1. |
|
|
2. |
|
|
3. |
|
|
4. |
|
|
5. |
|
|
6. |
- Blumel, Edda, et al.
(author)
-
Staphylococcal alpha-toxin tilts the balance between malignant and non-malignant CD4+ T cells in cutaneous T-cell lymphoma
- 2019
-
In: Oncoimmunology. - : Taylor & Francis. - 2162-4011 .- 2162-402X. ; 8:11
-
Journal article (peer-reviewed)abstract
- Staphylococcus aureus is implicated in disease progression in cutaneous T-cell lymphoma (CTCL). Here, we demonstrate that malignant T cell lines derived from CTCL patients as well as primary malignant CD4+ T cells from Sézary syndrome patients are considerably more resistant to alpha-toxin-induced cell death than their non-malignant counterparts. Thus, in a subset of Sézary syndrome patients the ratio between malignant and non-malignant CD4+ T cells increases significantly following exposure to alpha-toxin. Whereas toxin-induced cell death is ADAM10 dependent in healthy CD4+ T cells, resistance to alpha-toxin in malignant T cells involves both downregulation of ADAM10 as well as other resistance mechanisms. In conclusion, we provide first evidence that Staphylococcus aureus derived alpha-toxin can tilt the balance between malignant and non-malignant CD4+ T cells in CTCL patients. Consequently, alpha-toxin may promote disease progression through positive selection of malignant CD4+ T cells, identifying alpha-toxin as a putative drug target in CTCL.
|
|
7. |
- Engstrom, C, et al.
(author)
-
High-temperature stability of epitaxial, non-isostructural Mo/NbN superlattices
- 2000
-
In: Journal of Materials Research. - 0884-2914 .- 2044-5326. ; 15:2, s. 554-559
-
Journal article (peer-reviewed)abstract
- The effect of 1000 degrees C vacuum annealing on the structure and hardness of epitaxial Mo/NbN superlattice thin films was studied. The intensity of superlattice satellite peaks, measured by x-ray diffraction, decreased during annealing while new peaks corresponding to a MoNbN ternary phase appeared. The results are consistent with the Mo-Nb-N phase diagram, which shows no mutual solubility between Mo, NbN, and MoNbN. Even after 3-h anneals and a loss of most of the superlattice peak intensity, the room-temperature hardness was the same as for as-deposited superlattices, The retained hardness suggests that a residual nanocomposite structure is retained even after the formation of the ternary structure.
|
|
8. |
- Farnocchia, Davide, et al.
(author)
-
International Asteroid Warning Network Timing Campaign: 2019 XS
- 2022
-
In: The Planetary Science Journal. - : Institute of Physics Publishing (IOPP). - 2632-3338. ; 3:7
-
Journal article (peer-reviewed)abstract
- As part of the International Asteroid Warning Network's observational exercises, we conducted a campaign to observe near-Earth asteroid 2019 XS around its close approach to Earth on 2021 November 9. The goal of the campaign was to characterize errors in the observation times reported to the Minor Planet Center, which become an increasingly important consideration as astrometric accuracy improves and more fast-moving asteroids are observed. As part of the exercise, a total of 957 astrometric observations of 2019 XS during the encounter were reported and subsequently were analyzed to obtain the corresponding residuals. While the timing errors are typically smaller than 1 s, the reported times appear to be negatively biased, i.e., they are generally earlier than they should be. We also compared the observer-provided position uncertainty with the cross-track residuals, which are independent of timing errors. A large fraction of the estimated uncertainties appear to be optimistic, especially when <0 2. We compiled individual reports for each observer to help identify and remove the root cause of any possible timing error and improve the uncertainty quantification process. We suggest possible sources of timing errors and describe a simple procedure to derive reliable, conservative position uncertainties.
|
|
9. |
- Fredholm, Simon, et al.
(author)
-
SATB1 in Malignant T Cells
- 2018
-
In: Journal of Investigative Dermatology. - : Elsevier. - 0022-202X .- 1523-1747. ; 138:8, s. 1805-1815
-
Journal article (peer-reviewed)abstract
- Deficient expression of SATB1 hampers thymocyte development and results in inept T-cell lineages. Recent data implicate dysregulated SATB1 expression in the pathogenesis of mycosis fungoides, the most frequent variant of cutaneous T-cell lymphoma. Here, we report on a disease stage-associated decrease of SATB1 expression and an inverse expression of STAT5 and SATB1 in situ. STAT5 inhibited SATB1 expression through induction of microRNA-155. Decreased SATB1 expression triggered enhanced expression of IL-5 and IL-9 (but not IL-6 and IL-32), whereas increased SATB1 expression had the opposite effect, indicating that the microRNA-155 target SATB1 is a repressor of IL-5 and IL-9 in malignant T cells. In accordance, inhibition of STAT5 and its upstream activator JAK3 triggered increased SATB1 expression and a concomitant suppression of IL-5 and IL-9 expression in malignant T cells. In conclusion, we provide a mechanistic link between the proto-oncogenic JAK3/STAT5/microRNA-155 pathway, SATB1, and cytokines linked to CTCL severity and progression, indicating that SATB1 dysregulation is involved in cutaneous T-cell lymphoma pathogenesis.
|
|
10. |
- Jacobsohn, L. G, et al.
(author)
-
Role of intericosahedral chains on hardness of sputtered boron carbide films
- 2004
-
In: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 84:21, s. 4173-
-
Journal article (peer-reviewed)abstract
- The relationship between the structure and mechanical properties of sputter-deposited boron carbide films was investigated. Changes in the structure induced by annealing were characterized in terms of chemical composition, chemical bonding, and concentrations of defects and trapped impurities. The creation of intericosahedral chains for higher annealing temperatures was revealed by infrared and Raman measurements, and the intensity of the infrared band at 1500 cm–1 was found to be related to the hardness. The presence of residual trapped Ar atoms and of open-volume defects is insensitive to relatively high annealing temperatures and does not influence the recovery of the hardness. Our results suggest postdeposition annealing as a pathway to enhance the mechanical properties of boron carbide films.
|
|