1. |
- Yang, Liyun, 1992-, et al.
(author)
-
Impact of Procedure Type, Case Duration, and Adjunctive Equipment on Surgeon Intraoperative Musculoskeletal Discomfort
- 2020
-
In: Journal of the American College of Surgeons. - : ELSEVIER SCIENCE INC. - 1072-7515 .- 1879-1190. ; 230:4, s. 554-560
-
Journal article (peer-reviewed)abstract
- BACKGROUND: Surgeons are at high risk of developing musculoskeletal disorders. STUDY DESIGN: This study was designed to identify risk factors and assess intraoperative physical stressors using subjective and objective measures, including type of procedure and equipment used. Wearable sensors and pre- and postoperation surveys were analyzed. RESULTS: Data from 116 cases (34 male and 19 female surgeons) were collected across surgical specialties. Surgeons reported increased pain in the neck, upper, and lower back both during and after operations. High-stress intraoperative postures were also revealed by the real-time measurement in the neck and back. Surgical duration also impacted physical pain and fatigue. Open procedures had more stressful physical postures than laparoscopic procedures. Loupe usage negatively impacted neck postures. CONCLUSIONS: This study highlights the fact that musculoskeletal disorders are common in surgeons and characterizes surgeons' intraoperative posture as well as surgeon pain and fatigue across specialties. Defining intraoperative ((C) 2020 The Author(s). Published by Elsevier Inc. on behalf of the American College of Surgeons.
|
|
2. |
- Hooke, Alexander W., et al.
(author)
-
Mechanical Assessment of Tissue Properties During Tourniquet Application
- 2021
-
In: Military medicine. - : OXFORD UNIV PRESS. - 0026-4075 .- 1930-613X. ; 186, s. 378-383
-
Journal article (peer-reviewed)abstract
- Introduction: Successful tourniquet application increases survival rate of exsanguinating extremity hemorrhage victims. Tactile feedback during tourniquet application training should reflect human tissue properties in order to increase success in the field. This study aims to understand the mechanical properties of a human limb during tourniquet application. Method: Six cadaveric extremities-three uppers and three lowers-were tested from three body mass index groups: low (<19) healthy (19-24), and overweight (>24). Each specimen donned with a tourniquet and mounted to a servo-hydraulic testing machine, which enabled controlled tightening of the tourniquet while recording the tourniquet tension force and strap displacement. A thin-film pressure sensor placed between the specimen and the tourniquet recorded contact pressure. Each limb was tested with the tourniquet applied at two different sites resulting in testing at the upper arm, forearm, thigh, and shank. Results: The load displacement curves during radial compression were found to be nonlinear overall, with identifiable linear regions. Average contact pressure under the tourniquet strap at 200N and 300N of tension force was 126.3 (sigma= 41.2) mm Hg and 205.3 (sigma = 75.3) mm Hg, respectively. There were no significant differences in tissue stiffness or contact pressure at 300N of tension force between limb (upper vs. lower) or body mass index. At 200N of tension, the upper limb had significantly higher contact pressure than the lower limb (P= 0.040). Relative radial compression was significantly different between upper (16.74, sigma = 4.16%) and lower (10.15, sigma = 2.25%) extremities at 200N tension (P= 0.005). Conclusions: Simulation of tissue compression during tourniquet application may be achieved with a material exhibiting elastic properties to mimic the force-displacement behavior seen in cadaveric tissue or with different layers of material. Different trainers for underweight, healthy, and overweight limbs may not be needed. Separate tourniquet training fixtures should be created for the upper and lower extremities.
|
|