1. |
|
|
2. |
- Klionsky, Daniel J., et al.
(author)
-
Guidelines for the use and interpretation of assays for monitoring autophagy
- 2012
-
In: Autophagy. - : Informa UK Limited. - 1554-8635 .- 1554-8627. ; 8:4, s. 445-544
-
Research review (peer-reviewed)abstract
- In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
|
|
3. |
- Beal, Jacob, et al.
(author)
-
Robust estimation of bacterial cell count from optical density
- 2020
-
In: Communications Biology. - : Springer Science and Business Media LLC. - 2399-3642. ; 3:1
-
Journal article (peer-reviewed)abstract
- Optical density (OD) is widely used to estimate the density of cells in liquid culture, but cannot be compared between instruments without a standardized calibration protocol and is challenging to relate to actual cell count. We address this with an interlaboratory study comparing three simple, low-cost, and highly accessible OD calibration protocols across 244 laboratories, applied to eight strains of constitutive GFP-expressing E. coli. Based on our results, we recommend calibrating OD to estimated cell count using serial dilution of silica microspheres, which produces highly precise calibration (95.5% of residuals <1.2-fold), is easily assessed for quality control, also assesses instrument effective linear range, and can be combined with fluorescence calibration to obtain units of Molecules of Equivalent Fluorescein (MEFL) per cell, allowing direct comparison and data fusion with flow cytometry measurements: in our study, fluorescence per cell measurements showed only a 1.07-fold mean difference between plate reader and flow cytometry data.
|
|
4. |
-
- 2019
-
Journal article (peer-reviewed)
|
|
5. |
- Bentham, James, et al.
(author)
-
A century of trends in adult human height
- 2016
-
In: eLIFE. - 2050-084X. ; 5
-
Journal article (peer-reviewed)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.522.7) and 16.5 cm (13.319.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
6. |
- Bentham, James, et al.
(author)
-
A century of trends in adult human height
- 2016
-
In: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Journal article (peer-reviewed)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
7. |
- Chu, Ming, et al.
(author)
-
Accurate capacitance-voltage characterization of organic thin films with current injection*
- 2021
-
In: Chinese Physics B. - : IOP PUBLISHING LTD. - 1674-1056. ; 30:8
-
Journal article (peer-reviewed)abstract
- To deal with the invalidation of commonly employed series model and parallel model in capacitance-voltage (C-V) characterization of organic thin films when current injection is significant, a three-element equivalent circuit model is proposed. On this basis, the expression of real capacitance in consideration of current injection is theoretically derived by small-signal analysis method. The validity of the proposed equivalent circuit and theoretical expression are verified by a simulating circuit consisting of a capacitor, a diode, and a resistor. Moreover, the accurate C-V characteristic of an organic thin film device is obtained via theoretical correction of the experimental measuring result, and the real capacitance is 35.7% higher than the directly measured capacitance at 5-V bias in the parallel mode. This work strongly demonstrates the necessity to consider current injection in C-V measurement and provides a strategy for accurate C-V characterization experimentally.
|
|
8. |
- Danaei, Goodarz, et al.
(author)
-
Effects of diabetes definition on global surveillance of diabetes prevalence and diagnosis: a pooled analysis of 96 population-based studies with 331288 participants
- 2015
-
In: The Lancet Diabetes & Endocrinology. - 2213-8595 .- 2213-8587. ; 3:8, s. 624-637
-
Journal article (peer-reviewed)abstract
- Background Diabetes has been defined on the basis of different biomarkers, including fasting plasma glucose (FPG), 2-h plasma glucose in an oral glucose tolerance test (2hOGTT), and HbA(1c). We assessed the effect of different diagnostic definitions on both the population prevalence of diabetes and the classification of previously undiagnosed individuals as having diabetes versus not having diabetes in a pooled analysis of data from population-based health examination surveys in different regions. Methods We used data from 96 population-based health examination surveys that had measured at least two of the biomarkers used for defining diabetes. Diabetes was defined using HbA(1c) (HbA(1c) >= 6 . 5% or history of diabetes diagnosis or using insulin or oral hypoglycaemic drugs) compared with either FPG only or FPG-or-2hOGTT definitions (FPG >= 7 . 0 mmol/L or 2hOGTT >= 11 . 1 mmol/L or history of diabetes or using insulin or oral hypoglycaemic drugs). We calculated diabetes prevalence, taking into account complex survey design and survey sample weights. We compared the prevalences of diabetes using different definitions graphically and by regression analyses. We calculated sensitivity and specificity of diabetes diagnosis based on HbA1c compared with diagnosis based on glucose among previously undiagnosed individuals (ie, excluding those with history of diabetes or using insulin or oral hypoglycaemic drugs). We calculated sensitivity and specificity in each survey, and then pooled results using a random-effects model. We assessed the sources of heterogeneity of sensitivity by meta-regressions for study characteristics selected a priori. Findings Population prevalence of diabetes based on FPG- or-2hOGTT was correlated with prevalence based on FPG alone (r= 0 . 98), but was higher by 2-6 percentage points at different prevalence levels. Prevalence based on HbA(1c) was lower than prevalence based on FPG in 42 . 8% of age-sex-survey groups and higher in another 41 . 6%; in the other 15 . 6%, the two definitions provided similar prevalence estimates. The variation across studies in the relation between glucose-based and HbA(1c)-based prevalences was partly related to participants' age, followed by natural logarithm of per person gross domestic product, the year of survey, mean BMI, and whether the survey population was national, subnational, or from specific communities. Diabetes defined as HbA(1c) 6 . 5% or more had a pooled sensitivity of 52 . 8% (95% CI 51 . 3-54 . 3%) and a pooled specificity of 99 . 74% (99 . 71-99 . 78%) compared with FPG 7 . 0 mmol/L or more for diagnosing previously undiagnosed participants; sensitivity compared with diabetes defined based on FPG-or-2hOGTT was 30 . 5% (28 . 7-32 . 3%). None of the preselected study-level characteristics explained the heterogeneity in the sensitivity of HbA(1c) versus FPG. Interpretation Different biomarkers and definitions for diabetes can provide different estimates of population prevalence of diabetes, and differentially identify people without previous diagnosis as having diabetes. Using an HbA(1c)-based definition alone in health surveys will not identify a substantial proportion of previously undiagnosed people who would be considered as having diabetes using a glucose-based test.
|
|
9. |
|
|
10. |
- Fang, Shuhong, et al.
(author)
-
Environment occurrence of perfluoroalkyl acids and associated human health risks near a major fluorochemical manufacturing park in southwest of China
- 2020
-
In: Journal of Hazardous Materials. - : Elsevier BV. - 0304-3894 .- 1873-3336. ; 396
-
Journal article (peer-reviewed)abstract
- Despite China being the largest global manufacturer of perfluoroalkyl acids (PFAAs), few studies have been carried out on the environmental occurrence and associated human health risks of PFAAs emitted from manufacturing sites in China. Here, river water, tap water, soil and leaf samples were collected around a major fluorochemical manufacturing park (FMP) in the southwest of China in 2019. High EPFAA concentrations (sum of 12 PFAAs) of 3817 ng/L, 3254 ng/L, 322 - 476 ng/g dw and 23401-33749 ng/g dw were measured near the FMP in river water, tap water, soil and leaves, respectively, indicating that the FMP is a point source of PFAAs. PFOA was the predominant PFAA in all samples (58.5-98.6 %) indicating the production or use of PFOA at the FMP. PFOA concentrations in most tap water samples (> 300 ng/L in 31 of 38 samples) exceeded the U.S. EPA health advisory. Proportions of branched PFOA isomers in all samples were in 5.9-47.4 %, suggesting the production or use of PFOA manufactured by electrochemical fluorination at the FMP. It is recommended to focus more attention on branched PFOA isomers in the future because otherwise health risks may be underestimated due to their relatively high proportions in China.
|
|