1. |
|
|
2. |
- Andreeva, M. A., et al.
(author)
-
Nuclear resonant reflectivity with standing waves for the investigation of a thin 57Fe layer buried inside a superconducting Si/[Mo/Si]45/57Fe/Nb multilayer
- 2008
-
In: Nuclear Instruments and Methods in Physics Research Section B. - : Elsevier BV. - 0168-583X .- 1872-9584. ; 266:1, s. 187-196
-
Journal article (peer-reviewed)abstract
- A special multilayer sample Si/[Mo/Si]45/57Fe/Nb has been prepared for the depth selective investigations of the hyperfine fields in thin iron layer at low temperatures above and below the superconducting transition in the top Nb layer (Tc 8 K) by means of the nuclear resonant reflectivity with standing waves. The periodic multilayer [Mo/Si]45 below the iron layer in our sample was used as “a standing wave generator”. A weak magnetic hyperfine splitting in the 57Fe layer was detected just at low temperature. A slight variation of the nuclear resonant reflectivity time spectra measured above and below Tc was observed. At first it was supposed that this change of the spectrum shape is caused by the spatial modulation of ferromagnetic domains in the 57Fe layer caused by a proximity effect. A closer analysis, however, reveals that the spectrum variations are due to just the changes of the relative weights of the magnetic and paramagnetic phases in 57Fe layer.
|
|
3. |
|
|
4. |
|
|
5. |
- Komlev, Andrei A., et al.
(author)
-
Effect of the sequence of chemical transformations on the spatial segregation of components and formation of periclase-spinel nanopowders in the MgO–Fe2O3–H2O System
- 2016
-
In: Russian journal of applied chemistry. - : Maik Nauka-Interperiodica Publishing. - 1070-4272 .- 1608-3296. ; 89:12, s. 1932-1938
-
Journal article (peer-reviewed)abstract
- Specific features of the process in which oxide nanopowders are formed in a hydrothermal treatment of coprecipitated magnesium and iron oxides were studied. It was shown that the rate at which oxide nanoparticles are formed increases when reagents structurally close to the final product are used. It was found that, with the hydrothermal treatment of coprecipitated magnesium and iron hydroxides at 450°C combined with the subsequent thermal treatment in air at temperatures of 400–600°C, it is possible to obtain a homogeneous mixture of nanocrystalline powders based on an iron-containing spinel phase and magnesium oxide.
|
|