| 1. |
- Ali, A., et al.
(author)
-
Cobalt oxide magnetic nanoparticles-chitosan nanocomposite based electrochemical urea biosensor
- 2015
-
In: Indian Journal of Physics. - : Springer Verlag (Germany). - 0973-1458 .- 0974-9845. ; 89:4, s. 331-336
-
Journal article (peer-reviewed)abstract
- In this study, a potentiometric urea biosensor has been fabricated on glass filter paper through the immobilization of urease enzyme onto chitosan/cobalt oxide (CS/Co3O4) nanocomposite. A copper wire with diameter of 500 mu m is attached with nanoparticles to extract the voltage output signal. The shape and dimensions of Co3O4 magnetic nanoparticles are investigated by scanning electron microscopy and the average diameter is approximately 80-100 nm. Structural quality of Co3O4 nanoparticles is confirmed from X-ray powder diffraction measurements, while the Raman spectroscopy has been used to understand the chemical bonding between different atoms. The magnetic measurement has confirmed that Co3O4 nanoparticles show ferromagnetic behavior, which could be attributed to the uncompensated surface spins and/or finite size effects. The ferromagnetic order of Co3O4 nanoparticles is raised with increasing the decomposition temperature. A physical adsorption method is adopted to immobilize the surface of CS/Co3O4 nanocomposite. Potentiometric sensitivity curve has been measured over the concentration range between 1 x 10(-4) and 8 x 10(-2) M of urea electrolyte solution revealing that the fabricated biosensor holds good sensing ability with a linear slope curve of similar to 45 mV/decade. In addition, the presented biosensor shows good reusability, selectivity, reproducibility and resistance against interferers along with the stable output response of similar to 12 s.
|
|
| 2. |
- Ali, Akbar, et al.
(author)
-
Silver-chitosan nanobiocomposite as urea biosensor
- 2014
-
In: Optoelectronics and Advanced Materials Rapid Communications. - : NATL INST OPTOELECTRONICS. - 1842-6573 .- 2065-3824. ; 8:11-12, s. 1238-1242
-
Journal article (peer-reviewed)abstract
- Silver nanoparticles (Ag NPs) were synthesized by aqueous chemical growth technique. The above mentioned synthesized materials were characterized by applying scanning electron microscope (SEM) and X-ray diffraction for confirmation of morphological analysis, compositional purity, and crystalline property and emission characteristics as well. In order to fabricate the urea biosensor (potentiometric), a solution of deionized water and chitosan was prepared having Ag NPs. The said solution was dropped on the glass fiber filter having diameter of 2 cm. A wire of copper having thickness of approximately 500 pm was used for the voltage signal to pull out from the said working nanoparticles (NPs). To improve the strength, sensitivity and the quality of the potentiometric urea biosensor, a specific functional surface of Ag NPs was attained by electrostatic restrained of an enzyme (urease) onto the chitosan-Ag (a nanobiocomposite). The potentiometric reaction was measured via electrochemical detection technique. The potentiometric urea biosensor illustrates significant sensibility at room temperature with approximate to 42 mV as per span. Furthermore, the said biosensor showed an appropriate stable response within 7 sec.
|
|
