1. |
- Ardenfors, Oscar, et al.
(author)
-
Organ doses from a proton gantry-mounted cone-beam computed tomography system characterized with MCNP6 and GATE
- 2018
-
In: Physica medica (Testo stampato). - : Elsevier BV. - 1120-1797 .- 1724-191X. ; 53, s. 56-61
-
Journal article (peer-reviewed)abstract
- PurposeTo determine organ doses from a proton gantry-mounted cone-beam computed tomography (CBCT) system using two Monte Carlo codes and to study the influence on organ doses from different acquisition modes and repeated imaging.MethodsThe CBCT system was characterized with MCNP6 and GATE using measurements of depth doses in water and spatial profiles in air. The beam models were validated against absolute dose measurements and used to simulate organ doses from CBCT imaging with head, thorax and pelvis protocols. Anterior and posterior 190° scans were simulated and the resulting organ doses per mAs were compared to those from 360° scans. The influence on organ doses from repeated imaging with different imaging schedules was also investigated.ResultsThe agreement between MCNP6, GATE and measurements with regard to depth doses and beam profiles was within 4% for all protocols and the corresponding average agreement in absolute dose validation was 4%. Absorbed doses for in-field organs from 360° scans ranged between 6 and 8 mGy, 15–17 mGy and 24–54 mGy for the head, thorax and pelvis protocols, respectively. Cumulative organ doses from repeated CBCT imaging ranged between 0.04 and 0.32 Gy for weekly imaging and 0.2–1.6 Gy for daily imaging. The anterior scans resulted in an average increase in dose per mAs of 24% to the organs of interest relative to the 360° scan, while the posterior scan showed a 37% decrease.ConclusionsA proton gantry-mounted CBCT system was accurately characterized with MCNP6 and GATE. Organ doses varied greatly depending on acquisition mode, favoring posterior scans.
|
|
2. |
- Behling, Rolf, et al.
(author)
-
Microparticle Hybrid Target Simulation for keV X-ray Sources
- 2024
-
In: Instruments. - : Multidisciplinary Digital Publishing Institute (MDPI). - 2410-390X. ; 8:2
-
Journal article (peer-reviewed)abstract
- The spatiotemporal resolution of diagnostic X-ray images obtained with rotating-anode X-ray tubes has remained limited as the development of rigid, high-performance target materials has slowed down. However, novel imaging techniques using finer detector pixels and orthovolt cancer therapy employing narrow X-ray focal spots demand improved output from brilliant keV X-ray sources. Since its advent in 1929, rotating-anode technology has become the greatest bottleneck to improvement. To overcome this limitation, the current authors have devised a novel X-ray generation technology based on tungsten microparticle targets. The current study investigated a hybrid solution of a stream of fast tungsten microparticles and a rotating anode to both harvest the benefits of the improved performance of the new solution and to reuse known technology. The rotating anode captures energy that may pass a partially opaque microparticle stream and thereby contributes to X-ray generation. With reference to fast-rotating anodes and a highly appreciated small focal spot of a standardized size of 0.3 for an 8° target angle (physical: 0.45 mm × 4.67 mm), we calculated a potential output gain of at least 85% for non-melting microparticles and of 124% if melting is envisioned. Microparticle charging can be remediated by electron backscattering and electron field emission. The adoption of such a solution enables substantially improved image resolution.
|
|
3. |
- Bujila, Robert, et al.
(author)
-
Practical approaches to approximating MTF and NPS in CT with an example application to task-based observer studies
- 2017
-
In: Physica medica (Testo stampato). - : Elsevier BV. - 1120-1797 .- 1724-191X. ; 33, s. 16-25
-
Journal article (peer-reviewed)abstract
- Purpose: To investigate two methods of approximating the Modulation Transfer Function (MTF) and Noise Power Spectrum (NPS) in computed tomography (CT) for a range of scan parameters, from limited image acquisitions. Methods: The two methods consist of 1) using a linear systems approach to approximate the NPS for different filtered backprojection (FBP) kernels with a filter function derived from the kernel ratio of determined MTFs and 2) using an empirical fitted model to approximate the MTF and NPS. In both cases a scaling function accounts for variations in mAs and kV. The two methods of approximating the MTF/ NPS are further investigated by comparing image quality figure of merits (FOM) d' and AUC calculated using approximations of the MTF/NPS and MTF/NPS that have been determined for different mAs/kV levels and reconstruction kernels. Results: The greatest RMSE for NPS approximated for a range of mAs/kVp/convolution kernels using both methods and compared to determined NPS was 0.05 of the peak value. The RMSE for FOM with the kernel ratio method were at most 0.1 for d' and 0.01 for the AUC. Using the empirical model method, the RMSE for FOM were at most 0.02 for d' and 0.001 for the AUC. Conclusions: The two methods proposed in this paper can provide a convenient way of approximating the MTF and NPS for use in, among other things, mathematical observer studies. Both methods require a relatively small number of direct determinations of NPS from scan acquisitions to model the NPS/MTF for arbitrary mAs and kV.
|
|
4. |
|
|
5. |
|
|
6. |
- Holstensson, Maria, et al.
(author)
-
Comparison of acquisition protocols for ventilation/perfusion SPECT - a Monte Carlo study
- 2019
-
In: Physics in Medicine and Biology. - : Institute of Physics (IOP). - 0031-9155 .- 1361-6560. ; 64:23
-
Journal article (peer-reviewed)abstract
- One of the most commonly used imaging techniques for diagnosing pulmonary embolism (PE) is ventilation/perfusion (V/P) scintigraphy. The aim of this study was to evaluate the performance of the currently used imaging protocols for V/P single photon emission computed tomography (V/P SPECT) at two nuclear medicine department sites and to investigate the effect of altering important protocol parameters. The Monte Carlo technique was used to simulate 4D digital phantoms with perfusion defects. Six imaging protocols were included in the study and a total of 72 digital patients were simulated. Six dually trained radiologists/nuclear medicine physicians reviewed the images and reported all perfusion mismatch findings. The radiologists also visually graded the image quality. No statistically significant differences in diagnostic performance were found between the studied protocols, but visual grading analysis pointed out one protocol as significantly superior to four of the other protocols. Considering the study results, we have decided to harmonize our clinical protocols for imaging patients with suspected PE. The administered Technegas and macro aggregated albumin activities have been altered, a low energy all purpose collimator is used instead of a low energy high resolution collimator and the acquisition times have been lowered.
|
|
7. |
- Lindstrom, Jan, et al.
(author)
-
Experimental assessment of a phosphor model for estimating the relative extrinsic efficiency in radioluminescent detectors
- 2020
-
In: Physica medica (Testo stampato). - : Elsevier. - 1120-1797 .- 1724-191X. ; 76, s. 117-124
-
Journal article (peer-reviewed)abstract
- Optimising phosphor screens in dose detectors or imaging sensor designs is a cumbersome and time- consuming work normally involving specialised measuring equipment and advanced modelling. It is known that crucial optical parameters of the same phosphor may vary within a wide range of values. The aim of this work was to experimentally assess a simple previously published model where the case specific optical parameters (scattering and absorption) are instead represented by a fixed, single parameter, the light extinction factor, xi. The term extrinsic efficiency, N, of a phosphor is also introduced, differing from the common denotation "absolute efficiency", after noting that unknown factors (such as temperature dependence) can have an influence during efficiency estimations and hence difficult to claim absoluteness. N is expressed as the ratio of light energy emitted per unit area at the phosphor surface to incident x-ray energy fluence. By focusing on ratios and relative changes in this study, readily available instruments in a Medical Physics Department (i.e. a photometer) could be used. The varying relative extrinsic efficiency for an extended range of particle sizes (7.5 and 25 mu m) and layer thicknesses (220 to 830 mu m) were calculated in the model from the input parameters: the mean particle size of the phosphor, the layer thickness, the light extinction factor and the calculated energy imparted to the layer. In-house manufactured screens (Gd2O2S:Tb) were used for better control of design parameters. The model provided good qualitative agreement to experiment with quantitative deviations in relative extrinsic efficiency within approximately 2%.
|
|
8. |
- Nowik, Patrik, et al.
(author)
-
The dosimetric impact of including the patient table in CT dose estimates
- 2017
-
In: Physics in Medicine and Biology. - : IOP Publishing. - 0031-9155 .- 1361-6560. ; 62:23, s. 538-547
-
Journal article (peer-reviewed)abstract
- The purpose of this study was to evaluate the dosimetric impact of including the patient table in Monte Carlo CT dose estimates for both spiral scans and scan projection radiographs (SPR). CT scan acquisitions were simulated for a Siemens SOMATOM Force scanner (Siemens Healthineers, Forchheim, Germany) with and without a patient table present. An adult male, an adult female and a pediatric female voxelized phantom were simulated. The simulated scans included tube voltages of 80 and 120 kVp. Spiral scans simulated without a patient table resulted in effective doses that were overestimated by approximately 5 % compared to the same simulations performed with the patient table present. Doses in selected individual organs (breast, colon, lung, red bone marrow and stomach) were overestimated by up to 8 %. Effective doses from SPR acquired with the X-ray tube stationary at 6 o'clock (posterior-anterior) were overestimated by 14-23 % when the patient table was not included, with individual organ dose discrepancies (breast, colon, lung red bone marrow and stomach) all exceeding 13%. The reference entrance skin dose to the back were in this situation overestimated by 6-15 %. These results highlight the importance of including the patient table in patient dose estimates for such scan situations.
|
|
9. |
- Poludniowski, Gavin, et al.
(author)
-
Vector Meson Photoproduction from the BFKL Equation II: Phenomenology
- 2003
-
In: Journal of High Energy Physics (JHEP). - : Springer Science and Business Media LLC. - 1126-6708 .- 1029-8479. ; 12, s. 002-
-
Journal article (peer-reviewed)abstract
- Diffractive vector meson photoproduction accompanied by proton dissociation is studied for large momentum transfer. The process is described by the non-forward BFKL equation which we use to compare to data collected at the HERA collider.
|
|
10. |
- Ödén, Jakob, et al.
(author)
-
Comparison of CT-number parameterization models for stoichiometric CT calibration in proton therapy
- 2018
-
In: Physica medica (Testo stampato). - : Elsevier BV. - 1120-1797 .- 1724-191X. ; 47, s. 42-49
-
Journal article (peer-reviewed)abstract
- Purpose: This study compares the predictions of three parameterization models used in previously published works, implementing the stoichiometric CT calibration for proton therapy, and a further two alternative parameterizations suggested here. Methods: Stoichiometric calibrations of patient CT-number to stopping-power ratio (SPR) were performed for four CT protocols using tissue substitutes supplied by CIRS (CIRS Inc., Norfolk, VA, USA). To evaluate robustness of the five models (Sch96/Sch00/Mar12/Karol/Spek), the calibration was repeatedly simulated by randomly perturbing the measured CT-numbers of the tissue substitutes (1 sigma:10HU). The impact of high-Z content was assessed through calibrations where the two substitutes with barium content were replaced by hypothetical materials without barium. Results: The stoichiometric calibrations generally agreed within 1% between the models, for non-bony tissues. For higher CT-numbers, a well-known 2-parameter model (Sch00) generated larger SPRs compared to the other models, with inter-model discrepancies of up to 3%. The 95% coverage interval of the calibrations obtained from the robustness analysis varied substantially. The well-known 2- and 3-parameter models (Sch00/Sch96) had the largest intervals. However, the partly-hypothetical (i.e. no barium) input data generated calibrations that agreed within 1% over the whole CT scale for all models and improved the 95% coverage interval of the well-known models (Sch00/Sch96). Conclusion: All parameterization models performed comparably if the scanned materials only contained elements with Z <= 20. However, the two alternative models proposed here (Karol/Spek), together with a previously published 1-parameter model (Mar12), generated robust calibrations in close agreement even when tissue substitutes contain elements with higher atomic number.
|
|