1. |
- Bravo, L, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
2. |
- Tabiri, S, et al.
(author)
-
- 2021
-
swepub:Mat__t
|
|
3. |
- Lopes, T. S., et al.
(author)
-
Cu(In,Ga)Se2 based ultrathin solar cells the pathway from lab rigid to large scale flexible technology
- 2023
-
In: npj Flexible Electronics. - : Springer Nature. - 2397-4621. ; 7:1
-
Journal article (peer-reviewed)abstract
- The incorporation of interface passivation structures in ultrathin Cu(In,Ga)Se2 based solar cells is shown. The fabrication used an industry scalable lithography technique—nanoimprint lithography (NIL)—for a 15 × 15 cm2 dielectric layer patterning. Devices with a NIL nanopatterned dielectric layer are benchmarked against electron-beam lithography (EBL) patterning, using rigid substrates. The NIL patterned device shows similar performance to the EBL patterned device.The impact of the lithographic processes in the rigid solar cells’ performance were evaluated via X-ray Photoelectron Spectroscopy and through a Solar Cell Capacitance Simulator. The device on stainless-steel showed a slightly lower performance than the rigid approach, due to additional challenges of processing steel substrates, even though scanning transmission electron microscopy did not show clear evidence of impurity diffusion. Notwithstanding, time-resolved photoluminescence results strongly suggested elemental diffusion from the flexible substrate. Nevertheless, bending tests on the stainless-steel device demonstrated the mechanical stability of the CIGS-based device.
|
|
4. |
|
|
5. |
- Drummond, Miguel V., et al.
(author)
-
Tunable Optical Dispersion Compensator Based on Power Splitting Between Two Dispersive Media
- 2010
-
In: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 28:8, s. 1164-1175
-
Journal article (peer-reviewed)abstract
- In this paper, we propose and experimentally demonstrate a novel tunable optical dispersion compensator (TODC). Dispersion compensation is achieved by splitting the input signal between two dispersive media and adding the resulting signals thereafter. Tunable compensation is attained by controlling the power splitting ratio of the input signal between both dispersive media. The frequency response of the TODC is theoretically assessed considering signal addition in the optical and electrical domains. The latter case is enabled by using optical single side-band (OSSB) modulation, which allows preserving the phase information of dispersive media output signals after direct detection. This is the only case experimentally tested, since it avoids stability problems related with coherent addition of optical signals. A TODC with a tuning range of -340 to 0 ps/nm was designed and experimentally assessed for a 40 Gb/s nonreturn-to-zero OSSB signal. The tunable power splitter consisted of an automatic polarization controller and a polarization beam splitter, which offered a tuning time lower than 150 mu s. A bit error rate lower than 10(-8) was measured on the entire compensation range with a maximum power penalty of 3.3 dB relatively to an SSB signal in back-to-back.
|
|