| 1. |
- Nevanen, T. K., et al.
(author)
-
Efficient enantioselective separation of drug enantiomers by immobilised antibody fragments
- 2001
-
In: Journal of Chromatography A. - 0021-9673 .- 1873-3778. ; 925:02-jan, s. 89-97
-
Journal article (peer-reviewed)abstract
- There is an increasing need for methods for efficient enantioselective separation and purification of chiral drugs. Genetic engineering provides the means for generating recombinant antibodies exhibiting extremely high specificity for even small molecular mass compounds. Here, recombinant antibody fragments have been generated for the drug diarylalkyltriazole that contains two chiral centres. Immobilised antibody fragments has been used successfully for efficient, step-wise separation of two enantiomers of the drug. Owing to the antibody specificity, one enantiomer came out in the flow-through, while the bound enantiomer could be specifically eluted. One of the antibodies tolerated solvents required both for dissolving the target molecules and for their elution for extended times and was shown to function over multiple cycles of the separation process.
|
|
| 2. |
- Gustavsson, M. T., et al.
(author)
-
Modification of cellulose fiber surfaces by use of a lipase and a xyloglucan endotransglycosylase
- 2005
-
In: Biomacromolecules. - : American Chemical Society (ACS). - 1525-7797 .- 1526-4602. ; 6:1, s. 196-203
-
Journal article (peer-reviewed)abstract
- A strategy for the modification of cellulose fiber surfaces was developed that used the ability of Candida antarctica lipase B (CALB) to acylate carbohydrates with high regioselectivity, combined with the transglycosylating activity of the Populus tremula x P. tremuloides xyloglucan endotransglycosylase 16A (PttXET16A). Xyloglucan oligosaccharides (XGOs) prepared from tamarind xyloglucan were acylated with CALB as a catalyst and vinyl stearate or gamma-thiobutyrolactone as acyl donors to produce carbohydrate molecules with hydrophobic alkyl chains or reactive sulfhydryl groups, respectively. The modified XGOs were shown to act as glycosyl acceptors in the transglycosylation reaction catalyzed by PttXET16A and could therefore be incorporated into high M-r xyloglucan chains. The resulting xyloglucan molecules exhibited a high affinity for cellulose surfaces, which enabled the essentially irreversible introduction of fatty acid esters or thiol groups to cellulose fibers.
|
|
| 3. |
- Johansson, P., et al.
(author)
-
Crystallization and preliminary X-ray analysis of a xyloglucan endotransglycosylase from Populus tremula x tremuloides
- 2003
-
In: Acta Crystallographica Section D. - 0907-4449 .- 1399-0047. ; 59, s. 535-537
-
Journal article (peer-reviewed)abstract
- Xyloglucan endotransglycosylases (XETs) cleave and religate xyloglucan polymers in plant cell walls. Recombinant XET from poplar has been purified from a Pichia pastoris expression system and crystallized. Two different crystal forms were obtained by vapour diffusion from potassium sodium tartrate and from an imidazole buffer using sodium acetate as a precipitant. Data were collected from these crystal forms to 3.5 and 2.1 Angstrom resolution, respectively. The first crystal form was found to belong to space group P3(1)21 or P3(2)21 (unit-cell parameters a = 98.6, b = 98.6, c = 98.5 Angstrom) and the second crystal form to space group P6(3) (unit-cell parameters a = 188.7, b = 188.7, c = 46.1 Angstrom).
|
|
| 4. |
- Becker, D., et al.
(author)
-
Engineering of a glycosidase Family 7 cellobiohydrolase to more alkaline pH optimum : the pH behaviour of Trichoderma reesei CeI7A and its E223S/A224H/L225V/T226A/D262G mutant
- 2001
-
In: Biochemical Journal. - 0264-6021 .- 1470-8728. ; 356, s. 19-30
-
Journal article (peer-reviewed)abstract
- The crystal structures of Family 7 glycohydrolases suggest that a histidine residue near the acid/base catalyst could account for the higher pH optimum of the Humicola insolens endoglucanase Cel7B, than the corresponding Trichoderma reesei enzymes. Modelling studies indicated that introduction of histidine at the homologous position in T. reesei Cel7A (Ala(224)) required additional changes to accommodate the bulkier histidine side chain. X-ray crystallography of the catalytic domain of the E223S/A224H/L225V/T226A/D262G mutant reveals that major differences from the wild-type are confined to the mutations themselves, The introduced histidine residue is in plane with its counterpart in H. insolens Cel7B, but is 1.0 Angstrom (= 0.1 nm) closer to the acid/base Glu(217) residue, with a 3.1 Angstrom contact between N-2 and O'(1). The pH variation of k(cat)/K-m for 3,4-dinitrophenyl lactoside hydrolysis was accurately bell-shaped for both wildtype and mutant, with pK(1) shifting from 2.22+/-0.03 in the wild-type to 3.19+/-0.03 in the mutant, and pK(2) shifting from 5.99+/-0.02 to 6.78+/-0.02. With this poor substrate, the ionizations probably represent those of the free enzyme. The relative k(cat) for 2-chloro-4-nitrophenyl lactoside showed similar behaviour. The shift in the mutant pH optimum was associated with lower k(cat)/K-m values for both lactosides and cellobiosides, and a marginally lower stability. However, k(cat) values for cellobiosides are higher for the mutant. This we attribute to reduced nonproductive binding in the +1 and +2 subsites; inhibition by cellobiose is certainly relieved in the mutant. The weaker binding of cellobiose is due to the loss of two water-mediated hydrogen bonds.
|
|
| 5. |
- Christiernin, M., et al.
(author)
-
The effects of xyloglucan on the properties of paper made from bleached kraft pulp
- 2003
-
In: Nordic Pulp & Paper Research Journal. - : Walter de Gruyter GmbH. - 0283-2631 .- 2000-0669. ; 18:2, s. 182-187
-
Journal article (peer-reviewed)abstract
- Xyloglucan was adsorbed onto bleached soft-wood kraft pulp followed by preparation and analysis of handsheets with respect to sheet formation as well as sheet mechanical and optical properties. Adsorption of xyloglucan was found to be slow. After more than 20 hrs adsorption, equilibrium had not been reached. The amount of xyloglucan adsorbed increased with beating, but neither the rate of adsorption nor the quantity adsorbed was significantly affected by temperature. Xyloglucan was found to be practically irreversibly adsorbed onto the fibres and the effects of xyloglucan on paper sheet properties were investigated after thorough washing of the pulp. The adsorption characteristics of xyloglucan confirm observations by other authors on other cellulose substrates. Tensile index values for handsheets formed with the xyloglucan-containing pulps were higher than those measured for control pulps with a comparable beating degree. The light scattering coefficient was, however, not affected by xyloglucan adsorption. Hence, the increase in tensile strength is attributed to an increased relative bond strength between the fibres. Tensile strength versus tear strength relationship was similar for pulps with and without xyloglucan, but water retention value and dewatering resistance were lower for the xyloglucan treated pulps than for the reference pulps at the same tensile strength. In addition, formation was improved for pulps with adsorbed xyloglucan. The conclusion is that xyloglucan is a promising wet end additive that decreases the necessity for beating of the pulp and improves the formation of paper.
|
|
| 6. |
|
|
| 7. |
- Koivula, Anu, et al.
(author)
-
The active site of cellobiohydrolase Cel6A from Trichoderma reesei: the roles of aspartic acids D221 and D175.
- 2002
-
In: J Am Chem Soc. - : American Chemical Society (ACS). - 0002-7863 .- 1520-5126. ; 124:34, s. 10015-24
-
Journal article (peer-reviewed)abstract
- Trichoderma reesei cellobiohydrolase Cel6A is an inverting glycosidase. Structural studies have established that the tunnel-shaped active site of Cel6A contains two aspartic acids, D221 and D175, that are close to the glycosidic oxygen of the scissile bond and at hydrogen-bonding distance from each other. Here, site-directed mutagenesis, X-ray crystallography, and enzyme kinetic studies have been used to confirm the role of residue D221 as the catalytic acid. D175 is shown to affect protonation of D221 and to contribute to the electrostatic stabilization of the partial positive charge in the transition state. Structural and modeling studies suggest that the single-displacement mechanism of Cel6A may not directly involve a catalytic base. The value of (D2O)(V) of 1.16 +/- 0.14 for hydrolysis of cellotriose suggests that the large direct effect expected for proton transfer from the nucleophilic water through a water chain (Grotthus mechanism) is offset by an inverse effect arising from reversibly breaking the short, tight hydrogen bond between D221 and D175 before catalysis.
|
|
| 8. |
|
|
| 9. |
- Wohlfahrt, G., et al.
(author)
-
Probing pH-dependent functional elements in proteins : Modification of carboxylic acid pairs in Trichoderma reesei cellobiohydrolase Cel6A
- 2003
-
In: Biochemistry. - : American Chemical Society (ACS). - 0006-2960 .- 1520-4995. ; 42:34, s. 10095-10103
-
Journal article (peer-reviewed)abstract
- Two carboxylic acid side chains can, depending on their geometry and environment, share a proton in a hydrogen bond and form a carboxyl-carboxylate pair. In the Trichoderma reesei cellobiohydrolase Cel6A structure, five carboxyl-carboxylate pairs are observed. One of these pairs (D175-D221) is involved in catalysis, and three other pairs are found in, or close to the two surface loops covering the active site tunnel of the catalytic domain. To stabilize Cel6A at alkaline pH values, where deprotonation of the carboxylic acids leads to repulsion of their side chains, we designed two mutant enzymes. In the first mutant, one carboxyl-carboxylate pair (E107-E399) was replaced by a corresponding amide-carboxylate pair (Q107-E399), and in the second mutant, all three carboxyl-carboxylate pairs (E107-E399, D170-E184, and D366-D419) were mutated in a similar manner. The unfolding studies using both intrinsic tryptophan fluorescence and far-ultraviolet circular dichroism spectroscopy at different pH values demonstrate that the unfolding temperature (T-m) of both mutants has changed, resulting in destabilization of the mutant enzymes at acidic pH and stabilization at alkaline pH. The effect of stabilization seems additive, as a Cel6A triple mutant is the most stable enzyme variant. This increased stability is also reflected in the 2- or 4-fold increased half-life of the two mutants at alkaline pH, while the catalytic rate on cellotetraose (at t = 0) has not changed. Increased operational stability at alkaline pH was also observed on insoluble cellulosic substrates. Local conformational changes are suggested to take place in the active site loops of Cel6A wild-type enzyme at elevated pHs (pH 7), affecting to the end-product spectrum on insoluble cellulose. The triple mutant does not show such pH-dependent behavior. Overall, our results demonstrate that carboxyl-carboxylate pair engineering is a useful tool to alter pH-dependent protein behavior.
|
|
| 10. |
- Aspeborg, Henrik, et al.
(author)
-
Carbohydrate-active enzymes involved in the secondary cell wall biogenesis in hybrid aspen
- 2005
-
In: Plant Physiology. - : Oxford University Press (OUP). - 0032-0889 .- 1532-2548. ; 137:3, s. 983-997
-
Journal article (peer-reviewed)abstract
- Wood formation is a fundamental biological process with significant economic interest. While lignin biosynthesis is currently relatively well understood, the pathways leading to the synthesis of the key structural carbohydrates in wood fibers remain obscure. We have used a functional genomics approach to identify enzymes involved in carbohydrate biosynthesis and remodeling during xylem development in the hybrid aspen Populus tremula x tremuloides. Microarrays containing cDNA clones from different tissue-specific libraries were hybridized with probes obtained from narrow tissue sections prepared by cryosectioning of the developing xylem. Bioinformatic analyses using the sensitive tools developed for carbohydrate-active enzymes allowed the identification of 25 xylem-specific glycosyltransferases belonging to the Carbohydrate-Active EnZYme families GT2, GT8, GT14, GT31, GT43, GT47, and GT61 and nine glycosidases (or transglycosidases) belonging to the Carbohydrate-Active EnZYme families GH9, GH10, GH16, GH17, GH19, GH28, GH35, and GH51. While no genes encoding either polysaccharide lyases or carbohydrate esterases were found among the secondary wall-specific genes, one putative O-acetyltransferase was identified. These wood-specific enzyme genes constitute a valuable resource for future development of engineered fibers with improved performance in different applications.
|
|
