1. |
- Strzelecki, G. W., et al.
(author)
-
Multi-component low and high entropy metallic coatings synthesized by pulsed magnetron sputtering
- 2022
-
In: Surface & Coatings Technology. - : ELSEVIER SCIENCE SA. - 0257-8972 .- 1879-3347. ; 446
-
Journal article (peer-reviewed)abstract
- This paper presents the findings of the synthesis of multicomponent (Al, W, Ni, Ti, Nb) alloy coatings from mosaic targets. For the study, a pulsed magnetron sputtering method was employed under different plasma generation conditions: modulation frequency (10 Hz and 1000 Hz), and power (600 W and 1000 W). The processes achieved two types of alloy coatings, high entropy and classical alloys. After the deposition processes, scanning electron microscopy, X-ray diffraction, and energy-dispersive X-ray spectroscopy techniques were employed to find the morphology, thickness, and chemical and phase compositions of the coatings. Nanohardness and its related parameters, namely H-3/E-r(2), H/E, and 1/(ErH)-H-2 ratios, were measured. An annealing treatment was performed to estimate the stability range for the selected coatings. The results indicated the formation of as-deposited coatings exhibiting an amorphous structure as a single-phase solid solution. The process parameters had an influence on the resulting morphology & mdash;a dense and homogenous as well as a columnar morphology, was obtained. The study compared the properties of high-entropy alloy (HEA) coatings and classical alloy coatings concerning their structure and chemical and phase composition. It was found that the change of frequency modulation and the post-annealing process contributed to the increase in the hardness of the material in the case of HEA coatings.
|
|
3. |
- Gruber, T, et al.
(author)
-
Geodetic SAR for Height System Unification and Sea Level Research - Observation Concept and Results in the Baltic Sea
- 2021
-
Conference paper (peer-reviewed)abstract
- Traditionally, sea level is observed at tide gauge stations, which usually also serve as height reference stations for national leveling networks and therefore define a height system of a country. Thus, sea level research across countries is closely linked to height system unification and needs to be regarded jointly. One of the main deficiencies to use tide gauge data for geodetic sea level research and height systems unification is that only a few stations are connected to permanent GNSS receivers next to the tide gauge in order to systematically observe vertical land motion. As a new observation technique, absolute positioning by SAR using active transponders on ground can fill this gap by systematically observing time series of geometric heights at tide gauge stations. By additionally knowing the tide gauge geoid heights in a global height reference frame, one can finally obtain absolute sea level heights at each tide gauge. With this information the impact of climate change on the sea level can be quantified in an absolute manner and height systems can be connected across the oceans. First results from applying this technique at selected tide gauges at the Baltic coasts are promising but also exhibit some problems related to the new technique. The paper presents the concept of using the new observation type in an integrated sea level observing system and provides results for a test network in the Baltic sea area by combining geometric and physical heights with tide gauge readings.
|
|