1. |
- Abel, I, et al.
(author)
-
Overview of the JET results with the ITER-like wall
- 2013
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Journal article (peer-reviewed)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
2. |
- Adcox, K, et al.
(author)
-
PHENIX detector overview
- 2003
-
In: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - 0167-5087. ; 499:2-3, s. 469-479
-
Journal article (peer-reviewed)abstract
- The PHENIX detector is designed to perform a broad study of A-A, p-A, and p-p collisions to investigate nuclear matter under extreme conditions. A wide variety of probes, sensitive to all timescales, are used to study systematic variations with species and energy as well as to measure the spin structure of the nucleon. Designing for the needs of the heavy-ion and polarized-proton programs has produced a detector with unparalleled capabilities. PHENIX measures electron and muon pairs, photons, and hadrons with excellent energy and momentum resolution. The detector consists of a large number of subsystems that are discussed in other papers in this volume. The overall design parameters of the detector are presented. (C) 2002 Elsevier Science B.V. All rights reserved.
|
|
3. |
|
|
4. |
- Lissner, Lauren, 1956, et al.
(author)
-
Variability of body weight and health outcomes in the Framingham population
- 1991
-
In: New England Journal of Medicine. ; 324, s. 1839-1844
-
Journal article (peer-reviewed)abstract
- Department of Primary Health Care, Redbergsägen #6, Göteborg, Sweden. BACKGROUND. Fluctuation in body weight is a common phenomenon, due in part to the high prevalence of dieting. In this study we examined the associations between variability in body weight and health end points in subjects participating in the Framingham Heart Study, which involves follow-up examinations every two years after entry. METHODS. The degree of variability of body weight was expressed as the coefficient of variation of each subject's measured body-mass-index values at the first eight biennial examinations during the study and on their recalled weight at 25 years of age. Using the 32-year follow-up data, we analyzed total mortality, mortality from coronary heart disease, and morbidity due to coronary heart disease and cancer in relation to intraindividual variation in body weight, including only end points that occurred after the 10th biennial examination. We used age-adjusted proportional-hazards regression for the data analysis. RESULTS. Subjects with highly variable body weights had increased total mortality (P = 0.005 for men, P = 0.01 for women), mortality from coronary heart disease (P = 0.009 for men, P = 0.009 for women), and morbidity due to coronary heart disease (P = 0.0009 for men, P = 0.006 for women). Using a multivariate analysis that also controlled for obesity, trends in weight over time, and five indicators of cardiovascular risk, we found that the positive associations between fluctuations in body weight and end points related to mortality and coronary heart disease could not be attributed to these potential confounding factors. The relative risks of these end points in subjects whose weight varied substantially, as compared with those whose weight was relatively stable, ranged from 1.27 to 1.93. CONCLUSIONS. Fluctuations in body weight may have negative health consequences, independent of obesity and the trend of body weight over time. PMID: 2041550 [PubMed - indexed for MEDLINE]
|
|
5. |
- Romanelli, F, et al.
(author)
-
Overview of the JET results
- 2011
-
In: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Journal article (peer-reviewed)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|