| 1. |
|
|
| 2. |
- Davani, Hooman A., et al.
(author)
-
Polarization investigation of a tunable high-speed short-wavelength bulk-micromachined MEMS-VCSEL
- 2012
-
In: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819489197 ; 8276, s. Art. no. 82760T-
-
Conference paper (peer-reviewed)abstract
- We report the investigation of the state of polarization (SOP) of a tunable vertical-cavity surface-emitting laser (VCSEL) operating near 850 nm with a mode-hop free single-mode tuning range of about 12 nm and an amplitude modulation bandwidth of about 5 GHz. In addition, the effect of a sub-wavelength grating on the device and its influence on the polarization stability and polarization switching has been investigated. The VCSEL with an integrated sub-wavelength grating shows a stable SOP with a polarization mode suppression ratio (PMSR) more than 35 dB during the tuning.
|
|
| 3. |
- Gierl, Christian, et al.
(author)
-
Tuneable VCSEL aiming for the application in interconnects and short haul systems
- 2011
-
In: Proceedings of SPIE - The International Society for Optical Engineering. - : SPIE. - 0277-786X .- 1996-756X. - 9780819484963 ; 7959
-
Conference paper (other academic/artistic)abstract
- Widely tunable vertical cavity surface emitting lasers (VCSEL) are of high interest for optical communications, gas spectroscopy and fiber-Bragg-grating measurements. In this paper we present tunable VCSEL operating at wavelength around 850 nm and 1550 nm with tuning ranges up to 20 nm and 76 nm respectively. The first versions of VCSEL operating at 1550 nm with 76 nm tuning range and an output power of 1.3mW were not designed for high speed modulation, but for applications where only stable continious tuning is essential (e.g. gas sensing). The next step was the design of non tunable VCSEL showing high speed modulation frequencies of 10 GHz with side mode supression ratios beyond 50 dB. The latest version of these devices show record output powers of 6.7mW at 20 °C and 3mW at 80 °C. The emphasis of our present and future work lies on the combination of both technologies. The tunable VCSEL operating in the 850 nm-region reaches a modulation bandwidth of 5.5GHz with an output power of 0.8mW.
|
|
| 4. |
- Grasse, P., et al.
(author)
-
GEOTRACES Intercalibration of the Stable Silicon Isotope Composition of Dissolved Silicic Acid in Seawater
- 2017
-
In: Journal of Analytical Atomic Spectrometry. - London. - 0267-9477. ; 32, s. 562-578
-
Journal article (peer-reviewed)abstract
- The first inter-calibration study of the stable silicon isotope composition of dissolved silicic acid in seawater, d30Si(OH)4, is presented as a contribution to the international GEOTRACES program. Eleven laboratories from seven countries analyzed two seawater samples from the North Pacific subtropical gyre (Station ALOHA) collected at 300 m and at 1000 m water depth. Sampling depths were chosen to obtain samples with a relatively low (9 mmol L-1, 300 m) and a relatively high (113 mmol L-1, 1000 m) silicic acid concentration as sample preparation differs for low- and high concentration samples. Data for the 1000 m water sample were not normally distributed so the median is used to represent the central tendency for the two samples. Median d30Si(OH)4 values of +1.66‰ for the low-concentration sample and +1.25‰ for the high-concentration sample were obtained. Agreement among laboratories is overall considered very good; however, small but statistically significant differences among the mean isotope values obtained by different laboratories were detected, likely reflecting inter-laboratory differences in chemical preparation including preconcentration and purification methods together with different volumes of seawater analyzed, andthe use of different mass spectrometers including the Neptune MC-ICP-MS (Thermo Fisher™, Germany), the Nu Plasma MC-ICP-MS (Nu Instruments™, Wrexham, UK), and the Finnigan™ (now Thermo Fisher™, Germany) MAT 252 IRMS. Future studies analyzing d30Si(OH)4 in seawater should also analyze and report values for these same two reference waters in order to facilitate comparison of data generated among and within laboratories over time.
|
|
| 5. |
- Laukert, G., et al.
(author)
-
Nutrient and Silicon Isotope Dynamics in the Laptev Sea and Implications for Nutrient Availability in the Transpolar Drift
- 2022
-
In: Global Biogeochemical Cycles. - 0886-6236. ; 36:9
-
Journal article (peer-reviewed)abstract
- Realistic prediction of the near-future response of Arctic Ocean primary productivity to ongoing warming and sea ice loss requires a mechanistic understanding of the processes controlling nutrient bioavailability. To evaluate continental nutrient inputs, biological utilization, and the influence of mixing and winter processes in the Laptev Sea, the major source region of the Transpolar Drift (TPD), we compare observed with preformed concentrations of dissolved inorganic nitrogen (DIN) and phosphorus (DIP), silicic acid (DSi), and silicon isotope compositions of DSi (δ30SiDSi) obtained for two summers (2013 and 2014) and one winter (2012). In summer, preformed nutrient concentrations persisted in the surface layer of the southeastern Laptev Sea, while diatom-dominated utilization caused intense northward drawdown and a pronounced shift in δ30SiDSi from +0.91 to +3.82‰. The modeled Si isotope fractionation suggests that DSi in the northern Laptev Sea originated from the Lena River and was supplied during the spring freshet, while riverine DSi in the southeastern Laptev Sea was continuously supplied during the summer. Primary productivity fueled by river-borne nutrients was enhanced by admixture of DIN- and DIP-rich Atlantic-sourced waters to the surface, either by convective mixing during the previous winter or by occasional storm-induced stratification breakdowns in late summer. Substantial enrichments of DSi (+240%) and DIP (+90%) beneath the Lena River plume were caused by sea ice-driven redistribution and remineralization. Predicted weaker stratification on the outer Laptev Shelf will enhance DSi utilization and removal through greater vertical DIN supply, which will limit DSi export and reduce diatom-dominated primary productivity in the TPD.
|
|
| 6. |
|
|
