1. |
- Edgecock, T. R., et al.
(author)
-
High intensity neutrino oscillation facilities in Europe
- 2013
-
In: Physical Review Special Topics - Accelerators and Beams. - : American Physical Society. - 1098-4402. ; 16:2, s. 021002-
-
Journal article (peer-reviewed)abstract
- The EUROnu project has studied three possible options for future, high intensity neutrino oscillation facilities in Europe. The first is a Super Beam, in which the neutrinos come from the decay of pions created by bombarding targets with a 4 MW proton beam from the CERN High Power Superconducting Proton Linac. The far detector for this facility is the 500 kt MEMPHYS water Cherenkov, located in the Frejus tunnel. The second facility is the Neutrino Factory, in which the neutrinos come from the decay of mu(+) and mu(-) beams in a storage ring. The far detector in this case is a 100 kt magnetized iron neutrino detector at a baseline of 2000 km. The third option is a Beta Beam, in which the neutrinos come from the decay of beta emitting isotopes, in particular He-6 and Ne-18, also stored in a ring. The far detector is also the MEMPHYS detector in the Frejus tunnel. EUROnu has undertaken conceptual designs of these facilities and studied the performance of the detectors. Based on this, it has determined the physics reach of each facility, in particular for the measurement of CP violation in the lepton sector, and estimated the cost of construction. These have demonstrated that the best facility to build is the Neutrino Factory. However, if a powerful proton driver is constructed for another purpose or if the MEMPHYS detector is built for astroparticle physics, the Super Beam also becomes very attractive.
|
|
2. |
- Abele, H., et al.
(author)
-
Particle physics at the European Spallation Source
- 2023
-
In: Physics reports. - : Elsevier. - 0370-1573 .- 1873-6270. ; 1023, s. 1-84
-
Research review (peer-reviewed)abstract
- Presently under construction in Lund, Sweden, the European Spallation Source (ESS) will be the world’s brightest neutron source. As such, it has the potential for a particle physics program with a unique reach and which is complementary to that available at other facilities. This paper describes proposed particle physics activities for the ESS. These encompass the exploitation of both the neutrons and neutrinos produced at the ESS for high precision (sensitivity) measurements (searches).
|
|
3. |
- Baussan, E., et al.
(author)
-
A very intense neutrino super beam experiment for leptonic CP violation discovery based on the European spallation source linac
- 2014
-
In: Nuclear Physics B. - : Elsevier BV. - 0550-3213 .- 1873-1562. ; 885, s. 127-149
-
Journal article (peer-reviewed)abstract
- Very intense neutrino beams and large neutrino detectors will be needed in order to enable the discovery of CP violation in the leptonic sector. We propose to use the proton linac of the European Spoliation Source currently under construction in Lund, Sweden, to deliver, in parallel with the spoliation neutron production, a very intense, cost effective and high performance neutrino beam. The baseline program for the European Spoliation Source linac is that it will be fully operational at 5 MW average power by 2022, producing 2 GeV 2.86 ms long proton pulses at a rate of 14 Hz. Our proposal is to upgrade the linac to 10 MW average power and 28 Hz, producing 14 pulses/s for neutron production and 14 pulses/s for neutrino production. Furthermore, because of the high current required in the pulsed neutrino horn, the length of the pulses used for neutrino production needs to be compressed to a few mu s with the aid of an accumulator ring. A long baseline experiment using this Super Beam and a megaton underground Water Cherenkov detector located in existing mines 300-600 km from Lund will make it possible to discover leptonic CP violation at 5 sigma significance level in up to 50% of the leptonic Dirac CP-violating phase range. This experiment could also determine the neutrino mass hierarchy at a significance level of more than 3 sigma if this issue will not already have been settled by other experiments by then. The mass hierarchy performance could be increased by combining the neutrino beam results with those obtained from atmospheric neutrinos detected by the same large volume detector. This detector will also be used to measure the proton lifetime, detect cosmological neutrinos and neutrinos from supernova explosions. Results on the sensitivity to leptonic CP violation and the neutrino mass hierarchy are presented.
|
|
4. |
- Aguilar, J., et al.
(author)
-
Search for Leptonic CP Violation with the ESSnuSBplus Project
- 2024
-
In: Letters in High Energy Physics. - : Andromeda Publishing And Academic Services LTD. - 2632-2714.
-
Journal article (peer-reviewed)abstract
- ESSνSB is a design study for a next-generation long-baseline neutrino experiment that aims at the precise measurement of the CP-violating phase, δCP, in the leptonic sector at the second oscillation maximum. The conceptual design report published from the first phase of the project showed that after 10 years of data taking, more than 70% of the possible δCP range will be covered with 5σ C.L. to reject the no-CP-violation hypothesis. The expected value of δCP precision is smaller than 8◦ for all δCP values. The next phase of the project, the ESSνSB+, aims at using the intense muon flux produced together with neutrinos to measure the neutrino-nucleus cross-section, the dominant term of the systematic uncertainty, in the energy range of 0.2–0.6 GeV, using a Low Energy neutrinos from STORed Muons (LEnuSTORM) and a Low Energy Monitored Neutrino Beam (LEMNB) facilities.
|
|
5. |
- Burgman, A., et al.
(author)
-
The European Spallation Source neutrino super-beam conceptual design report
- 2022
-
In: The European Physical Journal Special Topics. - : Springer Nature. - 1951-6355 .- 1951-6401. ; 231:21, s. 3779-3955
-
Research review (peer-reviewed)abstract
- A design study, named ESSνSB for European Spallation Source neutrino Super Beam, has been carried out during the years 2018–2022 of how the 5 MW proton linear accelerator of the European Spallation Source under construction in Lund, Sweden, can be used to produce the world’s most intense long-baseline neutrino beam. The high beam intensity will allow for measuring the neutrino oscillations near the second oscillation maximum at which the CP violation signal is close to three times higher than at the first maximum, where other experiments measure. This will enable CP violation discovery in the leptonic sector for a wider range of values of the CP violating phase δCPδCP and, in particular, a higher precision measurement of δCPδCP. The present Conceptual Design Report describes the results of the design study of the required upgrade of the ESS linac, of the accumulator ring used to compress the linac pulses from 2.86 ms to 1.2 μs, and of the target station, where the 5 MW proton beam is used to produce the intense neutrino beam. It also presents the design of the near detector, which is used to monitor the neutrino beam as well as to measure neutrino cross sections, and of the large underground far detector located 360 km from ESS, where the magnitude of the oscillation appearance of νe from νμ is measured. The physics performance of the ESSνSB research facility has been evaluated demonstrating that after 10 years of data-taking, leptonic CP violation can be detected with more than 5 standard deviation significance over 70% of the range of values that the CP violation phase angle δCPδCP can take and that δCPδCP can be measured with a standard error less than 8° irrespective of the measured value of δCPδCP. These results demonstrate the uniquely high physics performance of the proposed ESSνSBESSνSB research facility.
|
|
6. |
- Burgman, A., et al.
(author)
-
Updated physics performance of the ESSnuSB experiment
- 2021
-
In: European Physical Journal C. - : Springer Nature. - 1434-6044 .- 1434-6052. ; 81:12
-
Journal article (peer-reviewed)abstract
- In this paper, we present the physics performance of the ESSnuSB experiment in the standard three flavor scenario using the updated neutrino flux calculated specifically for the ESSnuSB configuration and updated migration matrices for the far detector. Taking conservative systematic uncertainties corresponding to a normalization error of 5% for signal and 10% for background, we find that there is 10 sigma (13 sigma) CP violation discovery sensitivity for the baseline option of 540 km (360 km) at delta(CP) = +/- 90 degrees. The corresponding fraction of delta(CP )for which CP violation can be discovered at more than 5 sigma is 70%. Regarding CP precision measurements, the 1 sigma error associated with delta(CP )= 0 degrees is around 5 degrees and with delta(CP )= -90 degrees is around 14 degrees (7 degrees) for the baseline option of 540 km (360 km). For hierarchy sensitivity, one can have 3 sigma sensitivity for 540 km baseline except delta(CP) = +/- 90 degrees and 5 sigma sensitivity for 360 km baseline for all values of delta(CP). The octant of theta(23) can be determined at 30 for the values of: theta(23) > 51 degrees (theta(23) < 42 degrees and theta(23) > 49 degrees) for baseline of 540 km (360 km). Regarding measurement precision of the atmospheric mixing parameters, the allowed values at 3 sigma are: 40 degrees < theta(23) < 52 degrees (42 degrees < theta(23) < 51.5 degrees) and 2.485 x 10(-3) eV(2) < Delta(2)(m31) < 2.545 x 10(-3) eV(2) (2.49x 10(-3 ) eV(2) < Delta(2)(m31) < 2.54 x 10(-3) eV(2)) for the baseline of 540 km (360 km).
|
|
7. |
- Aguilar, J., et al.
(author)
-
Study of nonstandard interactions mediated by a scalar field at the ESSnuSB experiment
- 2024
-
In: Physical Review D. - : American Physical Society. - 2470-0010 .- 2470-0029. ; 109:11
-
Journal article (peer-reviewed)abstract
- In this paper, we study scalar mediator induced nonstandard interactions (SNSIs) in the context of the ESSnuSB experiment. In particular, we study the capability of ESSnuSB to put bounds on the SNSI parameters and also study the impact of SNSIs in the measurement of the leptonic CP phase δCP. Existence of SNSIs modifies the neutrino mass matrix and this modification can be expressed in terms of three diagonal real parameters (ηee, ημμ, and ηττ) and three off-diagonal complex parameters (ηeμ, ηeτ, and ημτ). Our study shows that the upper bounds on the parameters ημμ and ηττ depend upon how Δm312 is minimized in the theory. However, this is not the case when one tries to measure the impact of SNSIs on δCP. Further, we show that the CP sensitivity of ESSnuSB can be completely lost for certain values of ηee and ημτ for which the appearance channel probability becomes independent of δCP.
|
|
8. |
- Burgman, A., et al.
(author)
-
The ESSnuSB Design Study: Overview and Future Prospects
- 2023
-
In: Universe. - : MDPI. - 2218-1997. ; 9:8
-
Research review (peer-reviewed)abstract
- ESSnuSB is a design study for an experiment to measure the CP violation in the leptonic sector at the second neutrino oscillation maximum using a neutrino beam driven by the uniquely powerful ESS linear accelerator. The reduced impact of systematic errors on sensitivity at the second maximum allows for a very precise measurement of the CP violating parameter. This review describes the fundamental advantages of measurement at the second maximum, the necessary upgrades to the ESS linac in order to produce a neutrino beam, the near and far detector complexes, and the expected physics reach of the proposed ESSnuSB experiment, concluding with the near future developments aimed at the project realization.
|
|
9. |
- Poussot-Vassal, C., et al.
(author)
-
Interpolatory-Based Data-Driven Pulsed Fluidic Actuator Control Design and Experimental Validation
- 2022
-
In: IEEE Transactions on Control Systems Technology. - 1063-6536. ; 30:2, s. 852-859
-
Journal article (peer-reviewed)abstract
- Pulsed fluidic actuators (PFAs) play a central role in the fluid flow experimental control strategy to achieve better performances of aeronautic devices. In this brief, we demonstrate, through an experimental test bench, how the interpolatory-based Loewner data-driven control (L-DDC) framework is an appropriate tool for accurately controlling the outflow velocity of this family of actuators. L-DDC combines the concept of ideal controller with the Loewner framework in a single data-driven rationale, appropriate to experimental users. The contributions of this brief are, first, to emphasize the simplicity and versatility of such a data-driven rationale in a constrained experimental setup and, second, to solve some practical fluid engineers concerns by detailing the complete workflow and key ingredients for successfully implementing a PFA controller from the data acquisition to the control implementation and validation stages.
|
|