are identified. The results reveal that at a high voltage of 1.5 V, the self-discharge is characterized by a combination of charge redistribution and diffusion at both RT and 60 °C. At 60 °C, the diffusion-controlled mechanism dominates at lower voltages over the charge redistribution effect, while at RT both mechanisms contribute to a similar extent. The observed difference in the self-discharge mechanism between RT and 60 °C is explained in terms of a decreased RC time constant (τRC) at elevated temperature, and the same conclusions are potentially applicable to other IL-containing SCs as well.
|
|
| 5. |
- Haque, Mohammad Mazharul, 1984, et al.
(författare)
-
Ionic liquid electrolyte for supercapacitor with high temperature compatibility
- 2017
-
Ingår i: Journal of Physics: Conference Series. - : IOP Publishing. - 1742-6588 .- 1742-6596. ; 922:1
-
Konferensbidrag (refereegranskat)abstract
- This work describes the electrochemical investigation of two ionic liquids (ILs), 1-ethyl-3-methylimidazolium acetate (EMIM Ac) and 1-butyl-3-methylimidazolium chloride (BMIM Cl), as electrolytes in supercapacitors (SC). A comprehensive study on high temperature (HT) endurance that is required for system integration in microelectronics has also been carried out. It has been found that EMIM Ac containing SC performs better than a BMIM Cl containing SC, and HT treatment improves the capacitive performance.
|
|
| 6. |
- Haque, Mohammad Mazharul, 1984, et al.
(författare)
-
Self-discharge and leakage current mitigation of neutral aqueous-based supercapacitor by means of liquid crystal additive
- 2020
-
Ingår i: Journal of Power Sources. - : Elsevier BV. - 0378-7753. ; 453
-
Tidskriftsartikel (refereegranskat)abstract
- Self-discharge is being recognized as one of the main obstacles to implementing the supercapacitor (SC) in standalone self-powered systems. Strategies for addressing this issue include the modification of electrodes, electrolytes, separators, and diverse device configurations. However, an improved self-discharge behavior is often achieved with a large compromise on other prominent figures of merit such as capacitance, energy density, or cycle life of the device. In this work, a thorough comparative electrochemical investigation of SCs containing a neutral aqueous electrolyte, 1 M Li2SO4, and with a liquid crystal (LC) additive, 2% 4-n-pentyl-4′-cyanobiphenyl (5CB) in 1 M Li2SO4, has been carried out at different states of charge. The results demonstrate that the device containing the LC additive 5CB exhibits a reduced self-discharge and leakage current without compromising the capacitive performance at different nominal voltages compared to the behavior of the device without 5CB. We suggest an explanation of the difference of the self-discharge behavior between the devices through tunability of the effective conductivity of the electrolyte composite upon applied voltages. As a result, in an open circuit condition, the device containing LC shows a slower diffusion of ions that facilitates a decreased self-discharge and leakage current.
|
|
| 7. |
- Haque, Mohammad Mazharul, 1984, et al.
(författare)
-
Thermal influence on the electrochemical behavior of a supercapacitor containing an ionic liquid electrolyte
- 2018
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686. ; 263, s. 249-260
-
Tidskriftsartikel (refereegranskat)abstract
- Emerging demands on heat-durable electronics have accelerated the need for high temperature supercapacitors as well as for understanding the influence of elevated temperatures on the capacitive behavior. In this work, we present a comprehensive study of the thermal influence on a supercapacitor containing 1-ethyl-3-methylimidazolium acetate (EMIM Ac) electrolyte and activated carbon (AC) electrodes. The performance variation as a function of temperature in a range from 21 °C to 150 °C reveals that a high specific capacitance of 142 F g−1 can be achieved at 150 °C at a current density of 2 A g−1 with a rate capability of 87% at 15 A g−1 (relative to 2 A g−1). At 150 °C, equivalent series resistance (ESR) is only 0.37 Ω cm2, which is a result of improved ionic conductivity of the electrolyte at elevated temperature. The ESR value of 2.5 Ω cm2 at room temperature reflects a good compatibility between EMIM Ac and AC. In addition, a capacitance retention of more than 95% (in the end of 1000 cycles) is maintained up to120 °C followed by 85% at 150 °C. These results confirm EMIM Ac as a suitable candidate for carbon-based high temperature supercapacitors, and the observations regarding the thermal influence on performance metrics e.g. usable operation voltage could be applicable to other energy storage devices.
|
|
| 8. |
- Kuzmenko, Volodymyr, 1987, et al.
(författare)
-
Capacitive effects of nitrogen doping on cellulose-derived carbon nanofibers
- 2015
-
Ingår i: Materials Chemistry and Physics. - : Elsevier BV. - 0254-0584. ; 160, s. 59-65
-
Tidskriftsartikel (refereegranskat)abstract
- Carbons with valuable electrochemical characteristics are among the most convenient electrode materials used for energy storage. At the moment, their production is mostly reliant on unsustainable fossil fuels. A preferential sustainable production of enhanced carbonaceous electrodes can be achieved with more extensive utilization of abundant renewable resources instead of fossils. In this study, nitrogen-doped carbon nanofibers (CNFs) were synthesized from cellulose, the most abundant renewable resource, via consecutive steps of cellulose acetate electrospinning, subsequent deacetylation to cellulose, impregnation with nitrogen-containing additive (ammonium chloride), and carbonization. Results of material characterization showed that the carbonization of functionalized cellulose samples led to formation of CNFs doped with 4–5.6 at.% of nitrogen. In comparison with pristine CNFs N-doped samples had a slightly lower specific surface area, but higher conductivity and hydrophilicity. Moreover, electrochemical measurements indicated that the enhanced N-doped materials had about 2.5 times higher specific capacitance which was increasing throughout 1000 charge–discharge cycles. These results suggest that nitrogen doping method used in this study has a positive pseudocapacitive effect on the electrochemical performance of carbonized cellulose materials.
|
|
| 9. |
|
|
| 10. |
- Kuzmenko, Volodymyr, 1987, et al.
(författare)
-
Carbon nanotubes/nanofibers composites from cellulose for supercapacitors
- 2014
-
Ingår i: 16th European Conference on Composite Materials, ECCM 2014; Seville; Spain; 22 June 2014 through 26 June 2014.
-
Konferensbidrag (refereegranskat)abstract
- Cellulose-based carbon nanofibers (CNFs) with high mechanical strength and electrochemical stability were nitrogen-doped and functionalized with carbon nanotubes (CNTs) via two different methods. The diameter of incorporated CNTs was in the range of 1-20 nm. The doping with nitrogen atoms and incorporation of CNTs into the CNFs improved conductivity, while CNTs also increased surface area of the produced material. As a result, the composite materials with capacitance values up to 241 F/g were obtained.
|
|
